In figure below, the inductive reactance of 10 mH inductor at 50 Hz is : L 10 mH 10 V 60 Hz

Q: 14.1 a) Find the cutoff frequency in hertz for the RL fil- ter shown in Fig. P14.1. b) Calculate…

A: Given  An RL circuit diagram , we need to determine cutoff frequency and output voltage. Please find…

Q: In a microwave communications system, determine the noise power for an equivalent noise bandwidth of…

A: Microwave communication- Microwave communication is define as the communication in which the the…

Q: 8. Draw the output waveform for the circuit shown below given Vin(pp)=20V. Write the name of the…

A: We need to find out the output voltage for given circuit

Q: Given an analog x(t)= 5c sampled at a rate of 8,

A:

Q: Calculate the R.M.S value of the current waveform shown in figure below. 6 45 7 8 9 10 11 12 t i(t)…

A:

Q: Explain the steps for chip mounting.

A: Chip mounters are required for the mass manufacture of consumer and other electronic products…

Q: PI, & P of each element ID Si 10 mA ' 2.2 ΚΩ k ' 1.2 ΚΩ R₂ V₂

A: We need to find out the power of the given circuit.

Q: 2. Find the s-domain expressions for the h- and T-parameters of the following network shown below…

A:

Q: Stery readings, calculate the complex impedance of the mystery component. Where X and Y are the last…

A:

Q: For the circuit of Fig. below, calculate the phase and line currents. 3012 173/9: V 30 12 173/120 V…

A: The given circuit can be redrawn and the current in the branch can be parameterized as shown.

Q: Explain what the voltage reg

A: Given  We need to explain the down voltage regulation of a power transformer. Please find the below…

Q: what is one-stage lead compensator? And what is two-stage lead compensator?

A: Compensator in control system are used for improving performance specifications i.e. transient and…

Q: Design a full-wave bridge type power supply. Design the transformer, filter and regulator section.…

A: Desired output voltage =5.2V Power =15mW P=VI15m=5.2II=2.88mA Assume C=1mF R=VI=5.22.88m=1.8k ohm

Q: A medium-rise building with inductive loads has an average consumption of 40 kW and 26 KVAR. At the…

A:

Q: Q3\ For the circuit shown find: 1. By using voltage divider rule, calculate VR, Vc. 2. calculate…

A:

Q: Three resistors of 50 ohms, 100 ohms, and an unknown resistance R are connected in parallel and the…

A:

Q: Q3:- Calculate the frequency of the output F2. TFF F-8 KHz CK TFF CK F2

A: Given the asynchronous T-flipflop. Input clock frequency=8KHz. The output frequency is,

Q: Q2: a small com battery of (150 50 watt, laptop 1- Draw the sche 2- Find the total 3- Capacity of…

A: Given  6 PV penal to be installed at each with the specifications as stated below- Rated power…

Q: current divider rule. E 41₁ www.voo R≥30 X₁ 24Ω 12 X80

A:

Q: 3) The capacitance in a regular RC circuit is C = 0.35μF, the resistance is R = 28kn, and the…

A:

Q: The terminal voltage of a 3-φ generator is 19053 V, line-to-line. The load draws a current of 3150…

A:

Q: Q1/a: theirs clear deferent between linear reference and sawtooth more harmonics less harmonics…

A: 1) a :  Sawtooth waveform is not symmetrical about real axis so it contains all harmonics. i.e it…

Q: If feedback resistor Rf = 15k and input resistor R₁ = 5k. Then, The voltage gain of the…

A:

Q: 20. What are the currents flowing through the 2-2 resistors (Use Kirchhoff's rules) V Allt 252 380…

A: Given,

Q: 2 The total charge entering a terminal is given by q=10(1-e') mC. The current at t = 1.609 sec is…

A: Given, Total charge entering a terminal q=101-e-t mC Time, t=1.609 s

Q: Consider the RLC circuit in Figure 2. Given R = 2.2 , L = 1 H, and C = 0.25 F. (i) Obtain the…

A:

Q: Construct a signal flow graph from the following equations. Obtain overall TF using Mason's gain…

A: The overall transfer function can be calculated by using mason's gain formula.

Q: C₁ 1 μF www www R₁ 22 ΚΩ R₂ 4.7 ΚΩ Vcc +15 V Rc 2.2 ΚΩ C₂ 1 MF BDC = 90 Вас = 100 RE 1.0 ΚΩ Figure 1…

A:

Q: 1. Determine the following for the network shown below: *Use Mathematical Approach a. ID b. VGS C.…

A: We need to find out the current and voltage for given circuit

Q: What is the steady-state error to a unit-step input R(s) R(s) + 6 C(s) s+3 Select one: O a. ess =…

A: Given, The system is Unit step input, Rs=1s

Q: Q3 / For the circuit shown in figure below, find the current flows through 10 22 and 6 resistors,…

A:

Q: A 2500KVA, 6,600 volts, three-phase wye connected alternator has an effective resistance of 2 ohms…

A: Given data is shown below. V=2300S=2500kVIa=2500×1032300Ia=1.0869×103Ra=0.1 ohm/phaseXs=1.5…

Q: Two wye connected alternators A and B are running in parallel to supply the following loads at 6.6…

A: Line and phase current in star connection remain same  Line voltage is 1.732 times more than phase…

Q: It is frequently referred to as deep-space noise since it consists of electrical impulses that…

A: Noise- A loud or disruptive to hearing, Unwanted sound produced by machines, horns of vehicles, etc.…

Q: Design Buffer circuit using op-Amp AV=1?

A: In the buffer amplifier circuit the output voltage follow the input voltage and the total gain is 1.

Q: Infinite uniform line charges of 5 nC/m lie along the (positive and negative) x and y axes in free…

A:

Q: Sketch and explain the output wave shape for the circuit. The generator signal is a sine wave with a…

A: In this question,  We need to Sketch and explain the output wave shape for the circuit.  Assume…

Q: A R G₁ G₂ G3 G5 G4 C

A:

Q: Find Ts and Tr of the transfer function G(s)= 49 / (S+49)

A:

Q: Q1. The circuit of Figure 1 has a source of 240V and source, line and load impedances according to…

A:

Q: Ip 15 V O iX Si Si 1 $221 2.2 k o +5 V 10₂ -oV₂

A:

Q: Calculate the full-load power factor and torque developed in N-m, of a single phase motor with the…

A:

Q: 7.15 The switch in Fig. P7.15 has been closed for a long time before opening at t = 0. Find t a)…

A: Given  An electrical circuit and we need to do steady state and transient analysis of the circuit…

Q: List various differences between Latches and Flip-flops. Give example of digital system and explain…

A: Latches:- The latch is a electronics device which has two inputs and one output. One input is known…

Q: (b) A 30000 kVA, 13.8 kV generator with X = 18% is connected to a bus which supplies two identical…

A: Generator data Sb= 30000 kVA Vb=13.8 kV Xd'' =18 %   Motor data Vb= 7 kV Sb=6000 kVA Xd'' =25 %

Q: Question 2 Please check the following sentence is true/false. 'When the number of pipeline stages…

A: Pipelining is defined as “A Pipelining is a series of stages, where some work is done at each stage…

Q: 4. For the circuit shown in the figure below uses a transformer of 230V/12V-0-12V and all diodes are…

A: centre tapped Full bridge rectifier  A transformer is used with centre tapped winding Two diodes…

Q: 3- The following rod rotates about AB axis. If the angular velocity and acceleration are…

A: 3. The given circuit diagram is shown below: It is given that: ω=6 rad/sα=-25 rad/s2

Q: Using Norton's theorem, find the current pass through 302 resistor shown below. 20 www P 6 A 20…

A:

Q: 1 A circuit element draws 10A when connected to a 240V line. The time (in sec) required to consume…

A: Given: Current drawn by circuit element, I=10 A Supply, VS=240 V Energy consumed, E=12 kJ