is used to convert resistance value into voltage value.

Q: Using the data in Table 18.1, (a) calculate the resistance of an aluminum wire with 5 mm diameter…

A: Given that, Diameter of aluminum wire, d=5 mm,Length of aluminum wire, L=5 m,Electrical conductivity…

Q: EXAMPLE OF FAILURE CAUSED BY RESONANCE

A: Explanation Resonance: Resonance is the phenomenon at which the natural frequency is equal to…

Q: What is the total degree of freedom (DOF) of

A: To find Total DOF

Q: Calculate the angle between cables AB and AC using dot product A FAB 500 lb %3D FAC = 2000 lb B…

A: In the given figure, position vectors of different points are given by, A → = -2 i + 0 j + 2.5 kB →…

Q: 1. If two capacitors in parallel, they carry the same current. (a) True (b) False

A: Two or more capacitors are said to be associated in parallel in case each one of them is…

Q: what is the smallest gage size copper wire that will limit the conductor voltage drop to 5v when 120…

A:

Q: A 4 V battery, a 4 N resistor and a 3 2 resistor are connected in series. The battery has internal…

A:

Q: efer to the figure below and calculate the current (in Amps) through the R2 resistor

A: we will have to figure out the equivalent circuit

Q: What is the resistance of gauge no. 10 copper wire (diameter of 0.026 m), which is 1km long at 20…

A: given data diameter of copper wire =0.026 m radius = 0.026/2  =0.013m length of the copper wire…

Q: 9. Identify the resistance of the Following Five Band Resistor

A: From the five band Resistance the actual resistance which is 2000K Ohm +5%

Q: Explain what a load cell is and write the several types of load cells.

A:

Q: QUESTION 1 Suppose the frequency of a system is measured to be 2rad/s and after the addition of…

A: Frequency of spring mass system is given as  ω=km where ω, k, and m are angular frequency, spring…

Q: A 4-79 permalloy solenoid coil needs to produce a minimum inductance of 1.5 Wb/m2. If the maximum…

A: Data given - A 4-79 permalloy solenoid coil  minimum inductance of 1.5 Wb/m2 = 1.5 × 104 gauss…

Q: An electronic circuits that is used to implement the most elementary logic expressions is known as…

A:

Q: Conductivity readings are often referenced to a specific temperature typically equals for…

A:

Q: ne space constant for a resistance of 10

A: Need to find space constant foran axon.

Q: 2. Answer the following table Types of Advantage Disadvantage Relation Formula Application…

A:

Q: Calculate the equivalent resistance between A and B. A 3 ohm ww 9-ohm 5 ohm 4 ohm B 1.5 ohm O a. 1.5…

A: Option d is correct 2.2ohm

Q: A certain wire has a resistance of 90ohms. The resistance of another wire identical with the first…

A: Given that resistance of wire=90 ohms , Anothe wire whose resistance is R having same properties and…

Q: When n-type material is sandwiched between two p-type materials such type of transistor is called:

A: Solution: When N-Type material is sandwiched between two P-Type materials, Such a Type of Transistor…

Q: Define 'power'.

A: It can simply defined as the amount of work done per unit time. Or the rate of time of doing work or…

Q: Q#01: Briefly explain the following terms. a) Mechanical Vibration. b) Frequency. c) Natural…

A: Briefly explain the following terms.a) Mechanical Vibration.b) Frequency. c) Natural Frequency.d)…

Q: determine the total power rating of the electronic devices

A: Given: T∞=30°CTs=65°CL=1.5 mb=d=20 cm=0.2 mV=200 m/min=3.33 m/s To determine: The total power rating…

Q: The temperature measurement capability of thermistors is from 200°C to over 2000°C. Select one: True…

A: We have to determine the temperature measurement capability of thermistors

Q: Define German Magnetophon

A: Magnetophon recorders were comprehensively utilized in German radio creation during WWII, while they…

Q: Write the SI units of power.

A: Mathematically power can be expressed as, P=Wt=F→·s→t=F→·V→ Where W is the work, s is the…

Q: - Design a logic circuit that can compare between two-two bit binary number. Draw the circuit and…

A: Given Two two bit binary number To find Logic circuit Truth table

Q: find the applied voltage

A: Given data;   A DC servometer is directly driving an NC table.pitch= 5 mmspeed, N=100 rpmApplied…

Q: PV If A = T Enter the SI units for A using the base units only.

A:

Q: Explain the characteristic of parallel and series connection of resistor. Explain the term…

A: Electrical circuits can have their circuit elements arranged in either series or parallel. In series…

Q: 40KN 50KN. ,G0KH o 3m 4m Figure 2

A:

Q: The value of Vg-Vf at critical point is * O infinity two

A: Pure substance is the substance that can exists with same chemical composition in all the phases it…

Q: Write the SI units of natural frequency.

A:

Q: An electrical circuit includes a voltage source and two resistances (50 and 75 ohm) in parallel.…

A: Ohm's Law: It states that if all the physical parameters are constant then, the voltage across a…

Q: Calculate the output voltage if

A: Need to calculate output Voltage.

Q: The objective of this question is to give the missing information about the reading of thermocouple…

A: Given: J type thermocouple

Q: n and a current of 1000 A is being passe mm/min. (Use F 96500)

A:

Q: A circuit contains two un-equal resistances in series Select one: O A. " larger potential develops…

A: Given: A circuit contains two un-equal resistances in series

Q: If IC=3.95mA and IB=50µA, then IE calculates out to be: * 3.45MA 4mA 79mA .075mA

A:

Q: How many degrees are the current and voltage out of phase witheach other in a pure resistive…

A: The power varies between positive and negative instantaneous values over time, as it does in…

Q: I want to know the difference between Wave Winding Lap winding The laws used to solve problems

A: Difference between Lap winding and Wave winding-  Lap Winding Wave Winding 1. Lap winding is…

Axial Load

When a bar of the uniform cross-section is acted by a load, such that the load acts along the longitudinal axis of the bar, such kinds of loadings are known as axial loadings. In general terms, a load is an external force acting on a component. An axial load acts perpendicular to the geometric cross-section of the component. Based on the direction of the application of the load, an axial load can be tensile or compressive. The analysis of bodies under the action of axial loads is generally studied under the branch of mechanics, known as statics.