On a clear summer afternoon with a wind speed of 3.20 m/s, the particu- late concentration was found to be 1,520mg/m at a point 2 km downwin and 0.5 km perpendicular to the plume centerline from a coal-fired power plant. Given the following parameters and conditions, determine the par- ticulate emission rate of the power plant: Stack parameters: Height = 75.0 m Diameter = 1.50 m Exit velocity = 12.0 m/s Temperature = 322°C %3D Atmospheric conditions: Pressure = 100.0 kPa Temperature = 28.0°C

On a clear summer afternoon with a wind speed of 3.20 m/s, the particu- late concentration was found to be 1,520mg/m at a point 2 km downwin and 0.5 km perpendicular to the plume centerline from a coal-fired power plant. Given the following parameters and conditions, determine the par- ticulate emission rate of the power plant: Stack parameters: Height = 75.0 m Diameter = 1.50 m Exit velocity = 12.0 m/s Temperature = 322°C %3D Atmospheric conditions: Pressure = 100.0 kPa Temperature = 28.0°C

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Combustion in a diesel engine is assumed to begin at TDC and proceed at constant pressure. The air/fuel ratio is 27/1, the calorific value of fuel is 43 MJ/kg, and the specific heat of combustion products is given by: Cy = 0.71 + 20x10-5 T where Tis the combustion products temperature in K unit. The gas constant for these products is taken to be 0.287 kJ/kg K. If the compression ratio is 15/1, and the temperature at the end of compression is 870 K, find at what percentage of the stroke the combustion is completed. 2312w
Consider a boiler that burns sub-bituminous coal. The boiler has a cyclone furnace burner and has a thermal capacity of 500 MW. Consider the calorific value of coal at 25 MJ/kg. Obtain the annual emissions of mercury emanating from this boiler with the specified control system; Report your result in kg/year. Also, estimate the emissions if the boiler did not have an emission control system (kg/year). Finally, report the % reduction in emissions obtained from the control equipment that the boiler has. Emission factor Hg= 6.88x10^-5 kg/J Emission factor Hg uncontrolled= 4.15x10^-5 kg/Mg
HMW-3 Combustion in a diesel engine is assumed to begin at TDC and proceed at constant pressure. The air/fuel ratio is 27/1, the calorific value of fuel is 43 MJ/kg, and the specific heat of combustion products is given by: Cy = 0.71 + 20x10-5 T where T is the combustion products temperature in K unit. The gas constant for these products is taken to be 0.287 kJ/kg K. If the compression ratio is 15/1, and the temperature at the end of compression is 870 K, find at what percentage of the stroke the combustion is completed.
mnot Tnot = 75°C Tout-? %3D mcold Tcod = 18°C %3D Hot and cold stream of water are mixing together as shown in Figure. The temperature of the hot and cold streams at the inlet are 75 deg-C and 18 deg-C, respectively. Mass flow rates of the hot and the cold streams are (1.50x10^-1) kg and (1.000x10^-1) kg, respectively. Find the temperature of the mixed stream. The specific heat of the hot water stream is 4000 J/kg-K and the cold stream is 3800 J/kg-K. Note: Your answer is assumed to be reduced to the highest power possible. Your Answer: х10 Answer
combustion chamber consists of tubular combustors of 15-cm diameter. Eompressed air enters the tubes at 550 K, 480 kPa, and 80 m/s. Fuel with a heating value of 42,000 kJ/kg is injected into the air and is burned with an air-fuel mass ratio of 40. Approximating combustion as a heat transfer process to air, determine the ( ) temperature, pressure, ( | velocity, and ( Mach number at the exit of the combustion chamber.
Date: 1 of 1 PROBLEM 6.18 Air at 90°C and 1.00 atm (absolute) contains 10.0 mole% water. A continuous stream of this air enters a compressor-condenser, in which the temperature is lowered to 15.6°C and the pressure is raised to 3.00 atm. The air leaving the condenser is then heated isobarically to 100°C. Calculate the fraction of water that is condensed from the air, the relative humidity of the air at 100°C, and the ratio m outlet air @ 100°C /m feed air @ 90°C. Solution Basis: 1 mol feed. Since the problem statement asks us to calculate the ratio of the volumes of feed air and exit air, we will label both volumes on the flowchart. DA = dry air Compressor Heater V1 (m³) V2 (m³) П2 (mol) n2 (mol) V2 (mol H20(v)/mol) (1-y2) (mol DA/mol) 15.6°C, 3 a 1 mol 0.100 mol H2O(v)/mol 0.900 mol DA/mol 90°C, 1 atm V2 (1-y2) 100 C, 3 atm N3 [mol H2O(1)] 15.6°C, 3 atm DEGREE-OF-FREEDOM ANALYSIS ON COMPRESSOR UNKNOWNS AND INFORMATION JUSTIFICATION/CONCLUSION 4 unknowns (V1, n1, n2, y2) 2 balances 1…
A gasoline engine is at a location where the temperature is measured to be 14.8 °C and produces 300 kW at 5800 rpm while consuming 0.0184 kg/s of fuel. During operation, data shows that its mechanical energy loss is 18 %, the actual volume of air going into each cylinder is 80% (the volumetric efficiency has a negligible variation), and the actual fuel-to-air ratio is 0.065. What were the engine parameters at sea level conditions if the pressure here is 99.3 kPa and the temperature here is 18 0C hotter than that of the elevated condition? Determine at sea-level conditions the Brake Power in kW.
2 m^3/min of a light oil are to be heated from 20C to 100C (with zero vaporization) in an exchanger using 250 kPa steam of 90% quality. The heat losses to the surrounding air have been estimated to be 5% of the heat transferred from the condensing steam to the oil. If the steam condensate leaves at its saturation point, what mass of steam perhour will be used in the exchanger? For light oil, Specific gravity= 0.88Specific heat= 2.00 kJ/kg-KFor steam at 250 kPa,Saturated liquid: hf= 535.49 kJ/kgvf=0.001067 m^3/kgSaturated vapor: hg= 2716.8 kJ/kgvg= 0.7188 m^3/kg
A proposed alternative diesel fuel contains 50% finely powdered bituminous coal and 50% ethanol by weight. The coal contains 4% moisture, has been cleaned of ash, and has an as-received HHV of 25 MJ/kg. Assume the coal has 5% hydrogen and 40% volatiles as-received. Find the as-received LHV of this fuel. Estimate the as-received mass fraction (%) of volatiles and the mass fraction (%) of fixed carbon in this fuel.
2. Two hundred and fifty pounds of a mixture of 10 mol% propane 20% n-butane, and 70% n-pentane is completely vaporized in a pipe still in one hour. At the outlet, the temperature anc 433 F and 600 psia. What is the volumetric flow pressure are rate in cfm at the outlet conditions? Answer: The physical properties of the gas are: Tc Pc MW Propane 369.9 K 665.8 R 42.0 atm 44 Butane 425.17 K 765.31 R 37.47 atm 58 Pentane 469.8 K 845.64 R 33.3 atm 72
Steam of 1.4MN/m2 and of dryness fraction 0.7 is throttled to 0.11MN/m2 determine the dryness fraction of the steam after throttling?
Calculate the EER rating of a 20 ton (240000 Btu) air conditioning unit with an average electrical load of 30 kW. An air conditioning plant supplies air to a room at a rate of 2.5 kg/s, the supply air being made up of equal parts by weight of outdoor and recirculated air. The mixed air passes through a cooler coil fitted with a by-pass duct, face and by pass dampers being used for humidity control. The air then passes through an after heater and supply fan. In a test on the plant, the following conditions (Table Qu 4) were recorded; 3 Table Qu. 4: Parameters recorded Relative humidity Dry bulb temperature °C Wet bulb temperature °C % Outdoor air 270 20.5 Room air 210 50 Supply air Air leaving cooler 160 11.8 80 90 coil Make neat sketches showing the plant arrangement and the psychrometric cycle and identify the corresponding points on both diagrams. Calculate the following; mass of air through the cooler coil load on cooler coil load on heater