The flow past a two-dimensional Half-Rankıne Body results from the superposition of a horizontal uniform flow of magnitude U=3 m/s towards the right and a source strength q = 10 m²/s located at the origin (0, 0). The fluid density is 1000 kg/m³. All dimensional quantities are given in SI units. Neglect the effects of gravity. The x-coordinate of the stagnation point is x = m. The total width of the body is__ 2 _ m. The magnitude of the pressure difference between the points (-1, 0) and (0, 2) is _ 3 КРа. Enter the correct answer below. Please enter a number for this text box. 2 Please enter a number for this text box. 3 Please enter a number for this text box.

The flow past a two-dimensional Half-Rankıne Body results from the superposition of a horizontal uniform flow of magnitude U=3 m/s towards the right and a source strength q = 10 m²/s located at the origin (0, 0). The fluid density is 1000 kg/m³. All dimensional quantities are given in SI units. Neglect the effects of gravity. The x-coordinate of the stagnation point is x = m. The total width of the body is__ 2 _ m. The magnitude of the pressure difference between the points (-1, 0) and (0, 2) is _ 3 КРа. Enter the correct answer below. Please enter a number for this text box. 2 Please enter a number for this text box. 3 Please enter a number for this text box.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

3. A circular cylinder of radius a is fitted with two pressure sensors to measure pressure at 0 = 180° and at 150°. The intent is to use this cylinder as a stream velocimeter, i.e. a device to determine the velocity of a stream by measuring the pressures at the two taps. The fluid is incompressible with a density of p. Figure for Part (a) U Figure for Part (b) 30 a) Using potential flow approximation, derive a formula for calculating U from the measured pressure difference at the two pressure taps. Note that for accurate measurement, the velocimeter must be aligned to have one of the taps exactly facing the stream as shown in the figure. (Ans: 2|Aptaps|/p ) b) Suppose the velocimeter has been misaligned by ổ degrees so that the two pressure taps are now at 180° + 8 and 150° + 8. Derive an expression for the percent error in stream velocity measurement. Then, calculate the error for 8 = 5°,10° and –10°. (Ans: [2/(sin2(150 + 8) – sin²(180 + 8) )– 1] × 100 )
Flow through a converging nozzle can be approximated by a one-dimensional velocity distribution u=vo (1+2). For the nozzle shown below, assume that the velocity varies linearly from u = vo at the entrance to u = 3v, at the exit. Compute the acceleration at the entrance and exit if vo=10m/s and L = 1m. x=0 X u= :326 x=L
9- V(D1)^2=V1(D2)^2 mass 10 points continuity equation O true O False 10-stream line is a line giving 10 points direction of velocity at any point. O True O False
Q.2 A flow is described by the stream function v = 25xv, The coordinates of the point at which velocity vector has a magnitude of 4 units and makes an angle 150 ° with the X-axis is A x=1.0, y=0.5774 B X=0.5774, Y=1.0 WRONG C X=1, Y=-0.5774 D X=-1, Y=0.5774
P1 A thin layer of water flows down a plate inclined to the horizontal with an angle a = 15° in the shown coordinate system. If the thickness of the water layer is a=0.5 mm, assuming that the flow is laminar and incompressible, (water density p = 1000 kg/m³viscosity µ = 0.001 Pa.s and acceleration of gravity g = 9.81 m/s²) and an air flow shears the layer in a direction opposite to its flow with a shear stress of 1 N /m². Solve the Navier-Stokes equation: air water (a) to find the value of the maximum water velocity in m/s to three decimal points, Answer: (b)and to find the value of water velocity at the layer's surface in m/s to three decimal points, Answer:
The open tank in Fig. contains water at 20 ° C and isbeing filled through section 1. Assume incompressibleflow. First derive an analytic expression for the water-levelchange dh / dt in terms of arbitrary volume flows ( Q 1 , Q 2 ,Q 3 ) and tank diameter d . Then, if the water level h is constant,determine the exit velocity V 2 for the given data V 1 =3 m/s and Q 3 = 0.01 m 3 /s.
The figure below shows 4 streamlines corresponding to a free vortex flow. The streamlines are concentric eircles, and the velocity magnitude Valong each streamline is given by V = K/r, where r is the radial distance from the center, and K is a constant. Assume the flow to be steady, incompressible and inviscid. Neglect the effects of gravity. If K = 20 m2/s and the fluid density is 1000 kg/m, what is the magnitude of the static pressure difference AP between 2 streamlines at radial distances r = 3 m and r = 4 m? Ap = 1 КРа. C r В
4- Two free vortices of equal strength, but opposite direction of rotation, are superimposed with a uniform flow as shown in Fig. 4 1. The stream functions for these two vorticies are y = -[±T(2#)] In r. (a) Develop an equation for the x-component of velocity, u, at point P(x.y) in terms of Cartesian coordinates x and y. (b) Compute the x-component of velocity at point A and show that it depends on the ratio I/H. Sketch and describe the flow then determine the stagnation points. •Plx, y) Figure (4)
1- Reynolds number is a dimensionless number represent .....to .. 2- The velocity profile of the flow between two parallel plates is linear if the pressure gradient equal and parabolic if the pressure gradient has a .... 3- In the sink and source flow the potential function is represented as.. ...... and the stream function is represented as **** 4- In the laminar boundary layer, the .............. is the dominant reason for the loss while in turbulent boundary layer the is dominant. 5- For inviscid flow, there are no shear stresses the only forces acting on a fluid element are ....... and. *****
Consider steady flow of water through an axisymmetric garden hose nozzle. The axial component of velocity increases linearly from uz, entrance to uz, exit as sketched. Between z = 0 and z = L, the axial velocity component is given by uz = uz,entrance + [(uz,exit − uz,entrance)/L]z. Generate an expression for the radial velocity component ur between z = 0 and z = L. You may ignore frictional effects on the walls.
ASAP
Consider steady, incompressible, laminar flow of a Newtonian fluid in an infinitely long round pipe of diameter D or radius R = D/2 inclined at angle a. There is no applied pressure gradient (@P/x = 0). Instead, the fluid flows down the pipe due to gravity alone. We adopt the coordinate system shown, with x down the axis of the pipe. Derive an expression for the x- component of velocity u as a function of radius r and the other parameters of the problem. Calculate the volume flow rate and average axial velocity through the pipe. 10₂ α Pipe wall Fluid: p. p R