Answered: load 800+j0 ohms is connected across a…

Engineering

Electrical Engineering

load 800+j0 ohms is connected across a 200 V and 50 Hz supply. Find the Power angle.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.7P: Let a 100V sinusoidal source be connected to a series combination of a 3 resistor, an 8 inductor,...

See similar textbooks

Related questions

Q: Q.18: For the circuit shown, find the value of coupling coefficient "k" and put the dots on 50/00 V…

A: Explanation: First, we are calculating the total impedance Considering the dotes are placed at the…

Q: A 5000KVA, 6600V, 3 star connected alternator has a resistance of 0.75 per phase Estimate by ZPF…

Q: Find power factor of given circuit 30/0° V rms -j22 42

A: Power factor is the ratio of true power by apparent power. The value of power factor lies in between…

Q: AC chopper circuit shown in the figure, the thyristor T1 is triggered at an angle a (180 <a <360). V…

A: For the given AC chopper circuit, the input voltage is vint=100sinωt V. The thyristor T1 is fired…

Q: For the circuit shown in Figure , given that f= 60 Hz, calculate the complex power supplied by the…

A: Resistors, inductors and capacitors form an integral part of any electrical circuit. A source,…

Q: QQAL 440 V rms 8 Þa two-terminal load draws 3 kVA of apparent power at a lagging power factor of…

A: Electric powerElectric power in DC circuits can be defined as voltage multiply by current. This…

Q: A 400 resistor is connected in parallel to a coil having a resistance of 10 and an inductance of 3H.…

A: As per the guidelines of Bartleby we supposed to answer first three subpart only for solution of…

Q: 1. A series circuit contains a resistance of 55.1 ohms and the voltage across through it has…

A: Given data: Resistance R= 55.1 Ω Voltage equation e=230 cos( 314t-500) V

Q: The variable resistor Ro in the circuit shown is adjusted until maximum average power is delivered…

A: Given circuit, To find Ro we need to find VTH and Isc.

Q: 3 A biomass plant with a power rating 137 MW has a power cost of $63 per MWh, while a plant with…

A: Given: Power rating of first biomass plant, P1=137 MW Power cost of first plant, C1=$63/MWh Power…

Q: The step down chopper is operating at 1 kHz. Other data are V=240 V, L = 10 mH, R = 102 and duty…

A: Given Vs=240 V L= 10 mH R=10 ohm D=0.6

Q: DIosn circuit shown is: (e,=5+4sin1000t+2sin3000t) V. 1. Derive the equation of currents (i) & (ic).…

Q: Q 1) Given that Z1 = 302(-40°) N and Z2 = 50215° N, find the (a) apparent power, (b) real po (c)…

Q: PART 1 The voltage across a 100+j25 Q impedance is 230230° V. The power factor of the load is 0.97…

Q: A power station is to supply two loads. The daily load curve of the station is as shown in figure…

Q: (b) Three loads are connected in parallel to a 240Z0° V rms of 50 Hz source. Load 1 absorbs 90 kW…

A: The detailed solution is provided below.

Q: (a) The base impedance in (N) (b) The reactive power drawn by the load (p.u.) (c) The total current…

Q: all V R sine sine Let the voltage source be 202135, the current source be 10245 and the impedance of…

A: In this question, We need to determine the value of resistance R if angle of current flow in this…

Q: Bonus problem A single phase generator delivers at its terminals a voltage of 600 Volts rms and a…

A: The solution is given below

Q: One side of a transformer has 1,800 turns while the other side has 450 turns. The high voltage side…

Q: ) The reactance g pressuxe coil cixcuit g a dynamometer type wattmeter is 2.5% g Coarection factox…

A: In this question, we will find find correction factor and percentage error in electrodynamometer…

Q: 510 V, 60 Hz, 8 poles, 810 rpm

Q: If a load absord 20KVA at the leading power factor of 0.6 Write the complex form of power

Q: A impedance of Z = 20236.87° N is connected across a source with a voltage of 141.421 sin (314.159t)…

A: Given ImpedanceZ=20∠36.87° ΩVoltage V=141.421sin314.159t v

Q: Find the impedance of a 600 n generator terminal impedance if the voltage 6 volt rms and the current…

Q: Find the following in rectangular form: a. What is the real power delivered by the source (in W)? b.…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: A 40 kW induction motor, with a lagging power factor of 0.76, is supplied by a 120 V rms 60 Hz…

A: The solution is given below

Q: 1) A. a heater is connected to voltage source of 250 V and absorbs P= 1000 W.S= 1400 VA .What is the…

A: The heater is connected to a voltage source of 250 Volts. The real power absorbed by the heater is…

Q: 2. Using the Illustration below. Compute the total impedance (Z), the total current (1), the voltage…

Q: 5. A 240-V rms 60-Hz source supplies a parallel combination of a 5-kW heater and a 30-kVA induction…

A: In this question , parallel connected load is given....We have to find out system apparent power ,…

Q: A load operating at 280 V RMS draws 81 A RMS at a power factor 0.97 leading. Find: 1. The real power…

A: Given, Vrms=280 VIrms=81 ACosϕ=0.97 leading

Q: Q.22: For the magnetically coupled circuit shown, find the voltage across (-J100) 100° impedance and…

A: For the magnetically coupled circuit shown calculation of voltage across (-j10 ohm) impedance and…

Q: For the circuit shown in figure Calculate (a) the power factor (b) the average power delivered…

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: a) Find the total impedance? b) What is the r.m.s value of the voltage source? c) What is the phase…

Q: Find the power delivered by the source. B)Find the reactive power delivered by the source. C)Find…

Q: Calculate the apparent power, real power, and reactive power for the circuit shown in Figure. Draw…

A: (b) Referring to the given circuit, whenever the DC supply is provided then all the capacitors will…

Q: Calculate the apparent power, real power, and reactive power for the circuit shown in Figure. Draw…

A: The circuit diagram is, a). f = 50 Hz, Determining the total impedance of the circuit,

Q: In a series circuit containing pure resistance and pure inductance, the current and voltage are…

Q: Problem 4 An electric saw, a wood shaper, and a motor load of a workshop establish a 18 kVA power…

Q: A 110-V rms, 60-Hz source is applied to a load impedance Z. The apparent power entering the load is…

Q: 62 Find power factor of given circuit ww 30/0° V rms O -j22 42

A: Power factor is the ratio of true power by apparent power. The value of power factor lies in between…

Q: 3. A load of 40+j55 ohm is connected across a 120-Volt source. Determine the value of the reactive…

A: Given parameters: Load resistance, RL = 40 + j55 ohm Source voltage, Vs = 120 V To find: Reactive…

Q: A motor load consists of a resistance of 6 Ohms in series with an inductance of 12 mH. Assume…

A: Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for…

Q: For the single-phase voltage controller the source is 120 V rms at 60 Hz, and the load is a series…

Q: R R. Lo +

Q: Calculate the real power P, reactive power Q and apparent power S, include units and show…

Q: 30. Which are used for power factor correction in industrial applications? a. farads b. capacitors…

Q: 2. In your own words, explain : a. What is reactive power? b. What is average power? C. What is…

A: As per the guidelines of Bartley we supposed to answer first question only for solution of remaining…

Q: □6 Assume a Thévenin equivalent source composed of V, in series with Zeq = Ree+1X (a) Prove that…

Concept explainers

Synchronous Motor

The synchronous motor is an AC electric type motor where at a steady-state the shaft rotation is synchronized with the supply current variable-frequency. To an integral number of AC cycles, the rotation period is exactly equal. The stator of the motor in the synchronous motor contains multi-phase AC electromagnets due to which a magnetic field is created that rotates in time with the oscillation of the line current. The rotor contains a permanent magnet and the rotor rotates in synchronization with the stator field at the same rate and provides the second synchronized magnetic field which is rotating in nature as a result. When the synchronous motor is supplied with independently excited multi-phase AC electromagnets on both the rotor and the stator, it is termed as a doubly-fed machine. The most widely used AC-type motors are the synchronous AC motor and the induction AC motors.

Question

A load 800+j0 ohms is connected across a 200 V and 50 Hz supply. Find the Power angle.

Unity

46.8

Zero

32.7

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The rms value of v(t)=Vmaxcos(t+) is given by a. Vmax b. Vmax/2 c. 2Vmax d. 2Vmax
41. Two ac sources feed a common variable resistive load as shown in figure. Under the maximum power transfer condition, the power absorbed by the load resistance R, is lall 6 2 j8 2 6 2 11020 ( 0706 O9020° (a) 2200 W (b) 1250 W (c) 1000 W (d) 625 W
Please show you detailed solution Number 10 A voltage of 250 volts at 50 Hz is impressed on a circuit having a 60-ohm resistor, 35-?F capacitor, and a 0.25-henry inductor in series. Determine power factor. A. 0.979 C. 0.924 B. 0.862 D. 0.707
15 A of current is taken by a non-inductive load at 125 V. In order that the same current shall be generated from 240 V, 50 Hz mains. An inductor is now also then connected in series. Note: The resistance of the inductor should be ignored and also assume the waveform to be sinusoidal. Determine the phase difference between the current and the applied voltage, the impedance of the circuit and the inductance of the inductor.
A generator rated at 30MVA, 11kV has a reactance of 40%. Calculate its p.u. reactances for a base of 50MVA and 10kV. O 0.606 p.u. O 0.506 p.u. O 0.806 p.u. O 0.706 p.u.
3. A 12020⁰ Vrms is to supply power to a welder, heater and an induction motor. A welder is a coil of (4+j3) ohm, the induction motor draws 60KW with 0.8 power factor, and the heater is a resistor that draws 15KW power. Find the complex power, real power, reactive power and the total power factor that must be supplied by source. If a capacitor will be used to supply a reactive power in the circuit in order that the net load will have a unity power factor, what reactive power must be supplied by the capacitor? Draw the circuit.
1) Two identical voltage waveforms of difference phase angles are shown in Figure B. Write down the expression of waveforms A and B clearly. HUS Voltage (V) 8 0 K/N B 7: ST ot
The power factor of the circuit shown in figure 2 is. a. 0.866 lagging b. 0.5 lagging c. 0.707 lagging d. 1
Q2. For the circuit shown below, sketch the current waveforms is and io and determine the Average and RMS for both currents. ot io Vs = 220V a = 220° + ot 1002
Draw the sinusoidal waveform of the AC voltage and current for the given loads below. Describe the characteristics of the waveform for each load. A. Pure resistor B. Pure inductor C. Pure capacitor
A single-phase AC voltage controller has a resistive load R = 10 Ohm, and the RMS input voltage is Vs = 230 V, 60 Hz. The delay angle is 120 degree. Then power factor of the circuit is: Select one: O a. 1 O b. 0.75 O c. 0.44 O d. None of the above O e. 0.9
Q2. For the circuit shown below, sketch the current waveforms iş and io and determine the Average and RMS for both currents. a = 50° TI 50 2 Vs = 300 sin 100zt ( cot T2 in cot