The circuit is now modified to remove the 5 V power supply and instead provide feedback from the output (see Fig. A2d for the modified circuit). For this comparator circuit utilising positive feedback (commonly known as Schmitt trigger), describe and draw the output waveform. Please describe and draw the comparator output (Vo) by clearly labelling axes, threshold voltages and the saturation voltages in your sketch. Also show supporting calculations of the upper threshold point (UTP or V,"), lower threshold point (LTP or Vi) and the hysteresis voltage.

The circuit is now modified to remove the 5 V power supply and instead provide feedback from the output (see Fig. A2d for the modified circuit). For this comparator circuit utilising positive feedback (commonly known as Schmitt trigger), describe and draw the output waveform. Please describe and draw the comparator output (Vo) by clearly labelling axes, threshold voltages and the saturation voltages in your sketch. Also show supporting calculations of the upper threshold point (UTP or V,"), lower threshold point (LTP or Vi) and the hysteresis voltage.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

For the given four statements below, which of the following are not correct about an op-amp with negative feedback arrangement? i. Negative feedback reduces the gain of the op-amp circuit to desired value. ii. Negative feedback takes portion of the output and applies it back in-phase with the input. iii. Negative feedback controls the voltage transfer characteristic of the op-amp circuit. iv. Negative feedback maintains the oscillations. i and ii O i and iv iii and iv O i and iii
Can you please help with the following question. Find the output voltage Vo in terms of Vs. What type of opamp configuration is this?
Given the four statements below, which of the following statements are true about op- amp with negative feedback arrangement? i. Negative feedback drive the op-amp to saturation with Vo =+Vsat. 1i. Negative feedback reduces the gain of the op-amp circuit to desired valuc. iii. Negative feedback controls the frequency response of the op-amp cireuit. iv. Negative feedback maintains the oscillations. O, ii, i Oi, ii, iv
If the ideal design for op-Amp circuit generate 200 mV at the output, Then practically with 26 mV offset voltage the output voltage of the circuit will be equal to .. . mV
The op amp in the circuit of Figure is ideal.a) What op amp circuit configuration is this?b) Find ?0 in terms of ??.c) Find the range of values for ?? such that ?0 does not saturate and the op ampremains in its linear region of operation.
2. b) (i) Derive an expression for the differentiator using op-amp. (ii) Design a circuit to perform differentiation of an input signal that varies in frequency from 20HZ to about 2 KHz. (iii) If a sine wave of 0.5 V peak at 2 KHz is applied to the differentiator of part (ii), draw the output waveform.
Which op-amp network is commonly used to reduce the effect of noise on comparator circuits (Schmitt trigger arrangement)?Using an output networkUsing a negative feedback networkUsing an input networkUsing a positive feedback network
(a) Identify the correct answers 1. Virtual ground of an OP-AMP (a) Is formed only with negative feedback (b) Is always an AC ground, may occasionally be a DC ground (for PMOS) (c) Is coined as a terminology where the input signal splits equally between the terminals (d) Leads to the concept of almost zero difference between the two inputs (both DC and AC) using feedback 2. In an OP-AMP based circuit (a) Phase margin of the closed loop transfer function is a measure of stable operation (b) 45° is a desirable phase margin as it balances the frequency domain stability and the time domain settling optimally (c) Absolute open loop gain numbers are not that important, as long as they are large (d) 45° is only achieved when the RHP zero is placed on one of the poles 3. In a differential amplifier biased with a given tail current I, to increase the overdrive voltage by 2X without changing input capacitive loading, we should (a) Increase W by 2X and reduce L by 2X (b) Reduce W by 2X and…
Q2/B)- Show the connection of three combination op-amp stages ( Parallel and series connection) using an LM348 IC to provide outputs that are 110, 400, and 2601 times larger than the input. Use a feedback resistor of Rf = 500 k? in all stages, while can use only (R= 50 k? for first stage), (R= 25 k? for second stage), and (R= 10 k? for third stage
QI. A siniscidal voltage waveform with 5 V pk-pk and period of 10 as is applied to the input of the op-amp shown in the figure. The open loop gain is 200000 and the supply voltage is +12 . Draw the input and output waveforms showing the time relationship. Vee
For the given op-amp circuit, determine: (a) iout/iin2, (b) iin2/iin, (c) iin/Is, and (d) iout/Is.
For an op-amp having a slew rate SR=5V/ms, what is the maximum closed-loop voltage gain that can be used when the input signal varies by 0.2V in 10ms?