The power plant furnace burns coal at the rate of 108,200 kg/hr. Air at 100.8 Kpa 28°C is supplied at the rate of 13.8 kg/kg coal. Determine the volume flow rate of air flow in m³/min. 21,327.64 m³/min O 19,414.62 m³/min O 20,435.26 m³/min 24,535.54 m³/min

Q: Problem 3 Consider a 700 mol/h feed entering a flash distillation unit or still under isothermal…

A: Given, The feed rate, F = 700 mol/h The mole fraction of benzene, z = 0.45 The operating pressure, P…

Q: Liquid isobutane at T=160 °F and pressure P=500 psia with a flow rate of m = 1000 lbmol/hr is sent…

A:

Q: A central power plant, rated at 800 000 kW, generates steam at 585 K and discards heat to a river at…

A: Given data: Power rating of a power plant = 800,000 kW Temperature of steam = 585 K Temperature of…

Q: the irreversible, liquid-phase, elementary reaction a + b -> 2c is carried out in a pfr under…

A: Given data: Composition of feed by mole % is as follows: A = 25 % B = 50 % Inerts = 25 % Conversion…

Q: Consider the environmental accident in Hungary involving waste (‘red mud’) from aluminum…

A: To 1. write reaction equations for the processes that describe processing of Bauxite in Bayer…

Q: It is desired to produce 7% NaNO3 solution continuously according to a process described in the…

A:

Q: 5. Calculate the total heat loss by radiation and convection from an unlagged horizontal steam pipe…

A: Given details: Diameter of the Pipe,D=50 mm=50×10-3 m=0.05m Temperature of the pipe surface,Ts=415 K…

Q: 2) A cylinder holds 200 kg of water at 120 °C at a pressure of 20 MPa. The temperature is increased…

A:

Q: Which cement is used to create bond .with old concrete surface Rapid Hardening Cement Expansive…

A: option 1 ) Rapid hardening cement is used in areas like road pavements so that the traffic can be…

Q: A stream of humid air enters a condenser in which 95% of the water sapor in the air is condensed.…

A: A stream of humid air is passed through a condensed in which 95 % of water is condensed.

Q: 1. Complete this table for H₂O: T, °C P, kPa 50 250 110 400 500 350 v, m³/kg 7.72 Phase description…

A:

Q: You were asked to determine the acid content of vinegar and soda samples. You performed a simple…

A:

Q: In a hydrogen fuel cell shown in Figure 2.1-2, hydrogen and oxygen gas pass through porous…

A:

Q: Describe the preparation of 250mL of 0.20M acetic acid buffer, pH=4 from 1M HAc (pK₂=4.76) and solid…

A:

Q: A double pipe heat exchanger consists of a 2" Sch 40 steel pipe inside a 3inch Sch 40 steel pipe, 10…

A: It is given that double pipe heat exchanger is used to condense steam in the annulus bu help of…

Q: Under constant pressure P = 18 bar an ideal gas of 1.5 mol undergoes expansion from 1.2L to 23.5L,…

A: Given data: P = 18 bar n = 1.5 mol V1 = 1.2 L V2 = 23.5 L

Q: Calculate the total AS when 1 mole of ice is heated from -23°C to 27°C. Take the Cp of water and ice

A:

Q: Saturated steam at 99.63°C condenses on the outside of a 5-m long, 4-cm-diameter thin horizontal…

A:

Q: Using the isothermal transformation diagram for an iron-carbon alloy of eutectoid composition…

A: 100% bainite is formed when the specimen is cooled rapidly to 350°C from 760°C and held for 10's and…

Q: Tanning beds use primarily UV-A radiation, the same dangerous UV radiation type strongly linked with…

A: Tanning salons use lamps that emit both UV-A and UV-B radiation and UVA penetrates deep into the…

Q: The specific gravity of white petrolatum is 0.850. Find the weight of this substance needed to fill…

A:

Q: An experimental drier is being used to reduce the moisture content of bagasse to be used for…

A: It is given that wet bagasse is having 50% moisture initially. Initial weight of bagasse = 5.75Kg…

Q: when we are taking our deltas why are we doing intial-final instead of final-initial

A: We need to explain why the difference in enthalpy (hi - hf) is denoted as ∆h in the energy…

Q: a) Please find out the statement of zeroth law of thermodynamics. b) Mammals (e.g., human beings)…

A: a) The zeroth law of thermodynamics states that if two bodies are each in thermal equilibrium with…

Q: Given that the vapor pressure of n-butane at 350 K is 9.4573 bar, find the molar volumes of (a)…

A: The critical properties of the compound are considered which are critical temperature, critical…

Q: 3-44 Water is boiled at a location where the atmospheric pressure is 79.5 kPa in a pan placed on an…

A: At  P = 79.5kpa TSat = 93.3oC  from steam table  hfg = 2273.9 kj/kg vf  = 0.001238 let diameter of…

Q: The specific gravity of white petrolatum is 0.850. Find the weight of this substance needed to fill…

A: Given, The specific gravity of white petrolatum, SG = 0.850 The volume of jar, V = 2 fluid ounce…

Q: single effect evaporato

A:

Q: Problem 1.14 The dynamic viscosity of an oil, used for lubrication between a shaft and sleeve is 6…

A: Introduction: A fluid's dynamic viscosity is the amount of force required to overcome internal…

Q: What is the primary source of SO2 pollutants?

A: To answer from the available options the primary source of SO2 pollutants

Q: and CH

A: please find answer attached below

Q: Please read the problem and answer the questions  The following questions are related to the final…

A: Note: We are authorized to answer three subparts at a time, since you have not mentioned which part…

Q: Example 6.1. A horizontal steel pipe having a diameter of 50 mm is maintained at a temperature of…

A: Given  Diameter of steel pipe = 50mm Temperature of pipe surface = 50oC Room wall Temperature  = 25…

Q: [Evaporation] It is desired to concentrate a 6% KNO3 solution in water to 20% KNO3 solution. 7000 kg…

A: Introduction- Evaporation is a unit activity that uses heat transfer through boiling or vaporisation…

Q: 3. An evaporator is used to concentrate cane sugar solutions. A feed of 10000 kg/day of a solution…

A:

Q: 4. A refractory material with an emissivity of 0.40 at 1500 K and 0.43 at 1420 K is at temperature…

A:

Q: The outlet gases to a combustion process exits at 465°C and 0.93 atm. It consists of 2.42% H₂O(g),…

A: Given, The temperature of the outlet gases,  T = 465°C = 465+273 K = 738 K The pressure of the…

Q: A company that produces footballs uses a proprietary mixture of ideal gases to inflate their…

A:

Q: 6. Determine the temperature of water at a state of P = 400 kPa and h = 3300 kJ/kg.

A:

Q: Recovery of a desired a desired solute from solution can sometimes be accomplished by using a second…

A: Given: The amount of feed added to the solvent extractor is F = 1 kg containing xbf = 0.7 or 70%…

Q: [Crystallization] One tonne of a 30 % solution of soda ash, Na₂CO3 in water is cooled slowly to…

A:

Q: 4. A rigid tank has a volume of 0.01 m³. It initially contains saturated water at a temperature of…

A:

Q: Three different liquids are used in the manometer shown here. P₁ P2 PA T h₁ +++++ -PB Pc (a) Derive…

A:

Q: s the volumetric flow

A:

Q: The difference in energy between staggered and eclipsed conformations of ethane is known as which of…

A: About 3 kcal/mol (12 kJ/mol) more energy per mole exists in the eclipsed conformation than in the…

Q: Q2: You have an Aluminium cube with 2.00 inches side length. For the cube, calculate the following:…

A: please find answer attached below

Q: A sample of nitrogen at 23°C is allowed to expand reversibly and adiabatically from 400 cm³ to 3600…

A:

Q: A process starts with a 24.55 kg reactant mixture and ultimately produces 10.71 kg of product, 6.49…

A:

Q: draw something resembling Figure 4.4 is (attached), and indicate the following  the bubble point for…

A:

Q: 1. A compressed-air vessel has a volume of 10 ft³. Cooling coils hold its temperature constant a…

A: