Solute: Nickel (I) chloride O Solid O Solution NICI, 1 L Concentration (molL) 0.300 ½L Evaporation Remove Solute none What will change if more solid NiCl2 is added? O Molarity will decrease O The amount of NiCl, will increase O More than one of these O The amount of NiCl, will decrease O Molarity will increase Solute: Nickel (II) chloride O Solid O Solution 1 L Concentration (molL) 0.300 Evaporation Remove Solute What will change if liquid 5.0 Molar NiCl2 is added? O Molarity will decrease O The amount of NiCl, will decrease O Molarity will increase O More than one of these O The amount of NiCl, will increase

Solute: Nickel (I) chloride O Solid O Solution NICI, 1 L Concentration (molL) 0.300 ½L Evaporation Remove Solute none What will change if more solid NiCl2 is added? O Molarity will decrease O The amount of NiCl, will increase O More than one of these O The amount of NiCl, will decrease O Molarity will increase Solute: Nickel (II) chloride O Solid O Solution 1 L Concentration (molL) 0.300 Evaporation Remove Solute What will change if liquid 5.0 Molar NiCl2 is added? O Molarity will decrease O The amount of NiCl, will decrease O Molarity will increase O More than one of these O The amount of NiCl, will increase

EBK A SMALL SCALE APPROACH TO ORGANIC L

4th Edition

ISBN:9781305446021

Author:Lampman

Publisher:Lampman

Chapter79: Solubility

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

The box below represents one liter of a saturated solution of the species , where squares represent the cation and circles represent the anion. Water molecules, though present, are not shown. Complete the next three figures below by filling one-liter boxes to the right of the arrow, showing the state of the ions after water is added to form saturated solutions. The species represented to the left of the arrow is the solid form of the ions represented above. Do not show the water molecules.
The freezing point of a 0.11 m solution of HNO2 is -0.20C. (a) What is i for the solution? (b) Is the solution made (i) of HNO2 molecules only? (ii) of H+ and NO2- only? (iii) of more HNO2 molecules than H+ ions? (iv) primarily of H+ and NO2- ions with some HNO2 molecules?
Supersaturated solutions of most solids in water are prepared by cooling saturated solutions. Supersaturated solutions of most gases in water are prepared by heating saturated solutions. Explain the reasons for the difference in the two procedures.
Potassium hydrogen phthalate is a solid, monoprotic acid frequently used in the laboratory as a primary standard. It has the formula KHC8H4O4. This is often written in the short-hand notation as KHP. If 25.0mL of a potassium hydroxide solution are needed to neutralize 2.26g of KHP, what is the molarity of the potassium hydroxide solution? Potassium hydrogen phthalate sometimes called potassium biphthalate, as shown on this bottle is an acid that is convenient to store and use because it is a solid.
The freezing point of 0.10 M KHSO3 is -0.38C. Which of the following equations best represents what happens when KHSO3 dissolves in water? (a) KHSO3(s)KHSO3(aq) (b) KHSO3(s) K+(aq)+HSO3(aq) (c) KHSO3(s) K+(aq)+SO32(aq)+ H+(aq)
An aqueous solution of LiX is prepared by dissolving 3.58 g of the electrolyte in 283 mL of H2O(d=1.00g/mL). The solution freezes at -1.81C. What is X-? (Assume complete dissociation of LiX to Li+ and X-.
A 0.010 M solution of the weak acid HA has an osmotic pressure (see chapter on solutions and colloids) of 0.293 atm at 25 C. A 0.010 M solution of the weak acid HB has an osmotic pressure of 0.345 atm under the same conditions. (a) Which acid has the larger equilibrium constant for ionization HA[HA(aq)A(aq)+H+(aq)] or HB[HB(aq)H+(aq)+B(aq)]? (b) What are the equilibrium constants for the ionization of these acids? (Hint: Remember that each solution contains three dissolved species: the weak acid (HA or HB). the conjugate base (A- or B- and the hydrogen ion (H+). Remember that osmotic pressure (like all colligative properties) is related to the total number of solute particles. Specifically for osmotic pressure, those concentrations are described by molarities.)
Public Health Service standards for drinking water set a maximum of 250 mg/L (2.620103M) of SO42- because of its cathartic action (it is a laxative). Does natural water [hat is saturated with CaSO4 (gyp" water) as a result or passing through soil containing gypsum, CaSO42H2O, meet these standards? What is the concentration of SO42- in such water?