Answered: Separating t-butyl chloride from the…

Separating t-butyl chloride from the reaction mixture. What is the purpose of washing with the following? . a. With cold water b. With sodium bicarbonate solution

EBK A SMALL SCALE APPROACH TO ORGANIC L

4th Edition

ISBN:9781305446021

Author:Lampman

Publisher:Lampman

Chapter33: Triphenylmethanol And Benzoic Acid

Section: Chapter Questions

Problem 2Q

See similar textbooks

Related questions

Q: During separation of t-butyl chloride from the reaction mixture, what is the purpose of washing with…

A: To obtain the pure product from the reaction mixture, the whole process involved is known as Work-Up…

Q: Why does benozic acid dissolve in toulene but not hexane?

A: Benzoic acid dissolve in toluene, but it does not dissolve in hexane.

Q: Why is it necessary to remove the stopp the stopcock? The pka of p-nitrophenol and 2,5-dinitro- any,…

A: Solvent extraction is done using a separatory funnel. In the process, the analyte that is dissolved…

Q: Why is it necessary to store the prepared lysates in a very low temperature?

A: necessasity to store the prepared lysates in a very low temperature.

Q: Aqueous sodium bicarbonate was used to wash the crude n-butyl bromide.a. What was the purpose of…

A: Crude n-butyl bromide is washed by sodium bicarbonate in the final step of synthesis.

Q: 1. What is the purpose of adding Na2SO4 to the dichloromethane layer prior to distillation 2.…

A: In liquid-liquid extraction, separation of compounds takes place on the basis of their relative…

Q: How can we check that there is no more vanillin left in the organic layer after it has been…

A: Vanilin is an organic compound. It can extracted from the lignin waste and then can be separated…

Q: Why is it necessary to acidify the mixture obtained after reaction of Grignard reagent with both the…

A: Grignard reaction is an organometallic chemical reaction alkyl, aryl, vinyl or aryl magnesium…

Q: How can the Eugenol content be separated from the alkaline solution?

A: Eugenol also known as clove oil. This oil is extracted from cloves and is used to treat toothache,…

Q: Why is it necessary to keep all materials dry in Grignard reactions?

A: The Grignard reactions are used for the alcohol synthesis, which involves the addition of…

Q: 7. Why did you allow the reaction to settle before you took some of the solvent for spotting?

A: If the reaction is not complete, then components of the reaction mixture might include some…

Q: In the Iodination of Acetone, Why were the reagents equilibrated in water bath before mixing?

A: In iodination reactions iodine are introduced into a molecule. The iodination reaction of acetone…

Q: Why Does The Flask Need To Be In An Ice Bath And The Sulfuric Acid Added Dropwise? Synthesis Of…

A: Sulphuric acid is a strong acid which react voilently with water and it is completely soluble in…

Q: What is the chemical composition of the nitrating mixture? Why does the incoming nitro group go para…

Q: We used to perform this experiment using diethylether or THF as the reaction solvent. We now use…

A: Introduction: Solvents are mainly two kinds i.e. polar and nonpolar. The polarity of the solvent is…

Q: Explain how these Grignard reagents would react with molecules of their own kind to “self-destruct.”

A: Given reagent,

Q: Why is excess ammonia used in the preceding reaction?

A: The preceding reaction is as given below:

Q: reaction

A: KOH reflux is the second step where hydrolysis of the ester is takes place. The product of this step…

Q: Why is it necessary to exclude moisture in the Grignard reaction? Be specific. What happens to the…

A: Alkyl halides in presence of Mg metal and dry ether form alkyl magnesium halides (RMgX) which are…

Q: What is the purpose of grinding the cloves before the steam distillation? The isolation of eugenol…

A: the purpose of grinding the cloves before the steam distillation is to get more extract from…

Q: Why should the purified compound at the well (Buchner funnel) not be washed with a larger amount of…

A: Crystallization is the process by which is a solid form, where the atoms or molecules are highly…

Q: Identify The resulting color of the solution upon the addition of dilute sodium hydroxide in…

A: In phthalein dye test when limited sodium hydroxide reacts with phenolphthalein the colour is pink.…

Q: why it is not a good idea to use dichloromethane as a solvent in Grignard reactions.

A: Reason for not using dichloromethane as a solvent in Grignard reactions.

Q: Write the reaction involved in Ferrox Test. a. What is the species responsible?…

Q: what will happen to the reaction of acetone in the sodium nitroprusside Test and in the iodoform…

A: The sodium nitroprusside test is used to detect ketone bodies or acetone bodies in urine. The urine…

Q: why do you have to stir when adding sodium nitrite to a solution when forming a diazonium salt?

Q: Why must the alkyl halide product be dried carefully with anhydrous sodium sulfate before the…

A: Given:- Nucleophilic substitution reaction: The reaction of electron pair…

Q: Briefly explain why OtBu- sometimes favored over hydroxide as an elimination reagent?

Q: During separation of t-butyl chloride from the reaction mixture, what is the purpose of washing with…

A: In the preparation of t-butyl chloride from t-butyl alcohol using HCl a carbocation intermidiate is…

Q: Why does the eugenol move from the water layer to the dichloromethane layer during extraction?

A: In separation process, aqueous and organic layer gets separated.

Q: Both acetyl chloride and acetic anhydride are good acetylating agents. Which is more preferred and

A: Acetic anhydride is very safe to use it is non corrosive. It is also cheap as compared to the acid…

Q: extraction

A: Dear student,this question is related to the organic chemistry.

Q: During the reaction of 1-bromobutane with sodium ethoxide, a white precipitate form. This…

A: The reaction of 1-bromobutane with sodium ethoxide is as follows.

Q: In shake and bake reactions, why might it be beneficial if one of the precursors is volatile?

A: Introduction: Shake and bake is a method to produce methamphetamine drug. As the name suggest, it is…

Q: Briefly explain why diethyl ether is the solvent of choice for Grignard reactions.

A: Grignard reagents are the reagents which have the formula RMgX. Hence the grignard reagent is an…

Q: Complete these reactions involving lithium diorganocopper (Gilman) reagents

Q: What is the purpose of the filter paper moistened with ammoniacal silver nitrate solution in the…

A: The purpose of the filter paper soaked with ammoniacal silver nitrate solution in the Acrolein test…

Q: Why is eugenol steam-distilled rather than purified by simple distillation?

A: Eugenol, also called clove oil, is an aromatic oil extracted from cloves that is used widely as a…

Q: Complete the reaction involving lithium diorganocopper (Gilman) reagents

A: A new C-C bond is formed between atoms when an alkyl halide is treated with Gilman reagent or…

Q: steps in purification of the mixture of benzoic acid and benzaldehyde

A: The mixture is reacted with Na2CO3 in which carboxylic acid reacts and forms a very soluble (in…

Q: Why is benzene diazonium chloride not stored and is used immediately after its preparation?

Q: Show how to bring about each conversion using a lithium diorganocopper reagent.

A: Using lithium di organocopper reagent, synthesize the above product.

Q: In addition to the normal dangers in using concentrated hydrochloric acid, what additional dangers…

A: Mixing of ice with HCl can be explosive and release dangerous fumes.

Q: Write the reaction involved in Ferrox Test. a. What is the species responsible?…

A: Ferrox test solution is hexane, alcohol, ether, which are generally used for prepared ferrox paper…

Q: Why is benzyl chloride reactive in both tests, whereas bromobenzene is unreactive?

A: The basis for the testing of sodium iodide and silver nitrate is to obtain a qualitative comparison…

Q: What is the use of acetylide formation??

A: Acetylide anion is an anion formed by the removing the proton from the end carbon of the terminal…

Q: Come up with a description of what you would do experimentally to recrystallize any two of the…

A: Organic compounds made by using different synthesis techniques may contain impurities. Purification…

Question

Separating t-butyl chloride from the reaction mixture. What is the purpose of washing with the following? .

a. With cold water

b. With sodium bicarbonate solution

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sample Preparation in Analytical Chemistry

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

How was the precipitate obtained after filtration? a. By drying the precipitate on the filter paper using a desiccator. b. By charring the filter paper and igniting the product in a crucible. c. By redissolving in hydrochloric acid
2. Please explain what is A and B in the separating funnel when using NaOH to extract Dichloromethane solution and why? A B
Aqueous sodium bicarbonate was used to wash the crude n-butyl bromide.a. What was the purpose of this wash? Give equations.b. Why would it be undesirable to wash the crude halide with aqueous sodium hydroxide?
1. What type of reaction explains solubility of phenol in sodium hydroxide? Explain the organic product formed. 2. How do the reactions of phenol samples with FeCl3 compare? Which structural component of the phenols account for the observation
4. Sublimation can be employed as a purification technique for substances that have Short answer text 5. Having known that phthalic anhydride readily sublimes, what two separation techniques will allow the separation of the the components in a mixture containing phthalic anhydride, benzoic acid and sodium chloride?
Aqueous sodium bicarbonate was used to wash the crude t-pentyl chloride.a. What was the purpose of this wash? Give equations.b. Why would it be undesirable to wash the crude halide with aqueous sodium hydroxide?
A compound X has the following properties: (i) Gives an orange precipitate with 2,4-dinitrophenylhydrazine. (ii) Forms a brick-red precipitate when heated with Fehling's solution. Compound X is Select one: O A. pentanal B. pentanone C. pentanol D. pentanoic acid
1. What method of tonicity adjustment will be used in the preparation? a. Sprowl's Method b. Cryoscopic Method c. NaCl Equivalent Method d. White-Vincent Method 2. How many grams of sodium chloride must be added to the Pilocarpine solution to make it isotonic?
1. Which of the following can most likely increase the yield of recrystallized benzoic acid? a. A fluted filter paper was used during cold filtration. b. The receiving flask from hot filtration does not contain a small amount of solvent. c. Activated charcoal was not added to the solution. d. The solution was filtered immediately after hot filtration.
Purification of benzoic acid 1. What is the purpose of washing the crystal in the filter paper with water? 2. How recrystallization affects the theoretical yield of sample? Explain.
What is the role of Glycerin in the assay of Boric Acid?I. The reagent prevents the formation of pink color earlier than the expected endpoint.II. The reagent allows the reaction of protons from the acid sample with the hydroxyl ions from the titrant.III. It enhances the water solubility of the difficultly soluble boric acid. a. I, II & III b. II & III c. I & II d. I only e. I & III
Describe why the inside wall of the flask is rinsed with deionized water during accurate titration. Does this washing affect the molar quantity of acetic acid in the sample? Describe..?