Q3- Using the voltage divider rule, find the indicated voltages in Figure 3 www 1.5 Ω 0.72 V + 4. www 2.50 050 + V ww 000 0,6 Ω

Q: Q2: Find i (t) and ₂ (t) in the circuit of Figure Q2. using mesh 1H 106³ (E)V = 2H1 Figure Q2 2H

A:

Q: Develop a truth table for the Boolean expression F = x ′ y ′ z .

A: We need to find out truth table for given Boolean function

Q: Q4/:- For VCO-LO circuit block, if the message signal is the sine wave as shown in the figure below…

A: Frequency of message signal is: fm=1t=110-3=1KHz Message signal can be written as:…

Q: Simplify the following Boolean expressions to a minimum number of literals: xy + x ( wz + wz ′ )

A:

Q: |--E Q3) In a long-shunt compund generator, the terminal voltage is 230 V, when it delivers 150 A.…

A:

Q: Find the Fourier transform x(t) for the following figure -T T

A: Fourier transform:- It is generalization of complex fourier series. It is a tool to break the…

Q: Q5: Determine the COP of a refrigerator which removes heat from the food at a rate of 6000000 J/h…

A: It is given that: QL=6000000 J/h=6000 KJ/hWin=1200 W=1.2 KW

Q: 10A a 192 EMM + 40 ww Vx T 492 ww + 21 692 ww Determine the value for the voltage V using the…

A:

Q: B) Determine the internal optical power of the double hetetostructure LED has 85% quantum efficiency…

A:

Q: 5. Explain the hazards of using batteries. 6. Write the 4 conventional kinds of primary batteries.…

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: Determine 1₁ and 1₂ using current division. 50 A (1) 2012 ↓I, 155 12 1052

A:

Q: For the given circuit, if the RMS Thevenin's voltage is VTh=2020° V and ZTh=5+j4 0, then the maximum…

A: Given circuit: Vth=20∠0° VZth=5+j4 Ω

Q: X₂ = 0.2 E оздо X'a=0.3 1 10 10 XL1 = 0.3 XL2 = 0.3 V = 1.0 A 50Hz synchronous generator having…

A:

Q: you have a moving iron ammeter to measuring the current signal shown in figure bellow, the reading…

A:

Q: Write assembly language program to generate a square wave with an ON time of 3 ms and an off time of…

A:

Q: Q3) In a long-shunt compund generator, the terminal voltage is 230 V, when it delivers 150 A. The…

A: This question belongs to electrical machine . It is based on the concept of dc generator . Have a…

Q: A 13800 / 480 V, 3-phase transformer bank is connected as a wye-delta configuration. What must be…

A:

Q: 17. If a 575-volt three-phase motor originally connected in 3-parallel △ is reconnected in…

A: 17) A 575-volt three-phase motor originally connected in 3-parallel △ Now it is reconnected in…

Q: 2.In digital modulation the carrier is one: A) binary wave B) high continuous wave frequency C)…

A: Given  The digital modulation..

Q: Q6) Write the mesh-current equations only (don't solve) for the circuit shown below: O 22v Osv 4.5 A…

A: Mesh current analysis is a technique used to measure the current circulating around a loop in any…

Q: if the potential difference between two points is 60 V, how much energy is expended to bring 8 mc…

A: Given data, Potential difference between two point, V=60 V Charge, Q=8 mC

Q: What is the voltage Vas, if V1=98 V, V2= 104 V, R1= 48 KQ, R2= 28 KQ, R3= 12 KS2, R4= 41 K2. www R4…

A: Given circuit: V1=98 VV2=104 VR1=48 kΩR2=28 kΩR3=12 kΩR4=41 kΩ

Q: 2. Develop a simple ladder logic program that will turn on an output X if inputs A and B, or input C…

A: From the question, The Output is =X  The inputs are(let say)=A,B or C which were taken to be in a ON…

Q: A load of 40 -j 30 is connected to a source of 100 V with a phase angle of 300, through a…

A: Given load impedance, ZL=40-j30° On comparing with ZL=R-jXC

Q: Q4/:- For VCO-LO circuit block, if the message signal is the sine wave as shown in the figure below…

A: Given: message signal, m(t): F=1T=110-3=103 Hzwhere F is frequency of signalT is time…

Q: Determine Vo2 A) -1.0 V B) -2.4 V C) -6.6 V -9.0 V -10 Vo Ge Si KK I 1.2kQ 3.3 K2

A:

Q: Find the Laplace transform of x(t)= 3u(t) + eu(t).

A:

Q: Which of the following is NOT a measurement made by a BERT tester? O Bit error ratio O Errored…

A: Bit error rate testing, or BERT, uses specified stress patterns made up of a series of logical ones…

Q: i need the answer quickly

A:

Q: What could be an option to vary the capacitance of a capacitor even though the plate areas and…

A: The capacitance of a capacitor is given by the formula:…

Q: B) Calculate the reflection coefficient of the cavity reflectors for semiconductor laser with 500μm…

A: Given,Reflectors length = 500 μmAttenuation factor = 820/mThreshold gain = 3000/m

Q: Q1 Figure Q1(a) is a full wave bridge circuit with a capacitor filter and the output waveform…

A: Full wave bridge rectifier- Full wave bridge rectifier is a combination of four diode which are…

Q: Find the bilateral Laplace transform of the signal x(t) = sin(at) u (t)

A:

Q: When does the polarity of a transformer become significant?

A: Transformer is a static device which transfers the energy from one circuit to another circuit…

Q: find the fourier transform X(t)=3 Sin (10TT fet) Plot the signal of X(+) in the tim domain and…

A:

Q: 1. Formulate (in symbolic matrix form) and solve mesh equations for the following circuit. Assume…

A: It is given that: R1=10R2=20R3=30XC=10XL=30E=j10r=5

Q: The reactance data for the given power system is as follows: G₁ Item X¹ X² Xº G₁ G₂ Ti T2 Line 1-2…

A:

Q: no C- A system is given by : y(t) =4x (t), Is the system 1- linear or nonlinear? 2- memory or memory…

A: We need to check whether the given system is linear , memoryless or causal .

Q: Simplify the following Boolean functions, using four-variable Kmaps: F (A, B, C, D)=Σ(2, 3, 6, 7,…

A:

Q: how many time the following program will * print the message? in C++ int i = 1; i i 1; i = while(i)…

A:

Q: B) Find the Fourier transform x(t) for the following figure -T T

A:

Q: 10A 5 EMM 192 452 ww +Vx www 21a 652 +100V Determine the value for the voltage Vy using the…

A: Thevenin’s Theorem- Thevenin’s theorem states that it is possible to simplify any linear circuit,…

Q: Q3 In a long-shunt compund generator, the terminal voltage is 230 V, when it delivers 150 A. The…

A:

Q: Energy level at negative infinity

A: The Fermi function at negative infinity ....?

Q: 2. Determine all the node voltages. 18A (↑) 16A 200 M 400 2 $15.22 ↑ 30 A

A:

Q: SUBJECT:      Elements of Electrical Machines Design INSTRUCTIONS:      - Please write clearly and…

A: Transformer: It is a static device that is used for electrical to electrical power transfer without…

Q: Protection of transformers depend on size of transformer size of cables number of circuit breakers…

A: The device transfers electric energy from one alternating-current in circuit. that is know as a…

Q: A/ For the half-wave rectifier of Fig. shown below, the source is a sinusoidal of 120 Vrms at a…

A: We need to analyze the given half wave rectifier circuit

Q: described 4) A DT- by the following system difference of nation. |y[n] - 12y(n-1] + 2y[n-2] − y(n-1]…

A:

Q: he transfer function of a position control system is given by: etermine: a) Tp C(s) 1500 R(s) 2s²…

A: For the given transfer function Find  a) peak time b) percentage overshoot c) Rise time d) settling…

KVL and KCL

KVL stands for Kirchhoff voltage law. KVL states that the total voltage drops around the loop in any closed electric circuit is equal to the sum of total voltage drop in the same closed loop.

Sign Convention

Science and technology incorporate some ideas and techniques of their own to understand a system skilfully and easily. These techniques are called conventions. For example: Sign conventions of mirrors are used to understand the phenomenon of reflection and refraction in an easier way.