suts Displayed AlAnswers, Submitted Ansvwers, Cortect AnswersQuestion 1The maximum gauge pressure in a hydraulic lit is 17 atm. What is the largestsize vehicle (kg) it can lift if the diameter of the output line is 28 cm1.0atm =1.013x10 Po Write the value with 2-decimal digits and SI unit,

Name: suts Displayed AlAnswers, Submitted Ansvwers, Cortect AnswersQuestion
Uploaded: 2024-03-20T06:51:10.000Z
Channel: Bartleby
Description: suts Displayed AlAnswers, Submitted Ansvwers, Cortect AnswersQuestion 1The maximum gauge pressure in a hydraulic lit is 17 atm. What is the largestsize vehicle (kg) it can lift if the diameter of the output line is 28 cm1.0atm =1.013x10 Po Write the

Answered: Image /qna-images/answer/118825ea-5cfd-4401-bb9c-fb13345f648b.jpg

Science

Physics

The maximum gauge pressure in a hydraulic lift is 17 atm. What is the largest size vehicle (kg) it can lift if the drameter of the output line is 28 cm ? 1.0atm =1.013x 10 Pa Write the value with 2-decimal digits and SI unit.

The maximum gauge pressure in a hydraulic lift is 17 atm. What is the largest size vehicle (kg) it can lift if the drameter of the output line is 28 cm ? 1.0atm =1.013x 10 Pa Write the value with 2-decimal digits and SI unit.

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter14: Fluid Mechanics

Section: Chapter Questions

Problem 115AP: A sump pump (used to drain water from be basement of houses built below the water table) is draining...

See similar textbooks

Similar questions

Calculate Reynolds numbers for flow of trough (a) a nozzle a radius of 0.250 cm and (b) a garden hose with a radius of 0.900 cm, when be nozzle is attached to hose. The flow rate through hose and nozzle is 0.500 L/s. Can flow in either possibly be laminar?
Verigy that the SI of hpg is N/m2.
The flow of blood through a 2.00106 m -radius capillary is 3.80109cm3/s . (a) What is the speed of be blood now? (b) Assuming all the blood in the body passes through capillaries, how many of them must there be to carry a total flow of 90.0 cm3/s?
A sump pump (used to drain water from be basement of houses built below the water table) is draining a flooded basement at rate of 0.750 L/S, with an output pressure of 3.00105N/m2 . (a) The water enters a hose with a 3.00-cm inside diameter and rises 2.50 m above the pump. What is its pressure at this point? (b) The hose goes over the foundation wall, losing 0.500 m in height and widens to 4.00 cm in diameter. What is the pressure now? You may neglect frictional losses both parts of the problem.
A 75.0-kg floats in freshwater 3.00% of his volume above water when his are empty, and 5.00% of his volume above water when his lungs are full. Calculate the volume of air inhales—called his lung capacity—in liters. (b) Does lung volume seem reasonable?
A container of water has a cross-sectional area of A=0.1m2 . A piston sits top of the water (see be following figure). There is a spout located 0.15 m from the bottom of tank, open to the atmosphere, and a stream of water exits the spout. The cross sectional area of the spat is As=7.0104m2 . (a) What is the velocity of the water as it leaves the spout? (b) If the opening of the spout is located 1.5 m above the grand, how far from be pout does water hit the floor? Ignore friction and dissipative forces.
How would you determine the density of an irregularly shaped rock?
Every few years, winds in Boulder, Colorado, attain sustained speeds of 43.0 m/s (about 100 mph) when jet steam descends during early spring. Approximately what is the force due to the Bernoulli equation on a roof having an area of 220m2? Typical air density in Boulder is 1.14kg/m3, and be corresponding atmospheric pressure is 8.89104 N/m2. (Bernoulli’s principal as stated in the text assumes laminar flow. Using the principle here produces only an approximate result, because there is significant turbulence.)
A trash compactor can compress its contents to 0.350 times their original volume. Neglecting mass of air expelled, by what factor is the density of be rubbish increased?
Suppose you have a coffee with a circular cross-section and vertical sides (uniform radius). What is its inside radius if it holds 375 g of coffee filled to a depth of 7.50 cm? Assume coffee has the same density as water.
Fluid originally flows through a tube at a rate of 100 cm3/s. To illustrate the sensitivity of flow rate to various factors, calculate be new flow rate for following changes with all other factors remaining the same as in original conditions. (a) Pressure difference increases by a factor of 1.50. (b) A new fluid wit 3.00 times greater viscosity is substituted. (c) The tube is replaced by one having 4.00 times the length. (d) Another tube used with a 0.100 times the original. (e) Yet another tube is substituted with a radius 0.100 times the original and half length, and pressure difference is increased by factor of 1.50.
In an immersion measurement of a woman's density, she is found to have a mass of 62.0 kg in air an apparent mass of 0.0850 kg completely submerged with lungs empty. (a) What of water does she displace? (b) What is her volume? (c) Calculate her density. (d) If her lung capacity is 1.7S L, is she able to that without treading water with her lungs filled air?