Answered: For the given circuit, the value of…

For the given circuit, the value of capacitor is in mF. So that the system will be critically damped is 40 92 ww 4 H voo i(t) C HA + Vo

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter24: Resistive-inductive-capacitive Parallel Circuits

Section: Chapter Questions

Problem 1RQ: An AC circuit contains a 24 resistor, a 15.9-mH inductor, and a 13.3F capacitor connected in...

See similar textbooks

Related questions

Q: Aif we have pil3, 30, 45) find the point pin Cartesian and Cylindrical systes.

Q: A three phase 50 Hz fully transposed line has conductors equilaterally spaced at 3 metres. The…

Q: A continuous stirred-tank reactor is considered generally as a: Self Regulation System Process…

A: A continuous stirred-tank reactor is considered generally as a: a) Self Regulation System b) Process…

Q: 1. Aşağıda verilen devrede 52 direnci üzerindeki gerilimi düğüm gerilimleri yöntemini kullanarak…

Q: 7) If the reload value in TH is 96, the frequency oscillator is 11.059MHz, and the SMOD bit equals…

A: Given that TH is 96. Oscillator frequency is 11.0592 MHz SMOD bit equal 1. Find the baud rate at…

Q: A single phase, 30 km long overhead transmission line consists of two parallel long conductors each…

Q: 7777 J. Calculate current density of a germanium p-a diode at a forward voltage 03 V. The n-type…

Q: The registers A. B. C. D. A. The cache memory. B. C. D. A. B. hold specific data for the…

A: The registers ________ a) hold specific data for the fetch-decode-execute cycleb) store data inside…

Q: In an AC circuit, the voltage is given by V = (100-j50) volts and the current in the circuit is I =…

Q: 1. A time-domain quantity is given as x(r)-5sin(3r+15). The phasor of this quantity is: (a) X-Se-A…

A: Given data, Function is given as xt=5sin3t+150.

Q: The pick-and-place robot arm is considered generally as a: O Discrete-state Control System O Process…

A: The pick-and-place robot arm is considered generally as a: a) Discrete-state Control System b)…

Q: b) The input voltage, Vin(t) = 15 sin(400mt) V is connected to four silicon zener diodes as shown in…

Q: 2. How the characteristics of the voltage follower (i.e., the high input and low output impedance)…

A: Voltage follower circuit A voltage follower circuit has a high value of input impedance and a…

Q: L = 0.1 H, R = 30, C = 0.05 F E(t) = 100 [U(t − 1) – U(t − 2)] - di L = + Ri + dt 1 i(t)dt = E(t)

Q: A few measurements on the below circuit produces the labeled voltages (indicated in blue colors.…

A: The circuit can be draw as

Q: 1. Consider the phase-shift oscillator shown in the below figure with parameters R = 4k and C =…

Q: Find I in the Circuit 5b. 1₁ 20 36/0° V (+ -j2 n 1:4 Ideal 2Ω 12/0° V

A: Note: The transformer is a static device that helps to step up or down the voltage or current level…

Q: A 240 V, 4-pole wave wound DC series motor has 600 conductors on its armature; it has armature and…

Q: 1. (30%) For the following digital circuit, consider all the expressions that would be needed for…

Q: mple, briefly describe the application of knowledge igital circuits such as memory, pulse unit…

Q: what is the motor speed in (rpm)

A: Given: a 25 HP, 250V, 84A "Shunt" DC motor Vt = 250 V The field resistance =170 ohms armature…

Q: A single circuit 3-phase line operating at 50 Hz has a conductor diameter of 5.18 mm. The sp between…

Q: For 50 Hz system the maximum speed of a synchronous generator can be

A: Given data, Frequency f = 50 Hz. For maximum speed number of poles P = 2.

Q: Two Voltage Sources, V1 with internal resistance R1 and V2 with internal resistance R2, are placed…

Q: 3-phase transmission line 100 long has its conductors of 0.5 cm diameter spaced at the s of the…

Q: For 50 Hz system the maximum speed of a synchronous generator can be 3600 rpm O approximately 3000…

A: The Synchronous speed of a synchronous generator is given by formula Ns =120f / P Where, P =…

Q: An asynhronous motor for aeronautical applications has the following rated data: V = 220 V, T = 48…

A: Given: An asynchronous motor for aeronautical applications has the rated data, Vn=220 V, Tn=48 Nm,…

Q: Z Find x(n) if x(z) (z+ 0.3)(z - 0.4) 2

Q: Example 10.6 Examine the stability of s³ + 25 +45³ +85² + 3s +1=0 using Routh's criteria. Solution…

A: Routh hurwitz table is given it is asked to explain how we are getting final data in table

Q: 3. Luminaires of 2000 Im output will be installed in a room. The desired illumination is 200 fc. The…

A: Solution of question (3): Luminaries that will be installed in a room is F=2000 lumens. Desired…

Q: Consider a second order system whose state space representation is of the form *= Ax+ Bu. Where B =…

Q: In the circuit shown below, calculate: vin Vos VOD MI M2 HOUT

Q: An electric circuit contains a 1-H inductor, a 4-92 resistor, and a voltage source of cost. The…

A: It is given that: L=1HV=costr=4 Ωdidt+4i=cost∆t=0.1 sintial current is zero i.e., i0=0

Q: Vi ww RG +5 V Rp Cc Rs -5 V Cs R₁ = 40 ΚΩ

A: We need to draw DC and AC equivalent circuit for given circuit.

Q: THE NETWORK SHOWN IN FIGURE REACHES A 20 V 10 V 30 42 ww 2002 ww t=0 elle STEADY STATE WITH SWITCH K…

A: In this question We need to determine the current i(t) for time t>0. Inductor act as short…

Q: The total reactive power of an AC circuit having power factor of 0.85 leading is 40kVAR. The true…

Q: § 6.4 Voltage-Divider Biasing * 15. For the network of Fig. 6.79, determine: (a) ID and VGS (b) VDs…

Q: Write down the mesh equations for Loop 1 and Loop 2 in Figure 3.3. You are not required to solve…

A: here we have to write the mesh equations.

Q: Solve please Last time Rejected The expected value of the voltage across a resistor is 60 V.…

Q: 4. For the Colpitts oscillator shown in the below figure is biased at ID = 1mA. The transistor…

A: Given: In this question, For the Colpitts oscillator is biased at ID=1mA. The transistor…

Q: A unity feedback system has the loop transfer function shown below. Draw the Nyquist HG(s)-plane…

A: Given data Open loop gain, HGs=K1+ss21+s202 We need to draw the Nyquist pot for the larger value of…

Q: 16. Given Vps = 4 V for the network of Fig. 6.80, determine: (a) ID. (b) VD and Vs. (c) VGS- 12 V…

A: We need to find out the current and voltage for given circuit.

Q: 5. A charge of 12 nC has a velocity of V= 5a-2a, + 3a₂ m/s. Determine F on the charge in the field…

Q: 2. A 3-phase, 4-pole, 50 Hz, 208 V induction motor has a starting line current of 700 A and a…

Q: A 220V do motor developing 25 hp (18.65 kW) runs at a speed of 1000 r/min.. Calculate the torque in…

A: the dc motor output power and speed is given it is asked to find the torque

Q: find The m and Draw The output signal of AmpsB Vc (t) = 8 cos2πxist Ac pm(t)

A: Given: vct=8cos2π×105t and Ac=8 Volts.

Q: In an AC circuit, the voltage is given by V= (100-j50) volts and the current in the circuit is I =…

A: it is asked to find the real and reactive power in the circuit using voltage and current given S = P…

Q: Which one of the following is the NAND2 gate equivalent area of the circuit A.B.C + C + D? The gate…

Q: 2. Find V, in the network in Fig. P3.50 using nodal analysis. (1+ 1 kΩ ; 12 V 4₂ www 1k02 2 mA 21₂…

A: Since you have asked multiple questions in a single request, we will be answering only the first…

Q: Provide short response for the followings: (a) The advantage of DSB-SC modulation over AM (i.e. DSB…

Question

Capacitance-

For the given circuit, the value of capacitor is in mF. So that the system will
be critically damped is
40 Ω
4 H
wwroot
C
i(t)
+ Vo

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Mathematical Modeling of Mechanical System

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

An AC circuit contains a 24 resistor, a 15.9-mH inductor, and a 13.3F capacitor connected in parallel. The circuit is connected to a 240-V, 400-Hz power supply. Find the following values. XL=XC=IR=AIL=AIC=AP=WVARsL=VARsC=IT=AVA=PF=%=
The total capacitance for this circuit is C₁ 5 F A. .035 farad. B. .06 farad. C. .026 farad. D. .0026 farad. C₂ 10 F C3 10 F What is the total capacitance of a circuit with three capacitors connected in series with the following values: C1 = .015 farad, C2 = .015 farad, and C3= .015 farad? A. 5 farad. B. .05 farad. C. .015 farad. D. .005 farad. What is the total capacitance of a circuit containing a .01 farad, a .015 farad, and a .001 farad capacitor, all connected in parallel?
4) Based on the circuit to the right answer the folowing questions. SHOW ALL WORK Switch is closed for the capcitors STEADY STATE (a) The equivalent capacitance and resistance is (0) 20UF c2 () () (iv) 26ul, 19KQ 5.0uF,6.0k2 25pF, 3 0ko 15uF.14ko 12V C3 TRI 12k0 R2 R3
The figure below shows a simple RC circuit with a 3.30-μF capacitor, a 4.40-M resistor, a 9.00-V emf, and a switch. What are the following exactly 9.00 s after the switch is closed? (a) the charge on the capacitor 13.7204 UC (b) the current in the resistor 0.0110522 x Your response is off by a multiple of ten. HA (c) the rate at which the capacitor is storing energy μW (d) the rate at which the battery is delivering energy μW
The switch in the following circuit closes at t-0. If the capacitor is initially discharged, calculate the voltage on the capacitor at t-3s. (R-50KQ, C-33uF) 50 k2 15 V 33 jul
A resistor and a capacitance are connected in series to an emf source. The time constant of the circuit is 0.87 s. What will be the 35 - time constant of the new circuit when another capacitor identical to the first is connected in series with the circuit? O a) 0.973s O B) 1,742 s O C) 2.034 s O D) 2.136 s O TO) 0.435 s
Select all correct statement(s):1, The equivalent resistance for resistors in parallel is the harmonic mean of all resistors;2, The equivalent capacitance for capacitors in series is the sum of all capacitors;3, The equivalent inductance for inductors in series is the sum of all resistors.32None of them is correct1
Consider the parallel plate capacitor shown below, prove that: c = Egen -), 2 x(Eg-En)+ten showing all your derivations steps. d/2 En d d/2 E, d. t
Asap
The resistors of a series circuit are given by this combination. All values are ohm resistor. Find the Z when the capacitor is 20 x 10-6 Farad.
In a circuit, there is a series connection of an ideal resistor and an ideal capacitor. The conduction current (in Amperes) through the resistor is 2sin(t+ n/2). The displacement current (in Amperes) through the capacitor is
In a R-C series circuit, the C charges exponentially to the input Voltage = 10V in time 45msec. Find the Time-constant of the circuit. What is the Capacitor Voltage at t = 9 msec? Say at t = 50 msec, the input is switched off. What will be the Capacitor voltage at t = 49 msec and at t = 59 msec?