I 2.5K 2K Vab Vs-10v 3K 1K 4K Figure 1 By applying Delta to why analysis, compute and measure the values of I and Vab. Fill up the table given below. Attach your calculations in PDF format. Vab P=IV, Measured

Q: H.W.3: Find i and v, in the circuit of Fig. Let i(0) = 5 A. University of Diyala Engineering College…

A:

Q: 120 V For the circuit shown above, I(0) is equal to: 20 52 6002 t=0K 30 (2 1 µF Vc 2 mH

A: In transient analysis the inductor get short circuited at steady state and capacitor get open…

Q: Detormine if the Pollowing systems are memoryless, Time- Invariant, Linear, Causal, and stable ノ |-…

A: There are multiple sub parts for question and for each subpart there are again multiple sub parts.…

Q: 1) Compute v, (t) in the circuit using nodal analysis. 1H 0.25 F 0.5 i, 16 sin (41 – 10°) V (

A:

Q: Given an electrical circuit shown in Figure 1. IH 32. v(t) vz(t) Figure 1 Obtain the transfer…

A: This question belongs to control system . It is based on the concept of time domain conversion into…

Q: (1) Determine y(n) of the system block diagram shown below: x(n) + y(n) + 21 5

A: Z-transform- Three-phase transformer work on the principle of Faraday's law of electromagnetic…

Q: For the given circuit calculate IB, Ic, VCE,VB,Vc,VBC. Assume VBE=0.7V, B= 50, RB =190K2 , Rc=1.5KN…

A: TRANSISTOR BIASING: The main and the most important function of a transistor is to do amplification.…

Q: V th max 4.2 th According to maximum power transfer theorem maximum power is equal to Pm Select one:…

A:

Q: Irrigation is comes under Municipal load Select one: O True False

A: To determine irrigation comes under municipal load or not.

Q: 1+K 1.332/(S^3+4S^2+5S+2)=0 (i). Identify the characteristic equation.

A: The equation is given as:

Q: Use the equation u = 1/2 *ε0*E2 , to determine ε0 using the slope, compare this value of ε0 with ε0…

A: Given data U = -1 * 10-3  J E2 = -0.225 (V/m)2 Theortical value of εo = 8.85 * 10-12 F/m

Q: Problem 42 3.42 Using Fig. 3.88, design a problem to help students better understand mesh analysis…

A:

Q: If the power system has 'n' number of generators, then the size of the B- coefficient matrix is…

A: The power system has n number of generator then B coefficient matrix size?

Q: Use Thevenin analysis to find the value of v,. 20 Ω 10 Ω + 40 V 20 Q (4 1 10 Ω Vo

A: Find vo? Using thevenin equivalent

Q: Find i, (t) if v, (t) = 15 sin 40004 V. Suppose that i, (t) Io cos(wt +o), where-360 <OS 360…

A: In this question,  Find the current io (t)   if voltage v(t) = 15sin(4000t) V We know I= V/Z

Q: Find v.(t) using nodal analysis. 10 2 10 2 5 sin (1000 t) ( ↑ 302 50 µF 10 mH

A: The solution is given below

Q: 1. Find Ix and Validate Reciprocity Theorem 40 I, 20 20<90°V (+ j10 40

A:

Q: bläi 10 Find T parameters for the circuit 30Ω 40 Ω 60 Ω 20 Ω 50 Ω 20 Ω

A:

Q: ing mesh analysis, find v. Vo 400 V (+ 10 Ω 10 Ω 10 Ω (+ 100 V 10 Ω 10 A

A:

Q: ww 751 01 U10+ 40 kQ 731 02 351 02 Z UA. A 108 8.00 Vo Solve for i, -

A: given here a op amp circuit and asked to find the i0 in the circuit. here nothing is mentioned about…

Q: SA For the given circait, show that the power dissipated is 120 200 equal to the power supplied. 40…

A:

Q: Let i, 10u(-1) - 20u(t) A in Fig. 2. Find (a) iL(0) シすく) (b) vc(0) (c) VR(0) (d) VL(0") (e) iL(0)…

A: As per our company guidelines we are supposed to answer only first 3 subpart kindly repost other…

Q: MULTIPLE CHOICE. Choose the one alternative that best completes the statement or answers the…

A: Given circuit is, XL=j200ΩXC=-j100Ω At resonance circuit,   XL+XC=0ωL=1ωC But here, ωL&gt;1ωC

Q: Question 2 For which range of K the system with the following characteristic equation is stable:…

A:

Q: Using Y-A or A-Y transformations, determine Rab 40 80 20 08. ww

A: The ∆-Υ and Υ-∆ transformation can be done as:

Q: Jse mesh analysis to find vo(t) if iş = 10cost(30t + 20°)A 0.1% | 20 Ω 40 Ω 50 με 100 mH

A:

Q: Given the system in the fgure below, calculate the following properties of its root locus plot Ku+3)…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: SEcIon A T ) Question 1: Hj w) vt) IH( AH(w) 4 For the system given above determine the output, yt)…

A:

Q: ᴛʜᴇ ᴘᴏᴡᴇʀ ɪɴᴘᴜᴛ ᴛᴏ ᴀ 500 ᴠ, 50 ʜᴢ, 6 ᴘᴏʟᴇ 3 ᴘʜᴀꜱᴇ ꜱQᴜɪʀʀᴇʟ ᴄᴀɢᴇ ɪɴᴅᴜᴄᴛɪᴏɴ ᴍᴏᴛᴏʀ ʀᴜɴɴɪɴɢ ᴀᴛ 975 ʀᴘᴍ…

A: Slip = synchronous speed- rotor speed)/ synchonous speed.  Rotor  cupper losses = slip× rotor input.…

Q: 1 Given Vi=4mV, determine the Zi, Zo, Vo, and Av. (Non-anonymous question) V₂0H Ζ΄ 1.5 ΚΩ Z; +15 V…

A: The given circuit diagram is shown below: It is given that: IDSS=8 mA=8×10-3 AVP=-2.8 Vrd=40…

Q: Consider the system described by:- x(k)-0.6y(k-1)-0.81y(k-2)+0.67y(k-3)-0.12y(k-4)=x(k), Where x(k)…

A: Given equation is…

Q: v(r), V (), A 20 40 9. 18 7 (ms) -40 18 7(ms)

A:

Q: IV) Find the Q point of JFET circuit ( graphically ). Jpss=5 mA VDD +6 V Rp 820 2 Ra 10 MN 330 0…

A: JFET:  It is known as Junction Field Effect Transistor. In the above figure, Self biased circuit is…

Q: A I 2.5K 2K Vab Vs-10v 3K 1K 4K

A: Given data: Vs=10 V Solution: Apply a delta-to-wye transformation to the upper triangle,…

Q: Q2: Consider the following circuit, determine Zt, Qp , BW ? * R 20 2 I = 2 mA 100 nF XL0.3 mH 1 Add…

A: The circuit this is excited the use of alternating supply is referred to as an AC Circuit. The…

Q: Q2: Consider the following circuit, determine Zt, Qp , BW ? * R 20 Ω I = 2 mA ( 100 nF XL0.3 mH 1,…

A: The circuit this is excited the use of alternating supply is referred to as an AC Circuit. The…

Q: Find i and V. in the circuit of Fig. 10 Ω 24 2 50Ω 3 25 2 15 V 202 30 2 60 N 302

A:

Q: Given the block diagram below, determine the system function H(z). x[n] + y[n] a. 1+0.25z2-2 b.…

A: for calculate trasfer funtion H(z)= Y(z)/X(z) by using masson gain formula  trasfer funtion…

Q: 500 N 1000 N ig 160 nF 100 mH R = 500 N, R2 = 1000 N, L = 100 mH,C = 160 nF,i,(t) = 4 cos 5000t mA

A: Given :   For the above question given electrical circuit, we have converted into the Laplace…

Q: ix 10 2 8 A VB 82 10 VA Vc ↑ )1 A Figure 1 cuit shown, write out the equations needed to solve for…

A:

Q: 750 500 600 Use Delta-Wye transformation to find the total resistance 800 500 400 620 of the given…

A: In this question,  We need to determine the equivalent resistance across the given terminals.  If…

Q: Question 2: If x[n] = 8[n], analyze the system and find the output y[n] for the system given below:…

A:

Q: a) i(t) = 10cos(10t +) b) i(t) = 10sin(20t – -) c) i(t) = 20sin(314t +7)

A:

Q: Apply nodal analysis to obtain vc. The voltage source has a value of V = 10Cos (1000t) v 20 2 50 μF…

A:

Q: 20/0º V ji N Vị V2 50 330 1Ω. -j1 N= 2/0° A

A: The solution is given below

Q: Figure Q4(b) 150 130 120 100 90 so 70 60 40 30 20 Sht field cament, A 1000 2000 3000 5000 7000…

A: B(i) To calculate voltage range B(ii) To calculate field current

Q: Use mesh analysis to obtain i, in the circuit below 100V 80 120 13 90 11 60 150V 150 12 50A

A: NOTE: We’ll answer the first question since the exact one wasn’t specified. Please submit a new…

Q: constants of the system using slope intercept method. 2 4 6 8 10 12 14 16 C(t) .375 .625 .75 .85…

A: Time constant is the time taken by output to each 63.4% of final output.

Norton Theorem

In the current circuit law, the Norton theorem (also known as the Mayer-Norton theorem) is a simplification that can be applied to networks generated by a constant line of opposition, power sources, and current assets. In two network terminals, it can be switched on with a current supply and single resistor respectively.