Q3. SAE 30 oil (Sp. Gr. =0.833) with a dynamic viscosity 0.28 N.S/m flows in a 4-cm-diameter pipe which is inclined with an angle 37°, For the pressure measurement shown, determine Whether the flow is up or down A. The flow rate in m/h The shear stress and velocity 1 cm from the boundary. Draw the shear stress and velocity profile with the section of the pipe. В. C. D.

Q: Oil of viscosity 10E-3 Pa-s and specific gravity 0.90, flows through 60 m of 100mm diameter pipe and…

A:

Q: Medium oil with kinematic viscosity 6.10 x 10^-6 m^2/s, flows through a straight pipe at a rate of…

A: Given Data: Flow rate. Q=6.0 L/s

Q: For which flowrates through the Venturi meter shown in the figure below will cavitation occur it P1…

A:

Q: Oil with a viscosity of 0.10 Pa-s and s+ 0.85, flows through 3,000 m of 30 cm cast-iron pipe at a…

A:

Q: Find the head lost due to friction in a pipe of diameter 5 mand length 5000 cm, through which a…

A: d=5 m L= 5000 cm ρg=9000 Nm3v=3000 cmsecμ=400 poise or μ=40 N-sm2…

Q: Q.3 b) A total of 14 litres per second of oil is pumped through two pipes in parallel, one 12 cm in…

A: Given :- Q =14Litls        L= 1200m               Q = 0.014 m3 IS               d1 = 12 cm =0.12m…

Q: Two very large open tanks A and F (Fig. ) containthe same liquid. A horizontal pipe BCD, having a…

A: Consider the given diagram: Apply Bernoulli theorem between top of tank A and point D:…

Q: Water flows upward in a vertical 300-mm pipe at the rate of 0.222 m /s. At point A in the pipe, the…

A:

Q: Q5/ Oil flows in a 0.3 (m) diameter pipe with a flow velocity of 2.7 (m/s). The physical properties…

A: As per given question we have determine  1- The value of Reynold's Number Re and Mention the Type of…

Q: A 500-mm diameter welded steel pipe (e = 0.046 mm) conveys 20°C crude oil (density = 856 kg/m and…

A:

Q: N/m². The flow is steady, incompressible, and fully develc

A:

Q: Q2: The pipe flow in Fig. 2 is driven by pressurized air in the tank. What gage pressure pl is…

A:

Q: (Q4) Water flows from a large tank through a large pipe that splits in to two smaller pipes as show…

A: Apply Bernoulli's equation at points (2) and (0). P2ρg+V222g+z2=P0ρg+V022g+z0 Here, the density of…

Q: If an ideal fluid is used in an experiment to prove the Bernoulli equation, will there be…

A:

Q: Oil with a kinematic viscosity of 6 x 104 m2/s, flows in a horizontal circular straight pipe with…

A:

Q: Water flows in a constant diameter pipe with the following conditions measured: At section (a) p. at…

A: Disclaimer Since the 1st question is incomplete, we will solve the second question for you as the…

Q: Considering pipe loss only, what difference in elevation between two tanks 800 ft apart will deliver…

A: Given Data Length of pipe is : L=800 ft Flow rate is : Q=1.10 ft3/s Temperature of fluid is :…

Q: YM Q5 Assuming ideal flow, determine the total pull on the bolts in Fig. P6.10, where y = 6 ft, d, =…

A: As per Bartleby rule we can answer one if two separate questions are posted so please post the next…

Q: C3. An oil of specific gravity 0.88 is flowing through a horizontal venturimeter fitted to a 272 mm…

A:

Q: Points A and B on a 15 cm diameter new steel pipe with f= 0.020 are separated by a distance of 1000…

A:

Q: Q1: In a venturemeter used for measuring the flow of oil (S = 0.85) through a horizontal pipeline,…

A: Given data: Write the equation of continuity for the system.

Q: A pumping system is installed at a location where the reading of barometer is Pa=90kPa and the vapor…

A: Given: The atmospheric pressure, Pa = 90 kPa The vapour pressure, Pv = 3.5 kpa The cavitation number…

Q: Brine (SG = 1.1, viscosity = 1.1cP) is pumped at a rate of 45 ft^3/min (ID = %3D 2.5in) from large…

A: Given: Specific gravity of the brine→S=1.1 Hence density of the brine→ρ=1.1×62.4=68.64 lb/ft3…

Q: 3. In the figure, ideal fluid (water) flow from the infinity large basin through the atmosphere.…

A:

Q: strsight pipe at a rate of 6.0 liters/s. For laminar flow comditions, what is the least

A:

Q: Q8: The velocity principle of a given fluid flowing over a flat plate is given by = 2y - y² , where…

A: Given:u=2y-y2μ=0.006 Lbfs/ft2μ=0.006122Lbfs/in2 =4.167*10-5 Lbfs/in2Shear stress in fluid flow is…

Q: 4: Water flow through a pipe at 5L/s as shown in figure. If gage pressure of 12.5kPa, 11.5kPa and…

A: The head loss can be calculated using the Bernoulli's equation which is given below as-…

Q: d. A pipe line, 300 mm in diameter and 3200 m long is used to pump up 50 kg per second of oil whose…

A:

Q: A fluid is being pumped through a pipe. The density of fluid is 872 kg/m³. The viscosity is 2.8x10²…

A: Given data: The density of the fluid is = 872 kg/m3 The viscosity of the fluid is = 2.8 x 10-2…

Q: C3. An oil of specific gravity 0.9 is flowing through a horizontal venturimeter fitted to a 278 mm…

A: We are suppose to solve only 3 subparts. Please post other parts as a separate question.

Q: A ventury meter used to measure the liquid from the reservoir. The cross-sectional area at the inlet…

A: Given:A1=4.536*10-3 m2A2=1.134*103 m2Q=9167 cm3/sx=266 mms=13.6

Q: 1. What relationship does the Bernoulli's Theorem Apparatus show between th kinetic and potential…

A: “Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: At a certain flow range, for a system with certain geometric characteristics, in a pipe whose…

A: Pressure drop (delta P ) = fL/D×V2/2g

Q: A balloon is being filled with water at an instant when the diameter is 50 cm. If the flow rate into…

A:

Q: .53 Water flows steadily from the large open tank shown in Fig. P3.53. If viscous effects are…

A: The above question is based on the application of Bernauli's Equation

Q: Nitrogen gas under a pressure pn = 15 psig is used for pumping kerosene at 25°C (density = 816…

A: Given: Gauge Pressure exerted by the nitrogen→P1=15 psig=103.42 KPa Density of the kerosene→ρ=816…

Q: A 6.0 cm diameter horizontal pipe gradually narrows to 4.5 cm. When water flows through this pipe at…

A: we can solve this question by using :- 1)continuity equation  2) Bernoulli  equation

Q: Q2/ A hydraulic hose carrying oil with a kinematic viscosity of 50 cSt at a volume flow rate 1300…

A: Given that, kinematic viscosity of oil, ν=50 cstv=50 cst=0.000001×50 m2/sec,v=0.00005 m2/sec,Volume…

Q: A venturi meter, shown in Fig. designed constriction whose pressure difference is a mea- sure of the…

A: Apply energy equation between points 1 and 2 P1ρg+V122g+Z1=P2ρg+V222g+Z2 By rearranging the terms…

Q: Would the volumetric flow rate in a pipe, assuming laminar flow, be more or less if the fluid were…

A:

Q: Oil of specific gravity 0.70 and dynamic viscosity of 0.05Pa-s flows at a rate of 100lit/sec through…

A:

Q: 4: Water flow through a pipe at 5L/s as shown in figure. If gage pressure of 12.5kPa, 11.5kPa and…

A:

Q: Q2- Water density =1000 kg/m³ and viscosity is 0.001 N s / m², is pumped between two reservoirs at…

A:

Q: Water flows from a pressurized tank (at 150 kPa gauge) to an open tank 15m above. What is the…

A: Given,  Water flow from pressurized tank Pressure (P) = 150 kPa= 150000 Pa Density (d) = 1000…

Q: C3. An oil of specific gravity 0.9 is flowing through a horizontal venturimeter fitted to a 278 mm…

A:

Q: Sunflower oil (SG = 0.7, viscosity = 154cP) is pumped at a rate of 85 ft^3/min (ID = 3.5in) from…

A: Specific gravity of Sunflower oil, SG=0.7Viscosity of the Sunflower oil, μ=154 cp…

Properties of Fluids

The term fluid represents a type of substance that can easily change its shape under any external pressure/force and can flow. Fluids can acquire any shape in which it is stored and can resist normal stresses but cannot resist shear stress in rest condition. Whenever external shear stress is applied to fluids, it starts to flow. The fluids may be liquid or gas. Example- water, air, etc.