is experimenting with single slit diffraction. Cody shines a blue monochromatic light with a elength of 498 nm through a single slit, and observes that the first minimum occurs at an e of 40.0° from central maximum. Determine the width of the slit in nanometers, with no mal places please.

is experimenting with single slit diffraction. Cody shines a blue monochromatic light with a elength of 498 nm through a single slit, and observes that the first minimum occurs at an e of 40.0° from central maximum. Determine the width of the slit in nanometers, with no mal places please.

University Physics Volume 3

17th Edition

ISBN:9781938168185

Author:William Moebs, Jeff Sanny

Publisher:William Moebs, Jeff Sanny

Chapter4: Diffraction

Section: Chapter Questions

Problem 32P: The width of the central peak in a single-slit diffraction pattern is 5.0 mm. The wavelength of the...

See similar textbooks

Related questions

Q: Khufra works at a spring factory and he was assigned to test a certain spring, whose constant is 50…

A: 1) Work done by spring on block W = -12kx2 k is spring constant and x is change in length of…

Q: In an amusement park water slide, people slide down an essentially frictionless tube. The top of the…

A: Write the given values with the suitable variables. H=3.2 mh=1.2 m Here, H is the height of the top…

Q: Question: A hot-air balloon is descending at a rate of 5 m/s at a height of 200 m above the ground…

Q: In a 30°-rough incline, a 1.25 kg block is initially at rest beside a spring that is compressed by…

A: Work energy theorem can be used at the initial and final position of motion. Kinetic energy at those…

Q: A water wave has a frequency of 2 Hz, and there are 5 meters between each crest on the wave. a) How…

Q: Use the following constants if necessary. Coulomb constant, k=8.987×109N⋅m2/C2. Vacuum permitivity,…

A: Given:- An infinite wire linear charge density λ=5C/m. The wire is placed along the z-axis Find:-…

Q: DONT MIND THE BIG NUMBER ON THE RIGHT, IT IS JUST FOR NUMBERING. MAKE SURE IT IS CORRECT AND…

A: Given data : Distance covered by m2 when it starts falling down (S) = 37 cm = 0.37 m…

Q: A toaster has a resistance of 30 ohms. What power in watts does the toaster use when connected to a…

Q: 1000 V 3000 0.5 μF

Q: Three vectors A, B and C add together to yield zero, i.e. A + B + C = 0. The vectors A and C point…

Q: Britney Spheres. A solid sphere with mass 5.47 [kg] and diameter 10.7 [m] experiences a net torque…

A: Write the given values with the suitable variables. m=5.47 kgd=10.7 mr=d2=10.7 m2=5.35 mτ=65 N·m…

Q: 6. A candle 20 cm high is placed 10 cm in front of a plane mirror. Draw a ray diagram to show how…

A: Plane mirror is a flat reflective surface. For plane reflective surface angle of incident is equal…

Q: Other Ba…

Q: box of mass 25 kg on a rough inclined plane is pulled by a force F. The magnitude of frictional…

Q: Please explain it. AsAp A 1.5-mol monoatomic gas (s=7.6 J/mol-K) experiences a 20-Kelvin…

A: Given:- n= 1.5 mol s= 7.6 J/mol-K ∆T= -20 K. (-ve as temprature is dropping) W= 750 J To find:- ∆U

Q: .. Using Ampere's law derive an expression for the magnetic field due to a long, hollow cylindrical…

Q: an airplane is traveling due north at an airspeed of 250km/h when it encounters a wind with a speed…

Q: Solve the following problems. 2. What current flows through a 220-watt light bulb connected to a…

A: Given data Power of a light bulb P = 220 Watt Voltage across the bulb V = 110 Volt Power in a…

Q: : You have a rock with a volume of 15cm³ and a mass of 45 g. What is its density?

A: Introduction : In this question we are provided with value of volume and mass . with these data we…

Q: Select the correct statement: The sum of the voltages at a node is zero. The current in…

Q: Please show solutions. 1.In simple circuit, if emf of the battery is 12v, internal resistance is 2…

A: Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: -rough incline, a 1.25 kg block is initially at rest beside a spring that is compressed by 24 cm as…

A: mass of block = 1.25 kg Angle of incline = 30 degree initial compression = 0.24 m spring constant =…

Q: 6. (14.21) A 0.095-kg aluminium sphere is dropped from the roof of a 55-m-high building. If 65% of…

Q: The uniform electric field between two parallel plates of opposite and separate loads of 40 mm has…

Q: 5. A sample of protactinium -234 of mass 100 g has a half-life of G-7 hours.. A. what praction of…

A: We have a sample of protactinium-234 having a mass m=100 g and a half life T1/2=6.7 hours. Let the…

Q: In the given figure below, a 3.0 -kg block is sliding down a 60o-rough incline. The speed of the…

Q: Richard observes that a single slit that is2,022 nm wide forms a diffraction pattern when…

Q: A bag of wheat weighs 200 kg. To what height should it be raised so that potential energy is 9800 J?…

A: Given data : Potential energy = P•E Mass of the bag = m…

Q: A 10-meter boom with a mass of 30 kilograms is held by a steel cable 6 meters from its left end.…

Q: ltiple Choice Opposite vectors have: 1. different magnitudes and directions 2. the same magnitude…

A: Given:- Opposite vectors have: Find:- correct option 1. different magnitudes and directions 2. the…

Q: The system in the figure is released from rest. The coefficient of kinetic friction between block A…

Q: True or False (Explain if False) 1. Joseph Musk launches two satellites of different masses to…

Q: South-line. Consider sphere with mass M and radius R. Assuming that the moment of inertia of the…

Q: 7.00 Ω Μ 5.00 Ω w Μ 2.00 Ω 15.0 V + A + ε

Q: Four circuits have the form shown in the diagram below. The capacitor is initially uncharged and the…

Q: A 4.0 kg object has the following two forces acting on it: F₁ = (181 +153) N F₂ = (-111 +233) N If…

Q: 3cm q₁=-2μC 9₁-4.5μC 4cm Figure 1 9₁-8μC B

Q: In a 300-rough incline, a 2.15 kg block is initially at rest beside a spring that is compressed by…

A: in this question first of all draw free body diagram of question then solve it with work energy…

Q: In the given figure below, a 3.0 -kg block is sliding down a 60°-rough incline. The speed of the…

Q: Khufra works at a spring factory and he was assigned to test a certain spring, whose constant is 71…

Q: Q1/ If you knew that Ne^-2x² = 1- Find the value of N, which makes the function (4) a standard…

Q: The voltage in circuit is 64 V and resistance is 28 ohms, calculate the current ?

A: Given Voltage (V) = 64 V Resistance (R) = 28 ohm's From. ohm's. law Current through…

Q: Khufra works at a spring factory and he was assigned to test a certain spring, whose constant is 50…

Q: A martian (of mass 200 kg) is located 300 km above the surface of Mars. What is the magnitude of the…

Q: Consider an object standing at a distance s0 from a thin lens in air. Given the object distance (in…

Q: What is the electric field due to a point charge of 20nC at a distance of 1 meter away from it?…

A: Given The magnitude of the charge is given as q=20 nC=20×10-9 C Distance is given as r=1 m We have…

Q: UESTION 10 The net force on an object determines which direction that object will accelerate in.…

A: Direction of acceleration of an object is in direction of net force . Therefore , we can say that…

Q: A car is moving at a speed of 6 meters/Second In 5 Seconds, he increases its speed to 16…

A: We know thatv=u+atWherev=final velocityu=initial velocitya=accelerationt=time taken

Q: If the energy received by 5 m² area in 430 seconds is 5120KJ. Find the value of Solar constant ?

A: Introduction : In this question we are provided with value of area , time and energy . With these…

Q: Suppose the current charging a capacitor is kept constant. Which graph below correctly gives the…

Concept explainers

Diffraction of light

In physics, the term diffraction is defined as the bending of light around the corners of the obstacle. As a light ray passes by an aperture, it bends around the edges or through slits, it spreads out through a narrow opening. The diffracted light will produce fringes of bright and dark or colored bands which are labeled as a diffraction pattern.

Question

Cody is experimenting with single slit diffraction. Cody shines a blue monochromatic light with a
wavelength of 498 nm through a single slit, and observes that the first minimum occurs at an
angle of 40.0° from central maximum. Determine the width of the slit in nanometers, with no
decimal places please.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

$Diffraction of light$

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

(a) Sodium vapor light averaging 589 nm in wavelength falls on a single slit of width 7.50 m. At what angle does it produces its second minimum? (b) What is the highest-order minimum produced?
Fifty-one narrow slits are equally spaced and separated by 0.10 mm. The slits are illuminated by blue light of wavelength 400 nm. What is angular position of the twenty-fifth secondary maximum? What is its peak intensity in comparison with that of the primary maximum?
For a three-slit interference pattern, find the ratio of the peak intensities of a secondary maximum to a principal maximum.
Suppose that the highest order fringe that can be observed is the eighth in a double-slit experiment where 550-nm wavelength light is used. What is the minimum separation of the slits?
When a monochromatic light of wavelength 430 nm incident on a double slit of slit separation 5 m, there are 11 interference fringes in its central maximum. How many interference fringes will be in the central maximum of a light of wavelength 632.8 nm for the same double slit?
(a) Find the angle of the third diffraction minimum for 633-nm light falling on a slit of width 20.0 m. (b) What slit width would place this minimum at 85.0°?
What is the highest-order maximum for 400-nm light falling on double slits separated by 25.0 m?
Determine the intensities of two interference peaks other than the central peak in the central maximum of the diffraction, if possible, when a light of wavelength 628 nm is incident on a double slit of width 500 nm and separation 1500 nm. Use the intensity of the central spot to be 1mW/cm2 .
A hydrogen gas discharge lamp emits visible light at four wavelengths, =410 , 434, 486, and 656 nm. (a) If light from this lamp falls on a N slits separated by 0.025 mm, how far from the central maximum are the third maxima when viewed on a screen 2.0 m from the slits? (b) By what distance are the second and third maxima separated for l=486 nm?
What is the separation between two slits for which 610-nm orange light has its first maximum at an angle of 30.0°?
Consider a single-slit diffraction pattern for =589 nm, projected on a screen that is 1.00 m from a slit of width 0.25 mm. How far from the center of the pattern are the centers of the first and second dark fringes?
Two slits of width 2 m, each in an opaque material, are separated by a center-to-center distance of 6 m. A monochromatic light of wavelength 450 nm is incident on the double-slit. One finds a combined interference and diffraction pattern on the screen. (a) How many peaks of the interference will be observed in the central maximum of the diffraction pattern? (b) How many peaks of the interference will be observed if the slit width is doubled while keeping the distance between the slits same? (c) How many peaks of interference will be observed if the slits are separated by twice the distance, that is, 12 m, while keeping the widths of the slits same? (d) What will happen in (a) if instead of 450-nm light another light of wavelength 680 nm is used? (e) What is the value of the ratio of the intensity of the central peak to the intensity of the next bright peak in (a)? (f) Does this ratio depend on the wavelength of the light? (g) Does this ratio depend on the width or separation of the slits?