Given data :Water content%3D0.02Weight of water%-D40 gFind weight of dry soil

This question is related to the Soil Properties from Geotechnical Engineering.

Answered: Given data : Water content%3D0.02…

Engineering

Civil Engineering

Given data : Water content%3D0.02 Weight of water340 g Find weight of dry soil

Fundamentals of Geotechnical Engineering (MindTap Course List)

5th Edition

ISBN:9781305635180

Author:Braja M. Das, Nagaratnam Sivakugan

Publisher:Braja M. Das, Nagaratnam Sivakugan

Chapter3: Weight-volume Relationships And Plasticity

Section: Chapter Questions

Problem 3.11P

See similar textbooks

Related questions

Q: Determine the force in members KJ, JN,ND and CD. K 10 ft

A: Given that - To find - Determine the forces in the member KJ, JN , ND and CD

Q: Tabulate the result of your design. In 2 columns, list the tension members on the 1st column and the...

Q: 300 mm P = 300 kN L = 4 m f'c = 24 MPa Compute the stress at the top and bottom fibers of the prestr...

A: Given : P = 300 kN, L = 3 m, fc = 24 MPa Service load = 20 kN/m

Q: 225 mm P1=8 P2=10 MJ=15 q1-18 dib 2(m) 1(m) 4.50(m) 1.50(m) 20/mm 66 225mm

Q: A steel wire having a radius of 2.0 mm, carrying a load of 4kg, is hanging from a ceiling. Given tha...

A: Given data, A steel wire, having Radius= 2mm = 2×10^-3 m Load =mass = 4kg g= 9.8m/s² Tensile stress...

Q: A steel tube with the croSs section shown carries a 50-kip in. in. torque. Determine (a) the maximum...

Q: Propose THREE (3) strategies for the control of volatile organic compounds (VOCS) in indoor air.

A: Volatile organic compounds (VOCs) are the chemicals which are found in various products which are us...

Q: 18m A 9m C 7.50m VP V166N Compute for P If CABLE BC is Horizon tal w9 B

Q: In an open channel, velocity of flow was found to be 1.23 m/s. If average bed shear stress is 1 N/m?...

Q: A 100 m tape weighing 3 kg was standardized and found to be 0.02 m short at temperature of 10degC an...

Q: Determine the axial stress (kPa) in the truss member a shown in Figure 4, if the truss structure mat...

Q: A rectangular reinforced concrete beam has a length of 7.5 – 10.5 m. It is supported with a hinged a...

Q: 225 P,- 8 P,- 10 9- 18 2 (m) 1 (m) 4.50 (m) 1.50 (m)

Q: A 4.0 m bar weighing 100 N ia resting on a smooth floor and against a smooth wall at points as shown...

Q: A footing 2.5 m wide x 2.5 m long and 0.45 m thick carries a square column 0.50 m x 0.50 m on its ce...

A: ANSWE(1). Ultimate moment = 360KN-m (2). Critical Wide beam shear stress = 0.475 mpa (3). Criti...

Q: Given data: Work done=600 J Force=30 N Determine displacement

A: This question is related with mechanics . In this question we are provided with value of work done a...

Q: A rectangular open channel, with a constant discharge of 32m3/s, has a smooth expansion from (1) to ...

A: open channel flow : A sort of liquid flow within a conduit or in a channel with a free surface, know...

Q: Water flows at a rate of 6 cubic meter per second in a 2 m diameter pipe. The depth of the its water...

A: This question is related to the Fluid mechanics from Civil Engineering. In this question we calculat...

Q: What is an Ecosystem? Civil Engineering please explain very well thank you very much type a soft no...

A: An ecosystem is a cycle of life where all the organisms (animal and plants) along with environmental...

Q: Given data: Kinetic energy=200 J Mass=10 kg Determine velocity

A: The answer is found to be Velocity=6.324 m/s For explanation please refer the attached solution, tha...

Q: 225 P,- 8 P,- 10 9- 18 2 (m) | 1 (m) 4.50 (m) 1.50 (m)

Q: (Use The Figure (10.20) to find the solution of this question) Two embankments loads on silty clay s...

A: Given, γleft = 11 kN/m3 γright = 13 kN/m3

Q: Situation 1| An overhang beam is loaded as shown below. The beam cross-section was built by attachin...

A: As per bartleby's guidelines we are supposed to answer only first three questions. Kindly repost oth...

Q: 6 kN/m A B 3 m 3 m

Q: Consider the following data for a plain cement concrete pavement: Width of expansion joint gap = 2.5...

Q: parabolic sag curve has tangent grades of –1.2% and +0.60%. The total allowable change of grades per...

Q: The percentage composition of Mahatma Gandhi Road (single lane) is 4 Wheeler : 80 10 Wheeler 18 6 Wh...

A: Given data, maximum free speed of traffic = 50 kmph To find Qmax

Q: Determine the stadia intercept and stadia interval factor Assume C = 0

A: Given data, C = 0

Q: MOMENT DISTRIBUTION METHOD for the

Q: car traveling at 50 mph observed a block is 80 m ahead. The driver immediately applies the brake and...

Q: LINE BEARING DISTANCE АВ S15°36'W 24.22 ВС S69°11E 15.92 CD N57°58'E DA S80°43'W

A: given - data of a closed traverse to find - distance DA

Q: 225 P,- 8 P- 10 9.- 18 Ra H 2 (m) 1 (m) 4.50 (m) 1.50 (m)

Q: A tapering RC beam of span 3 m tapers from 300 mm (effective depth) at critical section to 200 mm (e...

Q: 100 Mohr's circle for a state of stress defined by 30 30 MPa is a -20 circle with

A: Given data, For mohr's circle a state of stress is defined by To find center and radius of mohr's c...

Q: The interior column of an industrial building supports a roof dead load of 55 psf and a snow load of...

A: Given Data -

Q: Determine the force in members KJ, JN,ND and C D.

A: Given data-

Q: An overhang beam is loaded as shown below. The beam cross-section was built by attaching two (2) cha...

A: Answer Based on the given data for the built up cross section we can draw the cross section as shown...

Q: Question 13 4 pts A tank is subjected to a pressure of 50 MPa. If the thickness of the tank is 10 mm...

Q: Determine the ff. 1. The value that most nearly gives the absolute value of Fixed-end moment (FEM)...

A: Disclaimer “Since you have posted a question with multiple sub-parts, we will solve the first three ...

Q: A horizontal curve on a two-lane highway (11ft lanes) has a central angle of 33 degrees and designed...

A: Given -

Q: Show complete solution Compute for the horizontal and vertical components of the structure shown

Q: Slope Deflection Method Instructions: Solve the following problems completely using Slope Deflection...

A: Slope deflection method: The slope deflection method, invented by George A. Maney in 1914, is a stru...

Q: Derive equations for shear force and bending moment for the simply supported beam with two overhangs...

A: Given : To find - Derive equations for shear force and bending moment for the simply supported bea...

Q: Determine the reaction at point A and the tension in cord AB. (Partial ans. TAB = 7000 lb) %3D 30° B...

A: Given -

Q: Compute the volume of cur material t

Q: Slope Deflection Method nstructions: Solve the following problems completely using Slope Deflection ...

Q: Given the technical description of a triangular lot. We are to cut a 190 000 m2 along the side BC st...

Q: An equal tangent vertical curve connects a 1% and 3% initial and final grade. Design speed is 70mi/h...

Q: Situation 11 An overhang beam is loaded as shown below. The beam cross-section was bult by attaching...

Concept explainers

Unit Conversion

Standard units are also called SI units. SI units are used for measuring a physical quantity satisfying certain conditions. There are two types of units: fundamental units and derived units. Fundamental units are physical quantities that are independent, that is, they do not depend on other quantities like mass, length, or time. There are plenty of quantities in our lives which need to be measured and compared. Measuring is the comparison of a particular physical quantity with its reference value. A unit is a measure of a fixed physical quantity. A physical quantity is the product of a unit and the numerical value we need to compare with.

Question

Given data :
Water content%3D0.02
Weight of water%-D40 g
Find weight of dry soil

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Classify the soil according to the soil classification system AASHTO: With the following data: Percentage passing: sieve No. 200 = 45% sieve No. 40 = 10% sieve No. 10 = 45% LP = 32 LL = 54
Homework:- Classify the following soil Using AASHTO System. Given: % passing No. 10 = 100; % passing No. 40 = 80; "% passing No.200 = 58 LL = 30; PI = 10.
Ql: 1-For the following data, calculate the total available water and the soil moisture deficit. Soil depth (em) WwP W 0 - 40 1.38 0.31 0.13 0.23 40 - 100 1.38 0.29 0.12 0.26
100g of moist soil hs a mass of 25 g wate, calculate water content?
Classify a soil with 30% clay, 15% silt, 32% sand, and 23% gravel. 100 90 10 80, 20 30 70, Clay 60 40 50 50 Sandy 40 Clay Sitty Clay 60 Silty Clay Loam SandyClay Loám 30 Çlay Loam 20, 70 80 Loam Sift Loam Sandy Loan bamy San 10 90 Šilty /San 100 90 80 70 60 50 40 30 20 10 100 Percentage by Weight Sand a. Silt Loam b. Sandy Clay Loam c. Sandy Loam O d. Clay Loam Percentage by Weight Silt Percentage by Weight Clay
determine the group symbol and index for soil a, b and c.
Q3// The field capacity of a certain soil 20% and the moisture content of the soil before irrigation is 10%. What is the approximate depth up to which the soil will be wetted with an application of 50 mm of water? [Take dry unit weight of soil as 15kN/m³ and unit weight of water as 10kN/m³]
150g sample of soil is 50% saturated. The RD is 2.70 and the water content is 20%. Calculate density, e and n
Item Test No. 1 2 3 What is moisture content on results below. Can No. Mass of can 13.1 13.3 13.2Mass of can + moist soil 28.2 27.1 31.4Mass of can + dry soil 24.5 23.1 25.7Moisture content Number of blows 30 22 16
Q3: Classify the following soil according to USCS. PI=25, L.L.= 40 Sieve No. Mass of soil retained on each sieve (g) 4 10 20 9.1 40 249.4 60 179.8 100 22.7 200 15.5 pan 23.5
Granulometry and Volumetry of soils In a partially saturated soil, the W is 66.67%, the Ss is 2.5, the Y sat is 1.45. If the volume of air is 8 cm3, determine the other quantities from the schematic, and calculate e, n, Gw%, Ym, Yd, Y sat, Y'
For a given soil, the following are given Gs 2.64, moist unit weight = 17 4 kN/m3, and moisture content = 11.51% Determine the weight of water, in kN, to be added per cubic meter of soil to reach 82% degree of saturation. Round off to three decimal places. h> A Moving to another question will save this response. Activte Ruestion 2 of 20 Go to Settings to activate Windows ASUS W R- T Y] G H. V.