In measuring a voltage, a voltmeter uses some current from the circuit. Consequently, the voltage measured is only an approximation to the voltage present when the voltmeter is not connected. Consider a circuit consisting of two 1760- resistors connected in series across a 50.0-V battery. (a) Find the voltage across one of the resistors. (b) A voltmeter has a full-scale voltage of 50.0 V and uses a galvanometer with a full-scale deflection of 6.85 mA. Determine the voltage that this voltmeter registers when it is connected across the resistor used in part (a). Voltmeter Rv WW

In measuring a voltage, a voltmeter uses some current from the circuit. Consequently, the voltage measured is only an approximation to the voltage present when the voltmeter is not connected. Consider a circuit consisting of two 1760- resistors connected in series across a 50.0-V battery. (a) Find the voltage across one of the resistors. (b) A voltmeter has a full-scale voltage of 50.0 V and uses a galvanometer with a full-scale deflection of 6.85 mA. Determine the voltage that this voltmeter registers when it is connected across the resistor used in part (a). Voltmeter Rv WW

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter10: Direct-current Circuits

Section: Chapter Questions

Problem 69AP: Consider the circuit below. The battery has an emf of = 30.00 V and an internal resistance of r =...

See similar textbooks

Similar questions

Power P0 = I0 V0 is delivered to a resistor of resistance R0. If the resistance is doubled (Rnew = 2R0) while the voltage is adjusted such that the current is constant, what are the ratios (a) Pnew/P0 and (b) Vnew/V0? If, instead, the resistance is held constant while Pnew = 2P0, what are the ratios (c) Vnew/V0, and (d) Inew/I0?
Power P0 = I0 V0 is delivered to a resistor of resistance R0. If the resistance is doubled (Rnew = 2R0) while the voltage is adjusted such that the current is constant, what are the ratios (a) Pnew/P0 and (b) Vnew/V0? If, instead, the resistance is held constant while Pnew = 2P0, what are the ratios (c) Vnew/V0, and (d) Inew/I0?
In measuring a voltage, a voltmeter uses some current from the circuit. Consequently, the voltage measured is only an approximation to the voltage present when the voltmeter is not connected. Consider a circuit consisting of two 1830- resistors connected in series across a 70.0-V battery. (a) Find the voltage across one of the resistors. (b) A voltmeter has a full-scale voltage of 70.0 V and uses a galvanometer with a full-scale deflection of 4.34 mA. Determine the voltage that this voltmeter registers when it is connected across the resistor used in part (a). (a) Number (b) Number Units Units R Voltmeter Rv V www R
In measuring a voltage, a voltmeter uses some current from the circuit. Consequently, the voltage measured is only an approximation to the voltage present when the voltmeter is not connected. Consider a circuit consisting of two 2060- resistors connected in series across a 50.0-V battery. (a) Find the voltage across one of the resistors. (b) A voltmeter has a full-scale voltage of 50.0 V and uses a galvanometer with a full-scale deflection of 5.45 mA. Determine the voltage that this voltmeter registers when it is connected across the resistor used in part (a). (a) Number i (b) Number i R Units Units Voltmeter Rv www + V ww R (G)
In an automobile, the system voltage varies from about12 V when the car is off to about 13.8 V when the car is onand the charging system is in operation, a difference of15%. By what percentage does the power delivered to theheadlights vary as the voltage changes from 12 V to 13.8 V?Assume the headlight resistance remains constant.
In measuring a voltage, a voltmeter uses some current from the circuit. Consequently, the voltage measured is only an approximation to the voltage present when the voltmeter is not connected. Consider a circuit consisting of two 1830- resistors connected in series across a 70.0-V battery. (a) Find the voltage across one of the resistors. (b) A voltmeter has a full-scale voltage of 70.0 V and uses a galvanometer with a full-scale deflection of 4.34 mA. Determine the voltage that this voltmeter registers when it is connected across the resistor used in part (a). (a) Number i 35.15 (b) Number i 19.16 ww R Units V Units V + Voltmeter Rv V R
All of the electrical outlets in a room are connected in a single parallel circuit. The circuit is equipped with a 20-A fuse, and the voltage is V = 120 V. (a) What is the maximum total power that can be supplied by the outlets without blowing the fuse? W(b) How many 1,300-W appliances can be plugged into the sockets without blowing the fuse? appliance(s)
All of the electrical outlets in a room are connected in a single parallel circuit. The circuit is equipped with a 20-A fuse, and the voltage is V = 220 V. (a) What is the maximum total power that can be supplied by the outlets without blowing the fuse?W(b) How many 1,300-W appliances can be plugged into the sockets without blowing the fuse?appliance(s)
The RC charging circuit in a camera flash unit has a voltage source of 295 V and a capacitance of 126 µF. HINT Apply the expression q = Q(1 - e-t/RC). Click the hint button again to remove this hint. (a) Find its resistance R (in ohms) if the capacitor charges to 90.0% of its final value in 14.2 s. (b) Find the average current (in A) delivered to the flash bulb if the capacitor discharges 90.0% of its full charge in 1.14 ms. A
(a) Three 1.5-V dry cells are connected in series. What is the total voltage of the combination? (b) What would be the total voltage if the cells were connected in parallel?
Two identical resistors of 276 Ohms are configured in parallel and connected to a 13.3V power supply. If the same two resistors are then connected in series,what should the voltage of the power supply by charged to such that the parallel and series configurations draw the same amount to power?
Consider a 12.0 V motorcycle battery with an internal resistance of 0.53 Ω. (a) Find the terminal voltage, V, in volts, when the battery is being charged by a current of 9.5 A. (b) What is the output voltage, Vcharge, in volts, of the battery charger?