Given a stable system 2-½- with H(z) =₂ = 2² + 2/2 - 1/1/20 3 16 Is this system causal? Explain

Q: You acquire a 20 Hz analog signal from sensor. Now you need to digitalize it to process it on an on-…

A: .                          SOLUTION  GIVEN             f = 20 Hz ( Analog Signal from Sensor) LET…

Q: Suppose that resistors R₁ and R2 are connected in parallel to give an equivalent resistor R. If…

A: Given: R1 = 300ΩR2 = 200ΩTolerence = 1% when its in Parallel  Find: Tolerence of R = ?

Q: 1. Find Vo and lo in the op amp circuit, 15 V 20 ΚΩ ΜΕ ?v= 10 ΚΩ w 6ΕΩ Μ 12V 8 ΚΩ 4ΚΩ

A:

Q: give the transfer function of this block diagram (STEP BY STEP)  and error ratio.

A: ecalculation of transfer function of this block diagram and error ratio.

Q: Which of the following represents the phasor form of a uniform plane wave travelling in Teflon (μ₁ =…

A:

Q: A DC motor is wired as shown in the figure. If the ammeter (DC) reads 30 A, determine and report the…

A: Given information about a DC motor, Field resistance Rf=200 Ω. Armature resistance Ra=0.2 Ω. Supply…

Q: Reduce the circuit depicted in Fig. 7.58 to as few components as possible.

A:

Q: Explain the relationship between Gain-to-receiver system’s noise temperature ratio (dB) and the…

A: The ratio of a receiver's input and output signal power, often represented in decibels. Gain in…

Q: Show all the steps A coil has an inductance of 40 mH and negligible resistance. Determine its…

A:

Q: A single room is supplied with a device which has 100volt circuit with a resistance of 25 ohms,…

A: Given data:-Supply voltage=V=100vResistance=25ΩFind:- Currnet=I=?

Q: MAXIMUM POWER TRANSFER 4. Find the RL value and the highest power through RL using the theorem…

A: We need to find out the thevenin equivalent circuit for given circuit across load resistor . By…

Q: Using the characteristics of Figure Q1, determine the following for an emitter-bias if a Q-point is…

A: Given that: Emitter bias configuration has a Q point at ICQ=4 mA and VCEQ=10 V. A graph is shown.…

Q: Using Figure 4, if a voltage source (Vs) of 10V is placed between the terminals where we determined…

A: Given, The figure of the circuit will be, Supply voltage, Vs=10 V

Q: 2 A generation station of 1 MW supplied أعلى قيمة هي رادم فيها واط ۱۰۰۰۰۰ dregion as follow: from…

A:

Q: • Find out currents through all the resistors and voltages all resistors Using mash analysis Vp=12v…

A:

Q: 10. Use mesh analysis to obtain lo. 492 σου (1) ΤΩ Μ Μ 2Ω Μ 5A 3Ω Μ ( 10 A Το ΖΩ Μ 192 Μ 4Ω (+1 ΤΩ…

A: We need to find out the current for given circuit by using of mesh analysis .

Q: Determine the quiescent levels of Ico and VCEQ for the network of Figure Q3. V₁0 H 10 μF 250 ΚΩ 10 V…

A:

Q: A communications link has a transmitter with a power of 8.7 W. The receiver needs a minimum received…

A: Given,  Power of the transmitter, PT=8.7 W Power received by the receiver, PR=5.3×10-3 W  link loss…

Q: Draw the current waveform in the circuit below if the peak Voltage at the anode is 12V sinusoidal.…

A: The PUT is a type of thyristor that is triggered into conduction is voltage at anode exceeds voltage…

Q: T 108 C₂ C300 C4 -ob C₁ po UOLUL Evaluate Cab, if C₁ = 8uF₁ C₂ = 8 uf C3=9uF, C4 = 9 uf

A:

Q: 2, Calculate Vx using transformation, 20L-90°v +1 52 M using Source 4 √130 не 32 J4 + 100 Ux

A:

Q: 12 3 24V 4 1 It 3012 12V ww 4e Lamp Gow 12V A 24V DC generater supplies power to the load resister…

A: Given, The circuit diagram is,

Q: 1) The canonica nonical form for a band-reject filter is 2 sa wa + Wo O S² + BS a) Show that a m Hi…

A:

Q: 4- What is an ingot, and when do we call it this term?

A:

Q: 2. A 3 phase, 4 wire feeder has 220V per phase supplies two single phase motors. Motor A is rated…

A: Given that, Rating of Motor A= 8HP, 0.8 pf lag, 90% efficiency. Rating of Motor B= 5 HP, 0.866 pf…

Q: 4. Find i(t), ic(t) & in(t) for t> 0. 수 -www- t-o 25 die ㅎㅎ ↑ SA 352 ti Hie 0.25A = 0.5F

A: In the given questions we need to calculate the current through inductor , capacitor and resistance…

Q: Represent in block diagram, the control system used in automatic control of speedof a wind turbine?

A: A number of computers that make up the wind turbine controller continuously monitor the health of…

Q: A coil has an inductance of 40 mH and negligible resistance. Determine its inductive reactance and…

A: It is given that: L=40 mHR=0 Ω∙V=240 Vf=50 Hz∙V=100 Vf=1 kHz

Q: The activation function in the example is assumed to be linear as f(x) = x. Repeat the example and…

A: We have to drawn update code functionthe given Activation Code function

Q: Find the transfer function, X2(s)/F(s) for the given translational mechanical system. (Non-anonymous…

A:

Q: R 202 10 122 202 19 20 Figure 4 10 192 19 20 20 10 10 10 ww 252 2102

A:

Q: For a given DC motor, the speed depends upon flux only applied voltage alone back emf back emf and…

A:

Q: Two balanced delta connected loads, with impedances 20cis(-60°) and 18cis45° respectively, are…

A:

Q: .. R(T) = 5 √ {4+ + 10 cos [1017+ + Tan" (413)] +10 CO8 [LOTT (t+7) + Tan`¹ (413)] 0.2 5.√ [4+10 cas…

A: Given,  We need to explain the equation part.

Q: Find VL(1) & VR(1) for t> 0. +31 €moxa Fr V₁ - 22 t=0 (1) ZA

A:

Q: R(T) = 1 To = 5 0.2 -1 dt = 0.2 √ {2+5 cos [10xt+tan~¹ (4/3)]} {2+5 cos [10z (t + 7) + tan`¹ (4/3)]}…

A:

Q: You are asked to design an active low pass filter with cutoff frequency 96 Hz. Given a capacitor of…

A:

Q: An ideal transformer has a turns ratio of 8:1, and the primary current is 3 A when supplied at 240…

A: Given, turn ratio of the transformer, a=1:8 primary current, I1=3 A primary voltage, V1=240 V

Q: 3. Find the power of the 50 V source. ΤΩ www 40V ΤΩ ΘΩ www 4/5Ω 50V www 10Ω 40V

A: Given:  Required: Find the power of the 50 Volts source.

Q: Are the connections shown in circuits a) and b) below valid? If not, explain your answer. Hint:…

A:

Q: A 6-pole, lap-wound, DC generator has a useful flux per pole of 0.08 Wb. The armature winding…

A:

Q: Consider İs fin R₁ fiz R2 V + iz R3 Derive the formula for i2, the current through R2, in terms of…

A: The circuit diagram is shown below,

Q: Problem I v(t) = i(t). i, v, p, w graphs for an inductor 10 H Determine the equations for current,…

A:

Q: 1₁ Determine theorem. тот 852 -√202 не Io using superposition ← J4n 6/0° A v9 voth 30/30°V

A:

Q: Q- There are two generators in a power system. No- load frequencies of the generators are 51.5 Hz…

A: Given- 2 generators, No load frequencies=51.5 Hz & 51 Hz, Droop constant=1 Hz/MW, Total load=2.5…

Q: e 100 sin 377t =

A: We need to find out time period for given signal .

Q: What will be the oscillator frequency of the Hartley oscillator if inductance L1, L2 are equal to…

A:

Q: What is the inverse Laplace transform of 4s/(s^2+16) - 36/(s^2+16)? 4s s²+16 36 s²+16

A: Given data, 4ss2+16-36s2+16

Q: Question 8 Find in the network in the figure below using superposition. USE 3 decimal places. 8 ΚΩ 2…

A: This is a problem of superstition theorem from circuits. The detailed solution is given in the next…

Q: 20. Using superposition, find Vo. 5Ω Μ Μ 4Ω V₂ (+1) 1Ω Μ 3 Ω 9V 3V

A:

Graph theory

It is that part of network analysis where the configuration is called graph or structure of the network system when all of the elements (e.g., R, L, and C) in a network system are substituted with lines having circles/rings or dots across both endpoints. The study of the solution of the networks and circuits with the help of graphs is known as graph theory. The objective is to know the mathematics behind the network analysis.