It is a method of control in limited areas where engineering control methods at the source are not practical. a. Adjusting work schedules b. Reduction of work periods c. Job Rotation d. Education of supervisors
1. It is a method of control in limited areas where engineering control methods at the source are not practical.
a. Adjusting work
b. Reduction of work periods
c. Job Rotation
d. Education of supervisors
2. Used as a way to reduce employee exposure to toxic chemicals or harmful agents must be used with care.
a. Adjusting work schedules
b. Reduction of work periods
c. Job Rotation
d. Education of supervisors
3. is process equipment-oriented. The aim of the safety and health professional should be to teach them about the safety and health hazards that may be found in work areas.
a. Adjusting work schedules
b. Reduction of work periods
c. Job Rotation
d. Education of supervisors
4. In what condition of Dispersion of contaminant is 65 fpm belong?
a. Released with practically no velocity into quiet air
b. Released at low velocity into moderately still air
c. Active generation into zone of rapid air motion
d. Released at high initial velocity into zone at very rapid air motion
5. In what condition of Dispersion of contaminant is 3000 fpm belong?
a. Released with practically no velocity into quiet air
b. Active generation into zone of rapid air motion
c. Released at high initial velocity into zone at very rapid air motion
d. None of the Above
Step by step
Solved in 2 steps
