Q2/ The information in an analog signal voltage waveform is to be transmitted over a PCM system with an accuracy of ±0.1% (full scale). The analog voltage waveform has a bandwidth of 100 Hz and an amplitude range of -10 to +10 volts. Find the minimum sampling rate required. ii) Find minimum bit rate required in the PCM signal. iv) i) Find the number of bits in each PCM word. iii) Find the minimum absolute channel bandwidth required for the transmission of the PCM signal.

Q2/ The information in an analog signal voltage waveform is to be transmitted over a PCM system with an accuracy of ±0.1% (full scale). The analog voltage waveform has a bandwidth of 100 Hz and an amplitude range of -10 to +10 volts. Find the minimum sampling rate required. ii) Find minimum bit rate required in the PCM signal. iv) i) Find the number of bits in each PCM word. iii) Find the minimum absolute channel bandwidth required for the transmission of the PCM signal.

EBK ELECTRICAL WIRING RESIDENTIAL

19th Edition

ISBN:9781337516549

Author:Simmons

Publisher:Simmons

Chapter25: Television, Telephone, And Low-voltage Signal Systems

Section25.3: Signal System

Problem 1R

See similar textbooks

Similar questions

5- Discuss the effect of changing the number of bits on the recovered analog waveform. 6- Discuss the effect of changing the frequency of input analog signal on the reconstructed analog output signal.
The information in an analog voltage waveform is to be transmitted over a PCM system with a 10.1% accuracy (full scale). The analog waveform has an absolute bandwidth of 100 Hz and an amplitude range of -10 to +10 V. (a) Determine the minimum sampling rate needed. (b) Determine the number of bits needed in each PCM word. (c) Determine the minimum bit rate required in the PCM signal. (d) Determine the minimum absolute channel bandwidth required for transmission of this PCM signal.
discrete state. 3. A BCD counter can assume 4. A BCD counter can divide its input signal frequency by
In a PCM system, if maximum frequency of the input analog signal is 5 KHz and number of levels in the quantizer is 256. What will be bandwidth of the transmitted PCM signal?
Problem 2: The information in an analog signal voltage waveform is to be transmitted over a PCM system with an accuracy of ± 0.1 % of the peak-to-peak analog signal. The analog voltage waveform has a bandwidth of 100 Hz and an amplitude range of – 10 to + 10 Volts. Determine the minimum sampling rate required. b. Determine the number of bits in each PCM word. c. Determine the minimum bit rate required in the PCM system. d. Determine the minimum absolute channel bandwidth required for the transmission of the PCM signal.
how to draw the small signal model
6. Which of the following is not a type of signal is... a. analog signalb. Chain signalc. Binary signald. Dict signale. digital signal
What is sample and hold circuits?
What is the problem with AM signal when overmodulation occurs?
Give me right solution otherwise leave it. A voltage signal with a range of zero to 115 V. is to be converted by means of an ADC. Determine the minimum number of bits required to obtain a resolution of 10V?
In ADC circuit ,the input will be ........... signal.
Q/Design a filtered power supply that can produce dc output voltages of (+9V), (±10%) and (+9V), (±10%) with a maximum load current of (100 mA). The voltages are to be switch selec table across one set of output terminals. The ripple voltage must not exceed ( 0.25 Vrms).