Situation 01. A crate at rest having a weight of 1.60KN was dragged with a constant force of 0.75KN at an angle of 3V:4H only on the first 6m of its motion. If the coefficient of kinetic friction between the crate and the horizontal surface is 0.20; a. Compute the velocity of the crate if the distance it traveled was 9m. b. What is the total distance that the crate traveled until it stops?

Situation 01. A crate at rest having a weight of 1.60KN was dragged with a constant force of 0.75KN at an angle of 3V:4H only on the first 6m of its motion. If the coefficient of kinetic friction between the crate and the horizontal surface is 0.20; a. Compute the velocity of the crate if the distance it traveled was 9m. b. What is the total distance that the crate traveled until it stops?

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Problem #4 (. A 16-lb bowling ball is cast horizontally onto a lane such that its initial angular rate wo = 0 and its center of mass has a velocity vo = 8 ft/s. The radius of the ball is r = 0.375 ft, and the coefficient of kinetic friction between the lane and ball is Hk = 0.12. 8 ft/s G What is the condition, in terms of w and v for а. 0.375 ft rolling without slipping? b. ) Draw a clear and complete free body diagram of just the ball. с. What is the angular acceleration of the ball? Use IG = l5 mr for a solid sphere. What is the linear acceleration of the ball? е. For how much time does the ball slide before it begins to roll without slip? f. For what distance does the ball slide before it begins to roll without slip? g. What is the velocity of the ball at the moment it beings to roll without slip? d.
A 50.0 kg crate is being pulled by a rope as shown. The height and the width of the block are 0.450 m and 0.750 m, respectively. The coefficient of nonsliding and sliding friction between the floor and the ramp is 0.300 and 0.250, respectively. 5. If the magnitude of the pulling force P is 300 N, which of the following will happen to the crate at that instant? It will remain at rest. It will tip over but will not slide. 50 It will tip over and slide at the same time. It will slide but will not tip over.
Block A of 500-kg mass is subjected to a towing force F= 2000t2 +3000t (Newtons) where "t" is in seconds. If the initial velocity of the block is 6 m/s, determine the velocity after 4 seconds. The block is being towed at a surface inclined at 45° and the coefficient of kinetic friction between these is 0.2. " O 106.74 m/s O 215.73 m/s O 240.21 m/s O 106.04 m/s O 108.96 m/s O 115.64 m/s O 108.24 m/s O 241.18 m/s
A 400 N block slides on a horizontal plane by applying a horizontal force of 200 N and reaches a velocity of 10 m/s in a distance of 30 m from rest. Which of the following gives the coefficient of friction between the floor and the block? A. 0.24 B. 0.27 C. 0.33 D. 0.39 E. none of the above Which of the following gives the total distance that the block will move until it stops if the 200 N force is removed when it reaches 30 m from west. A. 45.43 m B. 47.88 m C. 49.17 m D. 51.64 m E. none of the above Which of the following gives time the block moves a distance of 30 m from rest. A. 4s B. 5s C. 6s D. 7s E. none of the above
Question 2: A 40 lb suitcase slides down a 20ft ramp with an initial velocity of va= 10 ft/sec. The coefficient of kinetic friction on the ramp is equal to 0.2. Determine the point where it strikes the ground at C and how long it takes to go from A to C. A/ 20 ft 30 B 4 ft C -R-
A car is being towed up on an incline with an angle of 15° with the horizontal. Find the force (parallel to the incline) needed to pull the car with an acceleration of 1.2 . The car weighs 20 kN. Neglect friction.
The 3-kg rod OA is initially hanging in a vertical position when a 0.6-kg block B, sliding on a horizontal surface with negligible friction with a velocity of VBO-3.2 m/s, strikes the rod at its end A. 0 VBO B 1. If the block's velocity after impact is VBI =0.16 m/s to the left what is the coefficient of restitution, e, between block B and bar OA? 2. What is the impulse exerted by rod OA on block B? 0.3 m 0.9 m
The 80-kg crate is subjected to the forces shown. If it is originally at rest, determine the distance it slides in order to attain a speed of v = 7 m/s. The coefficient of kinetic friction between the crate and the surface is uk %3D = 0.27. Forces with respect to 45° and 30° are 613 N and 368 N, respectively. %3D |30° 45°
PROBLEM 2: PRINCIPLE OF WORK AND ENERGY The crate, which has a mass of 100 kg, is subjected to the action of two forces. If it is originally at rest, determine the distance it slides in order to attain a speed of 6 m/s. The coefficient of kinetic friction between the crate and the surface is 0.2. 1000 N 800 N 3 30°{ 4
The crate in an inclined plane (angle of inclination, 02=10°), has a mass M=200 kg and is subjected to a towing force P acting at an angle e1=20° with the horizontal. If the coefficient of static friction is 0.2, determine the magnitude of P to just start the crate moving down the plane. (A) N=1909 N, P=47 N (B) N=1687 N, P=39 N N=1658 N, P=37 N N=1780 N, P=52 N
The fork lift has a weight of 2400 lb and a center of gravity at G (Figure 1). Figure 2.5 ft 1.25 ft -3.50 ft-
The small 0.6-kg block slides with a small amount of friction on the circular path of radius 3 m in the vertical plane. If the speed of the block is 5 m/s as it passes point A and 4 m/s as it passes point B, determine the normal force exerted on the block by the surface at each of these two locations.