Node A is sending some packets to node B with one-way delay is 50 milliseconds, the bandwidth of the link is 1 Mbps and the size of the packet is 50 bytes. If A is sending 200 packets from A to B, after sending 200 packets node A waits for the ACK then what is the percentage utilization of the link? [ Write the Ceil value of your answer].

Node A is sending some packets to node B with one-way delay is 50 milliseconds, the bandwidth of the link is 1 Mbps and the size of the packet is 50 bytes. If A is sending 200 packets from A to B, after sending 200 packets node A waits for the ACK then what is the percentage utilization of the link? [ Write the Ceil value of your answer].

Computer Networking: A Top-Down Approach (7th Edition)

7th Edition

ISBN:9780133594140

Author:James Kurose, Keith Ross

Publisher:James Kurose, Keith Ross

Chapter1: Computer Networks And The Internet

Section: Chapter Questions

Problem R1RQ: What is the difference between a host and an end system? List several different types of end...

See similar textbooks

Related questions

Q: If a host is monitored, and there are six TCP packets captured: {S1, E1, S2, E2,S3, E3}, where Si…

A: TCP follows Connection Oriented approach and all the packets will reach in same order

Q: In the figure, the communication link capacity between Router 1 and Router 2 is 3 Mbps. If a 2 Mbps…

A: Objective: Two routers are obtaining data traffic through a common channel. The channel capacity is…

Q: Suppose each user requires 500 kbps and is active only for 25% of the time. How many users can we…

A: Statistical multiplexing gain is performed by switching systems in communication networks that merge…

Q: If we know the capacity of the link (bandwidth) and the time to receive the first ACK (delay) fre…

A: The first packet was sent in 301ms =301/1000 =0.301second 1gb/s=1000000000 byte/sec

Q: We want to utransmit Data using the following Network via packet switching Conditions: Maximum…

A: Packet Switching: Convert the packet is the transfer between various networks of small parts of…

Q: the TCP Tahoe configuration network is used, why packet losses during the beginning of the…

A: INTRODUCTION: Why are packet losses during the beginning of transmission larger than during the…

Q: Assume that the link has an MSS of 100 bytes and that we are using a stop and wait protocol. If we…

A: Maximum Segment Size = 100 bytes RTT = 100ms We know, RTT = 2 * Tp Hence, Propagation delay (Tp) =…

Q: Assume that the link has an MSS of 100 bytes and that we are using a stop and wait protocol. If we…

A: Most extreme Segment Size = 100 bytes RTT = 100ms We know, RTT = 2 * Tp Henceforth, Propagation…

Q: Consider the extended LAN connected using bridges B1 and B2 in the following figure. If A sends a…

A: We have a connection of multiple nodes with bridges and hubs. Here we need to find the path of ports…

Q: Suppose each user requires 500 kbps and is active only for 25% of the time. How many users can we…

A: To find: To find the statistical multiplexing gain for users using packet switching with the given…

Q: Suppose each user requires 500 kbps and is active only for 25% of the time. How many users can we…

A: To find: To find the statistical multiplexing gain for users using packet switching with the given…

Q: Suppose each user requires 500 kbps and is active only for 25% of the time. How many users can we…

A: To find: To find the statistical multiplexing gain for users using packet switching with the given…

Q: A sends a total of 12 data packets to b using the stop wait protocol, as shown in the figure. How…

A: The above question is answered below

Q: Assume at a router r, the incoming bandwidth is bin and the outgoing bandwidth is bout What is the…

A: Given - Assume at a router r, the incoming bandwidth is bin and the outgoing bandwidth is bout . We…

Q: Suppose users share a 2 Mbps (i.e., 2×106 bits per second) link. Also suppose each user transmits…

A: The answer is..

Q: Consider the network shown in the figure below, with three links, each with a transmission rate of 1…

A: Given that, Bandwidth= 1 Mbps length of the packet= 5000 bits Propagation delay= 1 msec Transmission…

Q: In a network, If P is the only packet being transmitted and there was no earlier transmission, which…

A: Question. In a network, If P is the only packet being transmitted and there was no earlier…

Q: Between Host Q and Host Y, there are ten routers in a network. How many data connections will there…

A: Introduction: Network of Computers: A computer network is any network that utilizes numerous…

Q: Consider the sender A transmits 12 data packets to B using stop wait protocol. If every 3rd packet…

A: The answer is

Q: Given the below network routing graph (with costs), answer the following questions that follow: N1…

A: Given network routing graph with costs is shown below:

Q: According to the given figure, assume that, PC0 wants to send a message to PC4. If the distance…

A: Dear Student, We will use the following formulae to solve the question. Total time to send message…

Q: According to the given figure, assume that, PC0 wants to send a message to PC4. If the distance…

A: The details given Distance: 22000 km message size: 3.2 kbyte cable speed: 2.4×100000000 m/s…

Q: Assume that there is a single router between Alice's host and Bob's host. The bandwidth of the first…

A: ANSWER:-

Q: Consider the extended LAN connected using bridges B1 and B2 in the following figure. If A sends a…

A: The Answer is

Q: Consider the extended LAN connected using bridges B1 and B2 in the following figure. If A sends a…

A: The answer is

Q: What is the total delay (latency) for a frame of size 5 million bits that is being sent on a link…

Q: b. Suppose two hosts A and B are connected via a router R. The A-R link has infinite bandwidth; the…

A: Given : Suppose two hosts A and B are connected via a router R. (A-R link: infinite bandwidth) the…

Q: Consider the following situation: Source node has packets number 1, 2, 3, 4, 5, 6, 7, and 8 to send…

A: Go-Back-N - In Go-Back-N protocol if one packet is lost or dropped all the packet starting from the…

Q: what is the total latency for a frame of size 5 million bits that is being sent on a link with 10…

A: Link Length = 2000 Km = 2000 * 103 m Light speed inside the link = 2 * 108m/s Frame size is 5…

Q: Two hosts X and Y are connected by a single link. The propagation speed is 3 x 108 meters/sec. Host…

A: Below i have answered:

Q: Consider the extended LAN connected using bridges B1 and B2 in the following figure. If A sends a…

A: The complete answer is given below.

Q: Consider the extended LAN connected using bridges B1 and B2 in the following figure. If A sends a…

A: We have a connection of multiple nodes with bridges and hubs. Here we need to find the path of ports…

Q: A packet switch receives a packet and determines the outbound link to which the packet should be…

A: Given information: Packet length (L) = 1200 bytes Transmission rate (R) = 2 Mbps that is 2*106 bps.…

Q: What is the theoretical limit on the arrival rate at link (packet size is l and bandwidth is R)?

A: All things considered terms, throughput is the pace of creation or the rate at which something is…

Q: Suppose A and B nodes are on the same 10 Mbps broadcast and the propagation delay is 325 bit times…

A: AF t=0, A will transmit. At t=576, A is about to finish transmit In the failure Carl and 1-315. Bis…

Q: Consider a message of 200 octets to be sent from sender to receiver using 3 intermediate nodes. If…

A: Step 1:- Given:- Let the Bandwidth of the transmission line be BW as nothing is given. Now 200…

Q: Consider a message of 200 octets to be sent from sender to receiver using 3 intermediate nodes. If…

A: Answer: Let us consider a bandwidth for the transmission of B. Each node takes X amount of time to…

Q: Consider a message of 200 octets to be sent from sender to receiver using 3 intermediate nodes. If…

A: given: 200 octets, 3 nodes, 8packets of 10 octet info to find: transmission time

Q: Consider a message of 200 octets to be sent from sender to receiver using 3 intermediate nodes. If…

A: Consider a message of 200 octets to be sent from sender to receiver using 3 intermediate nodes. If…

Q: Consider a message of 200 octets to be sent from sender to receiver using 3 intermediate nodes. If…

A: Actually, given information: Consider a message of 200 octets to be sent from sender to receiver…

Q: Suppose, there are N = 4 nodes using the slotted ALOHA protocol. The nodes are contending for a 6…

A: In slotted ALOHA protocol It Divide time into slots of duration 1, synchronize so that nodes…

Q: Assume that there are only two stations, A and B, in a bus CSMA/CD network. The distance between the…

A: The Answer is in Below steps

Q: 2-A bus LAN has stations with packet arrival intensity 2=1.5 packets/sec per station. Packets are…

Q: For the following networks, can we subnet them according to the information given in the table…

A: Classes of IP address: Class A ( 8 bits for network id ) IP Address : 1- 126 Its Subnet Mask is…

Q: Suppose users share a 2 Mbps link. Also suppose each user transmits continuously at 1 Mbps when…

A: Total transmission rate= 2Mbps Minimum transmission rate required by each user = 1Mbps So it will be…

Q: Routing Table of R1 Destination Next Cost R2 network hop R1 200.20.20.0 R4 00 R6 200.20.30.0 R2 20…

A: Routing Table of R1: Destination Network Next Hop Cost 200.20.20.0 R4 100 200.20.30.0 R2 20…

Q: b) Suppose the server begins to transmit the packet at time t=0. when t= transmission delay, where…

A: The answer is

Q: Question 2: a) In Stop and wait protocol, sender wait for ACK before sending next packet. But what…

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Question

Computer networking subject rcs817

Node A is sending some packets to node B with
one-way delay is 50 milliseconds, the bandwidth of
the link is 1 Mbps and the size of the packet is 50
bytes. If A is sending 200 packets from A to B,
after sending 200 packets node A waits for the
ACK then what is the percentage utilization of the
link? [ Write the Ceil value of your answer].

System that digitally connects two or more computers for the purposes of communication and/or sharing resources. These networks may be composed of general or specialized hosts, PCs, servers, or networking hardware.

Expert Solution