The hole concentration in silicon is 2.25x10 cm. Assume T = 300K, n=1.5x10 cm³, kT=0.026eV. Is the semiconductor n type or p type and why? Determine n, and po Determine EF-Ev

Q: An RC High-pass filter consists of 5 nF capacitor and a 50 K 2 resistor. The output voltage is taken…

A: Given: An RC high-pass filter consists of  Capacitor, C=5 nF Resistor, R=50 kΩ

Q: For a transfer function G(s): = s(s+20)(s+85) in negative feedback, and the gain K to yield a 15%…

A: The Given Transfer function is Gs=Kss+20s+85 in negative feedback, To find the gain K to yield a 15%…

Q: Question 4 a) A iii. B Figure 4 Figure 4 shows the graph of the ripple current. Answer the following…

A: Full wave Bridge Rectifier Circuit :

Q: An LED is required to turn on when a switch is closed. The necessary illumination is obtained when…

A: The circuit is as shown below, Given, LED forward drop, Vd=1.2V, LED current, ID=20mA. Current…

Q: , R₁ 59. For the circuit shown below, ε = 50 V, and L= 2.0 mH. Find the values of 1₁ and 12 (a)…

A:

Q: 5G base station used for wireless communications operates at 30 GHz. We will consider the down-link…

A:

Q: In K-mapping, a four adjacent square in a three-variable map will give ______ literals. A) 3 B) 4 1…

A: here we are asked to choose the correct option.Given  in a k-mapping , a four adjacent square in a…

Q: A semiconductor is formed by......... bonds. 1. Covalent 2. Electrovalent 3. Co-ordinate 4. None of…

A: The correct option along with the explanation is provided in the following section.

Q: Obtain the waveform of output states Q and Q for the D latch when the input condition as in Figure 2…

A: The latch is a device that stores a bit of data in it. It is a level-triggered device and it changes…

Q: Given the signal below with a height of 12 V and a pulse width T/2. Find the first three…

A: The periodic or non periodic signal is represented in sinusoidal form by Fourier series. The Fourier…

Q: If Vin = 10 mV p-p what is the output voltage from the circuit shown below? Vin C₁ 0.1 μF Re 1100 ΜΩ…

A: Given: Vin=10mV p-p

Q: What is the typical value of refractive index for an ethyl alcohol?

A: The correct option along with the explanation is provided in the following section.

Q: Question 1 1 0 1 1 0 1 0 1 ... Đ 1 1 D CLK PS FF CLR Q Figure 1 Sketch the timing diagram based on…

A:

Q: i) A communication system employs a continuous source. The channel noise is white and Gaussian. The…

A: Given that Bandwidth, W= 10 MHz Signal to noise power ratio, S/N=100 We have to find channel…

Q: For the given circuit, find voltage V using Superposition theorem. ४८ X 15VL6 122 reell 1022 52052 t…

A:

Q: Q1: From the circuit shown below:- Vrms=19.8V f₁ =125Hz For the given circuit, a) State the name of…

A: Rectifier: It is a electronic circuit which is used to convert Ac signal to pulsating dc signal.

Q: Question 1 A circuit shown in Figure Q1 is supplied with an a.c. source, V1, with an instantaneous…

A: Given data, Voltage equation v1t=314cos314.16t-900 Circuit diagram is given as,

Q: B(jo) Determine gain margin and phase margin of the system shown above if the loop gain magnitude…

A: Given:  0

Q: Find the inverse Fourier Transform of X(jω) = 1 / (4+ jω)^2 using convolution property.

A:

Q: Q4:- Find the Thévenin equivalent circuit for the network external to the resistor R. for the…

A: Given that Resistance RL=5 Ω, 10 Ω, 100 Ω The circuit is shown below.

Q: The techniques used for sampling are a. Instantaneous sampling b. Natural sampling c. Flat top…

A:

Q: DAC

A:

Q: Q3:-Using superposition, determine the current through the (62) resistor for network of Fig.2 1= 0.3…

A: The superposition theorem is the sum of response of individual sources acting alone is same as…

Q: a) A single-phase induction motor, 14 hp, 180 V, 50 Hz, 3% slip has the following equivalent circuit…

A: Given parameters: Motor ratings, Rated power, P - 1/4 hp = 186.42 watt Vs = 180 V Frequency, f = 50…

Q: .) Consider a channel with a 3 MHz capacity and an SNR of 255. What is the upper limit to the data…

A: It is given that: Channel Bnadwidth=B=3 MHz=3×106 HzSignal to Noise Ratio=SNR=255

Q: Determine the total input resistance of the emitter-follower. Also find the voltage gain, current…

A: The given circuit diagram is shown below:

Q: Find the total resistance in the figure shown below 10 ¡¯‚¯……… www www Your answer 10 the 50 Q…

A:

Q: Find V, and the power absorbed by the dependent source in the given circuit. Assume / = 21 A. 1092…

A: Given circuit:

Q: A generator operating at 50 Hz delivers 1 pu power to an infinite busbar through a network with…

A: Given that  Pmax1 = 2.0p.u,         Pmax2 = 0.4p.u,         Pmax3 = 1.5p.u,         Pm = 1.0p.u…

Q: The technician is troubleshooting the following circuit and finds that there is an electrical…

A: In the given electrical circuit, the following things can be observed: The circuit consists of a…

Q: Find the current it in the figure shown below. Given Vs = 40 V Us Μ + 6Ω * ΣΩ I iz 8 Ω

A: Given circuit: Supply, Vs=40 V

Q: 1. Using Thevenin's theorem and Norton's theorem, find the current I, in the given circuit. 10Ω ww…

A: The given circuit diagram is shown below:

Q: In the given circuit, what is the value of the collector current (IC) if the BJT is made of Silicons…

A: Given circuit, BJT is made of silicon.

Q: An electric motor with a mass of 42 kg, rated speed of 3760 rpm and unbalance of 0.002 kg.m must be…

A: Given:-  Mass (m)= 42kg Speed (N)=3760rmp Unbalance =0.002 kg.m Force transmissibility =0.141…

Q: Load 1: A Y-connected 40 kVAR motor at 0.8 lagging power factor. Load 2: A A-connected 100kW…

A:

Q: A 10A current is lagging the voltage by 47° and a 12A current is lagging the voltage by 58°. What is…

A: Given:  10 A current lagging the voltage by 470 and 12 A current lagging the voltage by 580. We have…

Q: In a DC machine, rectification process is carried out in order to get unidirectional output (DC).…

A: The correct option along with the explanation is provided in the following  section.

Q: Show that as shown the text is Kirchhoff’s loop rule as applied to the circuit as shown.

A:

Q: Exe: The single-phase bridge rectifier has an RL Load and an ac source, with R = 10Ω and L = 10mH.…

A:

Q: A 1500 Hz B 3 kHz 1.5 kHz D) 6 kHz An audio signal represented by 60 sin 3000zt Volts modulates a…

A:

Q: 2. A loop contains three resistors and a battery, whose voltages are 3V, -4V, and 5V, respectively.…

A:

Q: given figure, ca ulate ssuming в о ur answer A Bo R1 2002 d the current flowing through R3 assuming…

A:

Q: (a) Illustrate the Thevenin equivalent circuit of Figure 1 (b) Sketch the Norton equivalent circuit…

A:

Q: ID= IMQ VDS= VG +90 VDD Given the figure above with the following values: VDD=21, RD=3.30k, IDSS =…

A:

Q: Describe the shape of the curve. How is the magnetic field welated to the current thwough the…

A: The values of the slope and y-intercept provide details on the relationship between the two…

Q: A) Explain how PLL works. B) How does a varactor work in a frequency modulator? C) What is the…

A: As you have not mentioned what question has to be done, only first three questions wills pe be…

Q: Using Norton's theorem find the current the indicated. resistor Q passing via the network shown…

A:

Q: b) If the consumer is desire to active the load instrument with varying input supply, at least…

A: Given Problem: To provide a design methodology to smoothen out the DC output for the digital wall…

Q: Question 1: As Fig.1, U₁= − 3 V, U₂ = 10 V, U₁ = 4 V, Us = − 2 V, R₁ = 2 . Calculate the voltage on…

A: Given: Circuit:

Q: I need all steps answer    A 3-phase overhead transmission line delivers a load of 80 MW at 0.8 pf…

A:

Types of Charge Carriers

A carrier is a type of object which carries a particular thing from one point to another point. For instance, people use different vehicles from one place to another, and the vehicle carries those people and acts as a carrier.