Imagine the water level in the tank as shown in the Figure rises at a rate of0.004579 ft³/sec. then find:i) The volume flowrate of water leaving the tank (Q3) in ft³/s from pipe 3.ii) The average velocity of water leaving the tank (V3) in ft/s from pipe 3.Pipe 1:Qi=0.0109 ft²/sPipe 2:Q₂ = 0.025 ft³/sPipe 3:dy = 1.5 in.V₁ = ?!Q₁ =?

Answered: Image /qna-images/answer/f3f156ab-b839-4934-b9de-031900b3bdbe.jpg

Imagine the water level in the tank as shown in the Figure rises at a rate of 0.004579 ft³/sec. then find: i) The volume flowrate of water leaving the tank (Q3) in ft3/s from pipe 3. ii) The average velocity of water leaving the tank (V3) in ft/s from pipe 3. Pipe 1: Qi-0.0109 ft³/s Pipe 2: Q₂ = 0.025 ft³/s Pipe 3: dy = 1.5 in. Q₁ =?

Imagine the water level in the tank as shown in the Figure rises at a rate of 0.004579 ft³/sec. then find: i) The volume flowrate of water leaving the tank (Q3) in ft3/s from pipe 3. ii) The average velocity of water leaving the tank (V3) in ft/s from pipe 3. Pipe 1: Qi-0.0109 ft³/s Pipe 2: Q₂ = 0.025 ft³/s Pipe 3: dy = 1.5 in. Q₁ =?

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

3). in the figure below. Consider the acceleration due to gravity as g=32.2 ft/s², specific weight of water as yw-Pwg=62.4 lb/ft³ and gasoline as ygasoline=Pgasolineg=42.5 lb/ft³. What pressure, pi, is needed to produce a flowrate of 0.09 ft³/s from the tank shown Air Gasoline 2.0 ft Salt water 3.6 ft SG = 1.1 0.06-ft diameter -
A certain liquid (SG = 12) flows through a 401-mm diameter pipe at a velocity of 6.5 m/s. Find the mass flow rate in kg/s. Round off to the nearest whole number.
Water flows through a 125 mm diameter pipe at a velocity of 7.5 m/sec. Find the mass flow rate in kg/sec. NOTE: Do not write any unit to your answer, put your answer in a numerical form only and use up to 3 decimal places. ASAP PLS
Ex. 1.13] A pump draws water from reservoir A and lifts it to reservoir B as shown in the figure. The loss of head from A to 1 is three times the velocity head in the 15.24-cm pipe and loss of head from 2 to B is 20 times the velocity head in the 101.6-mm pipe. The pump discharge rate is 40 Ips. Determine the following: d) Pressure head at point 1 e) Pressure head at point 2 Given: Pump system shown Q = 40 Ips HA = 3 29 Zg = 36 m H = 20 29 %3D ZA = 6 m D; = 15.24 cm Dz = 101.6 mm Required: Pump We a) TDH b) Pump WP c) BP if pump efficiency is 78% d) Pressure head at point 1 e) Pressure head at point 2
Water enters a fountain through a pipe with a cross-sectional area A1 at a flow rate Q. The pressure in the inlet pipe is p1. The water then leaves through a nozzle with a cross sectional area A2 and at an angle 8, as shown in Figure Q5. Both the inlet and the nozzle are at a height h2, and the jet reaches a maximum height 13. You may assume that viscosity is negligible. a) Find the horizontal force on the block b) What is the horizontal-component (u2), vertical component (v2) and magnitude (V2) of the velocity of the jet as it leaves the nozzle? c) What is the maximum height of the jet? You may assume that the horizontal component of velocity is the same at every point in the jet. P₁ A₁ A₂. To h₂ h3 Figure Q5: Jet emitting from a fountain.
b) Water flows through a pipe as shown in Figure 1 at the rate of 80 L/s. If the pressure at Point 1 is 180 kPa; r2 = 8 cm 2 m ņ = 16 cm Figure 1 i. What is the velocity of water at Point 1? ii. What is the velocity of water at Point 2? iii. Calculate the pressure at Point 2.
1. A 451 mm x 491 mm air compressor has a piston displacement of 0.9 m^3/s. Determine the operating speed of the compressor (rpm) Answer in whole number 2. The initial condition of air in an air compressor is 99 kPa and 30 deg. C and discharges at 438 kPa. The bore and stroke are 374 mm and 395 mm, respectively. The percent clearance of 11 % running at 356 rpm. Find the volume of air at suction in m^3/s Answer in one decimal places 3. A single stage air compressor hadles 0.454 m^3/sec of atmospheric pressure, 27 deg. C air, and delivers it to a receiver at 652.75kPa. Compression is isothermal. Determine the work in kW 4. An air compressor is to compress 8.878 m^3/min from 98.881 kPa to 988.493 kPa. Assuming condition is ideal, and n=1.3 What will be the work in kW due to 2 staging Answer in whole number
2. The initial condition of air in an air compressor is 99 kPa and 30 deg. C and discharges at 438 kPa. The bore and stroke are 374 mm and 395 mm, respectively. The percent clearance of 11 % running at 356 rpm. Find the volume of air at suction in m^3/s ANswer in one decimal places
A fluid is flowing between two parallel plates as shown below. These two plates are moving with same velocity, V0, but in opposite directions. The fluid flow is due to gravitation and movement of plates.i) Find the shear stress and velocity distribution.ii) Find Vav
1. Water flows steadily through a smooth, circular, horizontal pipe. The discharge rate is 1.5 ft3/s and the pipe diameter is 6 in. Find the difference in the pressure between two points 400 f t apart if the water temperature is 60°F. 2. A 2000-gallon swimming pool is to be filled with a 0.75 in. diameter garden hose. If the supply pressure is 60 psig, find the time required to fill the pool. The hose is 100 f t long, with a friction factor equal to 0.02.
Problem-4: The characteristics for a pump are given in the table below. The pump is required to left water against static head Az = EN" m. The pipe arrangement has a total length L the pump discharge, head, efficiency and power for the given pipe system. 200, d = 0.1 m and f= 0.016. Find %3D Q (L/s) 10 20 30 35 42 50 Hp (m) efficiency % 210 201 180 150 129 93 48 30 58 80 85 86 74 EN=62 Hp = Az + h, = Az + 12.1 d P = 757
Direction: Solve the following problems. Please box your final answer and write your solution clearly. A pump discharges a liquid into a drum at the rate of 0.032 m3/s. The drum, 1.5m in diameter and 4.2m in length, can hold 3000kg of the liquid. Find the density of the liquid and the mass flow rate of the liquid handled by the pump. A cargo ship has tanks for carrying fuel oil. The oil is measured in barrels, while the tank dimensions are in meters, 1m x 5m x 15m. How many barrels does the tank hold? How many gallons? (42 gal = 1 barrel)