In measuring the surface tension of a liquid (drop weight method), 20 drops of the liquid (r = 0.2cm) falling apart from the tip whose diameter is 0.4 cm were found to weight 0.95 gram. What is the surface tension of the liquid?

In measuring the surface tension of a liquid (drop weight method), 20 drops of the liquid (r = 0.2cm) falling apart from the tip whose diameter is 0.4 cm were found to weight 0.95 gram. What is the surface tension of the liquid?

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: A right circular cylinder volume υ is to be calculated fromthe measured base radius R and height H .…

A: Write the given information.

Q: pectin was studied. With this purpose, a 75°Brix concentrated industrial juice was assayed, and by…

A: The data given for the juice was plotted and then curve fitting was done to obtain the best curve…

Q: Example 3: A manometer is attached to a tank of gas in which the pressure is 104.0 kPa. The…

Q: 2. To perform a Kruskal-Wallis test, (a) first rank the observations y, in ascending order and…

A: The correct option is A. In the Kruskal-Wallis test first we need to arrange data in ascending order…

Q: A computer is protected against impact by foam packaging (spring stiffness, k = 100 N/cm; mass, m =…

A: Given data: The maximum force during the impact can be determine as,

Q: Why does the viscosity of a gas generally decrease with decreasing temperature whereas for a liquid…

Q: A U-tube manometer, attached to an air pipe, measures 20 cm of mercury. Che pressure, in kPa, in the…

A: Option a is correct.

Q: a) what is the laplace equation for a sphere?

A: Note:- As per the guidelines of the Bartleby only one question has to be answered at a time, so…

Q: The pressure drop, AP, in a horizontal pipe depends on the pipe diameter, d, pipe length, L, pipe…

A: The total number of dimensional parameters are 7 Write out the dimension of all the variables No.…

Q: One end of a capillary tube 10 cm in length and 1 mm in diameter is connected to a water supply…

Q: Air with density of 1.225 kg/m^3 and viscosity of 1.789 x 10^-5 kg/m-s flows in a wind tunnel, the…

Q: From the data obtained by a group of students below, compute the experimental den of the material…

A: Given, Material = Copper Standard Density = 8.9 g/cm3 Diameter = D = 3.25 cm Height = h = 6.48 cm…

Q: A tentative rule was given about tipping in Testing Experiment Table 8.4, where if a vertical line…

A: Given Width, w = 13 cm Height, h = 20 cm Find The angle

Q: Calculate the individual uncertainties associated for measuring this velocity from the provide…

Q: A vessel of cylindrical shape of 50 cm diameter and 75 cm height, contains 4 kg of gas. The pressure…

Q: The following tables show one measurement for the 90°-deflection plate. Referring to the lab manual,…

Q: II. Problem Solving Show your step-by-step solutions. 1. One mole of helium is contained in a vessel…

A: Given data 1 Moles of helium = n =1 We have to find the distance by which a mass of 2 kg has to fall…

Q: In a fluid mechanics experiment, you are given two unknown metals and was asked to determine if the…

A: When a body is immersed into a fluid, then the fluid exerts a force on the solid in the upward…

Q: Using Newton’s laws, we could show that for some pendulums, the period T is related to the length l…

A: Given the relation between the time period of oscillation and length of the pendulum, T =…

Q: How much time is required to inject a sample equal to 2.0% of the length of a 60 cm capillary if the…

A: Solution: Given Data: S=2%L=60 cmD=50×10-6 m∆P=2×104 Paμ=0.0010 kg/m-s

Q: A water column in a glass tube is used to measure the pres sure in a pipe. The tube is 1/2 in. in…

A: Given:Diameter of the tube, d1=12in ; d2=18in ; d3=16inFind: Water column due to surface tension…

Q: Manometer Mass of piston (kg) readings (KN/m²) 0.5 12 1 24 2 50 4.5 100 5.5 125 Draw the following…

A: To draw: The graph at the suitable scale. Given: Experimental data of mass and pressure is given.…

Q: After performing an experiment in a manner similar to the procedure described in the lab manmal, it…

Q: Carrier 0,36 0.032 PSYCHROMETRIC CHART 0.031 .030 0,40 NORMAL TEMPERATURES SI METRIC UNITS 0,027…

A: Calculated heat transfer per unit kilogram of dry air.

Q: For an atmospheric pressure of 101 kPa (abs) determine the heights in meters of the fluid columns in…

A: Pressure = density*gravity*height

Q: For many viscous materials, the viscosity n may be defined in terms of the expression deldt where o…

Q: 1- Consider the measurement of pressure in a gas through measurement of its temperature T and…

A: As given measurement of pressure using density and temperature and All these 3 parameters are…

Q: An object is submerged below the surface of the sea with an exerted pressure of 99.92 bar. How deep…

A: Pressure is defined as the intensity of force of weight of fluid acting over a unit area. The…

Q: An engineer living at an elevation of 2500 ft is conducting experiments to verify predictions of…

Q: As shown in Fig. 1.12, a horizontal interface 0-0 exists between two immiscible liquids. The dynamic…

Q: A machine that fills cereal boxes is supposed to be calibrated so that the mean fill weight is 12…

A: Solution: a) No, ?0 can NOT be rejected since the p-value is not small.

Q: Viscosity is defined as the measurement of the resistance of a fluid to gradual deformation by shear…

A: The sphere is initially driven downward, so that the upward force is smaller than the downward…

Q: The barometer can be used to measure ground clearance on aircraft. At a time when Ground Control…

Q: (c) Viscosity is defined as the measurement of the resistance of a fluid to gradual deformation by…

A: The drag force on the ball must be equal to the weight of the ball in order to attain a constant…

Q: The following data have been obtained during a creep test of an asphalt paving mixture under a…

A: Given σt= 700 kPa , T= 20°C and also the creep(c) at a given time(t)t1= 100 s , c1=0.6 % ;t2= 200 s…

Q: An engineer sets the pressure in a supply tank usinga very accurate manometer as a guide and then…

Q: skater weighing 500 N skates at 10 m/s and is supported by an average skating area of 10 cm2. If the…

Q: 8. The density of air is about 1.24kg/m³ at sea level and virtually zero at upper levels of the…

Q: 04 Example 3.5 A U-tube manometer similar to that shown in Figure 3.8 is used to measure the gauge…

Q: A core was mounted in a gas permeameter to measure permeability. Determine the liquid permeability…

Q: Write the primary dimensions of each of the following variables, showing all your work: (a)…

A: Ans(a) Specific heat at constant pressure Q=mCP∆TCP=Qm∆TCP=[ML2T-2][Mθ]=[L2T-2θ-1]

Q: An airplane that has a cross-sectional diameter D = 4 m of the front portion is to fly at a speed of…

Q: At a shear rate of 10 s-1, the apparent viscosity of non-Newtonian liquid was found to be 1.0 Pa.s.…

Q: The kinematic viscosity of liquid oil is 20 stoke and relative density = 0.85. Find the dynamic…

A: Given: kinematic viscosity of liquid = 20 stokes The relative density = 0.85

Q: After performing an experiment in a manner similar to the procedure described in the lab manual, it…

Q: In the development of a new piece of equipment, it is necessary to measure the shear stress (7)…

A: Given: The velocity of plate, v = 2 m/s The distance between plates, h = 0.025 m

Q: When a fluid flows over a surface, the shear stress 1 (N/m) at the surface is given by the…

Q: Pressure gauge B is to measure the pressure at point A in water flow as shown in Figure (1). If the…

Q: GRESFA1 PhC-hydrostatic pressure experienced by Aaron 36. What is 8 feet in meters? 2.4 M 37. What…

Question

100%

In measuring the surface tension of a
liquid (drop weight method), 20 drops of
the liquid (r = 0.2cm) falling apart from
the tip whose diameter is 0.4 cm were
found to weight 0.95 gram. What is the
surface tension of the liquid?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The capillary rise and fall in the glass tube used for both measuring water level and mercury level is not to exceed 0.8mm and 0.3mm respectively. Determine the minimum size of a glass tube for both liquids, given that surface tension of water = 0.082N/m and surface tension of mercury= 0.52 N/m with diagram. MODEL QUESTION PAPER
Answer the following. A: When the pressure of liquid is increased from 3.5 MN/m² to 6.5 MN/m² its volume is found to decrease by (0.08) percent. What is the bulk modulus of elasticity of the liquid? B: An open cylindrical tank (1.2m) in diameter and (1.8m) deep is filled with water and rotated about its central axis at (60 r.p.m). How much liquid is spill and how deep of the water at the central axis.
A manometer using oil (density 0.900 g/cm3) as a fluid is connected to an air tank. Suddenly the pressure in the tank increases by 7.61 mmHg. Density of mercury is 13.6 g/cm3. By how much does the fluid level rise in the side of the manometer that is open to the atmosphere? ? cm
3. A barrel contains a 15 cm layer of oil of density 5.88 kN/m3 floating on water that is 30 cm deep. What is the gauge pressure in mmHg at the oil-water interface?
1.The density p Determine how the density varies with pressure along the depth h. The density at the surface of the fluid is of a fluid varies with depth h, although its bulk modulus K can be assumed constant. Po. 2.A circular disc of diameter (D) is slowly rotated with angular velocity of ( wi) in a liquid of large viscosity (u) at a small distance (h) from another moving disc at counter clockwise rotation of (w2), as shown in figure (2). Derive an expression of torque (T) necessary to this case. D Figure (2)
Sometimes manometer dimensions have a signifi canteffect. In Fig. containers ( a ) and ( b ) are cylindricaland conditions are such that p a = p b . Derive a formula forthe pressure difference p a - p b when the oil–water interfaceon the right rises a distance ∆ h< h , for ( a ) d << D and ( b ) d=0.15 D . What is the percentage change in the value of ∆ p ?
PLEASE ANSWER THEM ASAP ALL FOR AN UPVOTE. I PROMISE THAT. At 20 0 C, determine pressure (in N/m²) inside a water droplet having diameter of 1.5 mm with a surface tension of 0.053 N/m. a.) What is the working formula of pressure to be used in this problem? b.)What is the diameter of the droplet (in m - enter your complete answer in decimal system)? c.) What is the radius of the droplet (in m - enter your complete answer in decimal system)? d.) What will be the modified working equation to be used to solve this problem based from the given? e.) What is the pressure inside the droplet of water (in N/m²)? f.)What is the pressure inside the droplet of water (converted to its CGS unit)?
1. A special-purpose piece of laboratory glassware, called a pyncnometer; is used to measureLiquid densities. It has a volume of 25 cc, and a mass of 17 .24 g when it is full of air. Whenfilled with a liquid of unknown density, its mass = 45.00 g. What is the density of this liquid?How large an error do we make if we ignore the mass of the air that was in it when we weighed itand found m = 17.24 g?
Calculate the capillary rise in cm in a glass tube of 3.0 mm diameter when immersed vertically in water. Take the surface tensions for water as 0.52 N/m in contact with air. a. 0.966 b.0.456 c. 0.1432 d. 0.3275
Directions: Solve the following problems completely, and make a detailed solution. Any incompletesolution arriving at such answers will never be considered. A barrel contains a 15 cm layer of oil of density 5.88 kN/m3 floating on water that is 30 cm deep. What is the gauge pressure in mmHg at the oil-water interface?
Fluid Properties- The difference in pressure between theinside and outside of a soap bubble wasobserved to be 1.6 N/m. If the surfacetension of the liquid is 40 dyne/cm, what will be the diameter of the bubble in meters?
2)What is the maximum gauge pressure of water that can be measured using a piezometer 2.5 m high? almosphere? (Ans. 24.5 kN/m2)