Answered: If we use 5000 µF, we can get a very…

Science

Physics

If we use 5000 µF, we can get a very low ripple voltage. But this is so bad and this a disadvantage, why?

College Physics

1st Edition

ISBN:9781938168000

Author:Paul Peter Urone, Roger Hinrichs

Publisher:Paul Peter Urone, Roger Hinrichs

Chapter23: Electromagnetic Induction, Ac Circuits, And Electrical Technologies

Section: Chapter Questions

Problem 89PE: The capacitor in Figure 23.55(b) will filler high—frequency signals by shorting them to...

See similar textbooks

Related questions

Q: Calculate the Hall voltage when B=0.5 Wb/m ^2 , Ix=2 mA , d=O.2 cm * . and ni=10^2/m ^3

Q: Determine the relationship between the phase angle of the current and voltage and the average power,…

A: The term power factor can be defined as the actual electric power dissipated by an AC circuit to the…

Q: The AM band extends from approximately 500 kHz to 1,600 kHz. If a 1.5-?H inductor is used in a…

A: Given: AM band ranges between 500 Hz - 1600 Hz That is, fmin=500 kHz=500×10-3 Hz & fmax=1600…

Q: High-end headphones (such as the likes of Audeze and HiFiMan) have a such high impedance compared to…

A: Given data: Diameter of headphone is, D=40 mm=40×10-3 m. Thickness of headphone is, T=2 mm=2×10-3 m.…

Q: What is the reactance of a 1.00-nF capacitor at (a) 60.0 Hz, 24 (b) 6.00 kHz, and (c) 6.00 MHz?

A: The quantity 1ωC is the effective AC resistance or the capacitive reactance of the capacitor and is…

Q: Determine the rms voltage of the given waveform V2 40 V wt 80° 260 440° (b) 20V 23.1V O 28.3V O…

Q: Two circuits hove two copper rosistors in thom The rosistor in the first circuit has a longth La…

A: Given For resistor 1, Length L, cross section Area A, current I = 6.0 m amp For resistor 2,…

Q: high‑voltage discharge tube is often used to study atomic spectra. The tubes require a large voltage…

A: Given Transformer is connected to a line Voltage of 120 V and designed to provide 3100 V rms to…

Q: A 10 μF capacitor is connected to a 1000 Hz oscillator with a peak emf of 5.0 V. What is the peak…

Q: Calculate the RMS value of the voltage waveform below

Q: 1. A sine waveform is shown in Figure A1, Voltage, mV Time.ms Figure Al Determine the following, 4.…

A: Average voltage is given by Vavg= (2/π)Vo Here Vo is the peak voltage And Vo= 3 mV Vavg= (2/π)(3×…

Q: When EXOR gate is applied to the given waveforms (A, B), which one will be represent the waveform of…

Q: What is the impedance of a one microfarad capacitor at 60 Hertz?

Q: A diode converts ac to pulsed dc. What electrical device smoothes the pulsed dc to smoother dc?

Q: _1. Both AC and Dc described the flow of current in a circuit. 2. Electric charges in both AC and DC…

A: Electric current flows in two ways as an alternating current (AC) or direct current (DC). In…

Q: What is the relationship between frequency and angular frequency?

Q: One way to compute the resistance for a resistor is to decode the color values from it, what is more…

A: The another way to calculate the resistance of a conductor is given by the formula, R = ρL/A ; Where…

Q: What is the quiescent output voltage of the amplifier shown below? Give your answer in Volts to 2…

A: The dc voltage at an output terminal with reference to a common terminal, normally ground, when no…

Q: High-end headphones (such as the likes of Audeze and HiFiMan) have a such high impedance compared to…

Q: Given the Followine Circuit, Detormine: Ig= Ry=? Kg= 90052 RT= RI= %3D %3D Rg=5052 Ry=? mu V, =

Q: 2. Boolean expression Use only NAND gates to design a logic circuit to simulate the Boolean…

A: Answer

Q: The peak to peak distance of a sinusoidal waveform displayed on a C.R.O. screen is 10 cm and the…

A: potential and field (E) is a differential: electric field is the gradient of potential (V) in the x…

Q: When electricity and magnetism are coupled together propagating in space, we call that.......?…

A: a) When electricity and magnetism are coupled together propagating in space, to form electromagnetic…

Q: 1) The electrons are tightly bound on the last orbit in these materials. A. Inductors B.…

A: 1) (c) insulators Reason-The outermost electrons are tightly bound that there are no free…

Q: 2. C, = 1.5 F a) Find the initial capacitance of C if the dielectric is a paper. b.) what will be…

Q: why does a capacitor block DC but pass AC?

A: The frequency of the direct current is zero.

Q: L + R dq + ¢q = V(t). Solve the b우 dt2 differential equation for q

A: First have to break the equation into two parts 1.complementary solution and 2. Particular intergral…

Q: Select the correct answer for each of the following items: 1. The clipping circuit is used for: (a)…

A: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question and…

Q: The waveform displayed on an oscilloscope is as shown in Figure The time/cm' switch is set to 05…

A: Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for…

Q: 7. The nominal resistance value of the a 4-band resistor is 470 kQ ± 5%. a. What is the resistance…

Q: Q1) If V1 (RMS) = 110 V (60 HZ) and transformer conversion ratio is 10: 1 according to the half-wave…

A: Hi please find solution to your problem

Q: 3) A square loop circuit (with a 30.0 V battery, resistance of 6.00 ohms and side length of 2.00 m)…

A: Given data: e.m.f of the battery, ε=30.0 V

Q: A radio broadcast antenna is located at the top of a steep tall mountain. The antenna is…

Q: What property of a diode enables it to convert ac to pulsed dc?

A: The diode only conducts in the forward biased condition; thus, one diode will only pass the positive…

Q: A digital communication system sends two messages, M=0 and M=1. A receiver observes a voltage signal…

Q: Q5)A half-wave rectifier has an input voltage of 240 V r.m.s. If the step-down transformer has a…

A: Given data, Turns ratio = 8:1 RMS value of input voltage = 240 volts

Q: What is rms voltage?

A: In the field of electricity: We define the term of currents known as the Alternating-current…

Q: А. | S N S В. N С. | S N D. S Unmagnetized ОА О в Ос OD ОЕ E.

A: Magnetic monopole doesn't exist. That means a magnet contains both north and south pole. Even if the…

Q: HOW DO YOU IDENTIFY RESISTORS THROUGH COLOR CODES?

A: As the resistor is a two-terminal device and is an important component for electronic devices. it is…

Q: Why, in practice, a fully charged capacitor and inductor will dissipate its energy?

A: In this question we have to answer why in a fully charged capacitor and inductor energy is…

Q: For a practical (Vdiode = 0.7 V), simple half wave rectifier (without a transformer), the Vav for Vp…

A: Average output voltage

Question

> If we use 5000 µF, we can get a very low ripple voltage.
But this is so bad and this a disadvantage, why?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

- If we use 5000 µF, we can get a very low ripple voltage. But this is so bad and this a disadvantage, why? What happens if we use a very small resistance (few Ohms) or big resistance (100 kohms) ?
Assume that V is a function of y and at y =2, V =5 volt and at y 4, V = 10 volt. a) Find V, E, JEl and draw these with respect to y-axis. b) Now if p 30uc and e, = 3. Find V, E, E and draw these with respect to y-axis.
capacitor has two plates. The distance between them is 3mm. The relative permittivity of insulator is 4; insert a second layer 5mm thickness between the two plates the capacitance was one-third of initial value. What is relative permittivity of insert layer?
. Calculate current across the capacitor shown in Fig. P8.6 if the voltage input is v1(t)=30 cos (320t-50°) V . v(t) i(t) Figure P8.6 For a current i(t) = C cos(wt+P), enter the value of the phase angle (P). (be sure that your answer is between -180deg to 180deg.) Notes on entering solution: • Enter your solution in degrees Have your current in cosine format . Do not include units in your answer ex. 5° is entered as 5 C = 1 µF
%3D %3D 11.2 For each set of voltages, state whether or not the voltages form a balanced three-phase set. If the TM set is balanced, state whether the phase sequence is positive or negative. If the set is not balanced, explain why. 180cos 377t V, 180 cos(377t- 120°) V, 180 cos(377t-240°) V. 180 sin 377t V, 180 sin(377t + 120°) V, 180 sin(377t- 120°) V. ILLE 400 sin(377r + 210°) V, 400cos(377t - 30°) V. LLE 10002 01 =201 cos(2000r + 150°) V, 200 cos(2000t + 270°) V. 208 cos(630f + 42°) V, 208cos(630r -78°) V, 208cos(630t 201") V. 240 cos 377t V, 3 240 cos(377t 120°) V, ve3D240 cos(397t + 120°) V.
واجب Solution Related Problem VAVG = P TT 50 V TT = 15.9 V Notice that VAVG is 31.8% of Vp- Determine the average value of the half-wave voltage if its peak amplitude is 12 V.
) Series Circuit R, 252 (2) = 42 80V V, = 20 V I, = 10 A %3D R V2 IL
When in forward biased, what have you noticed when you change the source voltage from 0V to +20V? When in reverse biased, what have you noticed when changing the source voltage from 0 V to -15V?
Is a JFETs tranconductance constant at all points?
Discuss the advantages of using tetrapolar bioimpedance measurements over the bipolar measurements.
C2 (ii). A sinusoidal waveform is displayed on a C.R.O. screen, the time/cm switch is on 20 us/cm and the volt/cm switch is on 50 V/cm. The width of one complete cycle is 3.4 cm and the peak to peak distance is 5.6 cm. Determine the following: The frequency is The magnitude of the sine voltage is The amplitude is
#1 - A capacitor has a peak current of 330 μA when the peak voltage at 250 kHz is 2.2 V. a) What is the capacitance? b) If the peak voltage is held constant, what is the peak current at 500 kHz?