Refrigerant 134-a is compressed in a two stage compressor. It enters the first stage of the compressor as saturated vapor at -10 degrees C and leaves 900kPa and 60 degrees C. It then enters the second stage compressor as saturated vaport at 900kPa and leaves at 1.4 MPa and 80 degrees C. The mass flow rate of the refrigerant through both stages is 3 kg/s. If the total heat loss from the compressor per unit mass of the refrigerant is 20kJ/kg if the refrigerant, what is the total power input to the compressor?

Q: the temperature for one stage of compression; and e) the heat transferred in the intercooler. Note:…

A: This question is based on the concept of thermodynamics.

Q: Steam enters an adiabatic turbine at 1 MPa and 300°C and leaves at 100 kPa as saturated steam. The…

A:

Q: Problem 4 - Change in entropy system and surroundings The coils of the evaporator of a refrigeration…

A:

Q: Professor Modyn operates an adiabatic turbine where steam enters at 5.0 MPa and 500 ∘C. The steam…

A: To find: The isentropic efficiency. Given: The inlet pressure of the steam is P1=5 MPa. The inlet…

Q: A compressor operating with 7.7 kg/s water vapour with a compression ratio (P2/P1) equal to 3.0 is…

A:

Q: Water as a saturated liquid at 7.5 kPa and 40.29 deg C enters a pump and leaves the pump as a…

A: Given : water enters as saturated liquid p=7.5 Kpa And leaves the pump as subcooled liquid…

Q: NOTE: This is a multi-part question. Once an answer is submitted, you will be unable to return to…

A: The initial volume is The initial pressure is .The initial temperature is .The final pressure is…

Q: 17. A piston-cylinder device with a set of stops initially contains 0.3 kg of steam at 1.0 MPa and…

A: Given:m=0.3 KgP1=1.0 MPav1=0.30661 m3/Kgv2=0.6*v1h2=2950 KJ/Kg

Q: An adiabatic pump is to be used to compress saturated liquid water at 10 kPa to a pressure to 15 MPa…

A:

Q: 1. Steam flows steadily into a turbine with a mass flow rate of 20 kg/s at 6 MPa and 600°C with a…

A:

Q: Refrigerant 134-a enters the coil of the condenser of a residential heat pump at 500kPa and 400C and…

A: The superheated refrigerant enters the compressor and leave as a saturated liquid. Therefore,…

Q: Refrigerant 134-a enters a compressor as saturated vapor at -20°C and leaves at 1.2 MPa and 80°C.…

A:

Q: The power output is 12122 kW

A:

Q: Determine (a) the entropy change of the refrigerant, (b) the entropy change of the cooled space

A:

Q: A refrigeration system has a compressor that runs on R134a. The refrigerant enters the compressor as…

A: Givenreferigerent R134aAt inletsaturated vapourP1=0.14MPaAt outletSuperheated…

Q: At 3MPa and 400C, 2 kg/s steam flows into a turbine. It exits at 300kPa. The turbine has an…

A: Given: P1 = 3 MPa = 3000 kPa P2 = 300 kPa T1 = 400 C efficiency = 85% Ideal case means isentropic…

Q: The operation of turbine is to harvest energy from the high temperature steam. Consider a scenario…

A:

Q: At 3MPa and 400C, 2 kg/s steam flows into a turbine. It exits at 300kPa. The turbine has an…

A:

Q: a turbine at 1100 kpa , dry and saturated . The steam is exhausted from the turbine at 200 kpa and…

A:

Q: Q3: Steam enters an adiabatic turbine at 8 MPa, 550°C, and 15 m/s and leaves at 60 kPa, 150°C, and…

A: At state 1 P1=8MPa T1=550°C C1=13 m/s Using the superheated steam table h1=3521KJ/Kg S1=6.8778…

Q: A gas turbine unit is used to produce electric power through a generator. The air inlet to the…

A: Calculate the power input to the compressor and the total power produced by the turbine and also…

Q: 2) A Refrigerant 134a at 1 MPa and 12 °C is mixed with another stream at 1 MPa and 60 °C. If the…

A:

Q: A schematic of a steam power plant is shown in the figure. The boiler volume is 50 liter and…

A:

Q: vii) Steam expands in an adiabatic turbine from 6 MPa and 400°C to 0.05 MPa at a rate of 4 kg/s. If…

A:

Q: NOTE: This is a multi-part question. Once an answer is submitted, you will be unable to return to…

A:

Q: Refrigerant 134-a enters the evaporator coils placed at the back of the freezer section of a…

A: ◆ The mass flow rate of the refrigerant is 0.016326 kg/sec. ◆ The rate of heat rejected to the…

Q: R-134a enters the adiabatic compressor as saturated steam at 160kPa pressure and is compressed to…

A: The required saturated vapour properties of R134a at 160 kPa are: The mass flow rate of the…

Q: Refrigerant-134a enters an adiabatic compressor at -26°C as a saturated vapor at a rate of 0.45…

A:

Q: 3.9 m3/s of saturated water vapor enters a compressor at 250 kPa and leaves it with a pressure equal…

A: Refrigeration is a device used to produce cooling by dissipating heat in the form of fluid or…

Q: An adiabatic steam turbine receives steam from two boilers. One flow has a mass flow rate (m) of 4.7…

A:

Q: Water vapor enters a reversible-adiabatic (isentropic) turbine with 4 MPa pressure, 500C…

A:

Q: I. Steam flows steadily into a turbine with a mass flow rate of 20 kg/s at 6 MPa and 600°C with a…

A: Mass flow rate = 20 kg/s P1 = 6 Mpa T1 = 600 C  P2 = 0.5 Mpa  T2 = 200 C

Q: (b) A refrigeration plant uses a flash chamber to separate saturated vapor and saturated liquid from…

A:

Q: Liquid water enters a pump at 100 kPa and 30°C at a rate of 1.35 kg/s and leaves at 4 MPa. If the…

A:

Q: The power required to compress 0.01 kg/s of steam from a saturated vapor state at 50°C to a pressure…

A:

Q: Professor Modyn operates an adiabatic turbine where steam enters at 5.0 MPa and 450 °C. The steam…

A:

Q: Saturated liquid water at 90 psia is expanded adiabatically through a valve to 5 psia. Assuming that…

A: Given Data State 1: saturated liquid, 90 psia State 2: 5 psia Adiabatic process (Q=0) No work…