4. Find the total equivalent Resistance (Rab).612223095252

Answered: Image /qna-images/answer/9cc43ef1-7c55-4d2e-ba16-4fd17c9c0c66.jpg

Answered: Find the total equivalent Resistance…

Engineering

Electrical Engineering

Find the total equivalent Resistance (Rab). 652 42

EBK ELECTRICAL WIRING RESIDENTIAL

19th Edition

ISBN:9781337516549

Author:Simmons

Publisher:Simmons

Chapter19: Special-purpose Outlets-water Pump, Water Heater

Section19.2: Water Heater Branch Circuit

Problem 8R: For residential water heaters, the Consumer Product Safety Commission suggests a maximum temperature...

See similar textbooks

Related questions

Q: In a hydroelectric power plant, 65 m3/s of water flows from an elevation of 90 m to a turbine, where…

A: power output of hydel power plant = 9.81×ρQHη watts where rho is the density of water Q is the…

Q: 21. This circuit represents a model of a solar photovoltaic panel. Given that V₁ = 30V, R; = 2002…

Q: Giving the following tank circuit, if L= 50 mH, R=102 and C=5µF. The approximate value of w, is L.

Q: Determine the voltage V, in the circuit shown below 50

Q: Given the following wye-connected resistances: Ra = 8 Ω, Rb = 9 Ω, and Rc = 6 Ω, calculate the value…

Q: Q/ Sketch V. and detelmine vss v.ms V ms

A: The solution can be achieved as follows.

Q: Ex Use mesh analycis to find the current in all elements. 40 20

A: Given :

Q: Example 6: Calculate the capacitance and charging current of a single core cable used on a 3-phase,…

A: Given Data: d = 10 cm l = 1000 m er = 4

Q: 4- Find the Thévenin circuit for the network within the shaded area of Figure below: E, q+ 10 V

A: The solution can be achieved as follows.

Q: 6. Find the total resistance at Rab.

Q: Find the equivalent resistance Rab, cof the following 1 circuits, Ench reesistor is Rn[Use Y-A…

A: Combining the resistance we get,

Q: Item 6 of 10 A network has a true power and a reactive power of 2400 W and 3200 W respectively. What…

Q: An impedance coil is connected in series with a fixed resistor, and a 120-V, 50-cycle Source is then…

Q: dc power supply

A: DC Power Supply

Q: When 50Hz alternating voltage of 150V is applied across the 10-Ohm resistor, 0.2H indcutor and…

A: Given that f= 50 Hz V= 150 volt R= 10 ohm L=0.2 H C=50 micro farad Calculate capacitive and…

Q: Assuming the dielectric of each capacitor is air and the network is connected to Vab = 30V supply,…

Q: Short Problem: Given a parallel RLC circuit comprised of the following element: 95.34-ohm resistor,…

Q: Given a parallel RLC circuit comprised of the following element: 76.19-ohm resistor, ideal inductor…

A: True power is nothing but power consumed by resistor Given by P = Vrms2/R

Q: Find the Vpeak of the Vout Value of the circuit below during the positive half cycle. R1 SiliconD…

A: The diodes are made of semiconductor materials. Silicon and germanium are common semiconductors for…

Q: Given a parallel RLC circuit comprised of the following element: 99.3-ohm resistor, ideal inductor…

A: In this question we need calculate true power .

Q: A circuit with resistance of 100-N and inductive reactance of 1-N in series across a 100 V source,…

A: To solve above problem, one should have basic idea about working of AC circuits. Above given circuit…

Q: A non- inductive resistor of 10 ohms requires a current of 8A and is to be feed from 1 200V 50Hz…

Q: Determine aln currents amd voltages m the circuit of the figure shown. エイ 12 13 I4 201 8 A 201 102

A: Given, The circuit is

Q: Consider a model (Electric RLC series Circuit) find the steady state current in a circuit using the…

A: to find the steady state current

Q: Consider a model (Electric RLC series Circuit) find the steady state current in a circuit using the…

A: When Inductance (L) and capacitance (C) connected to the AC circuit then their reactance contribute…

Q: 8.5 A 1100 Ah AGM battery (20-h rate) is used in a mini-grid. The mini-grid supplies a critical load…

A: Given data:

Q: Three identical capacitors are connected in delta with 400 V. If the line current is 12 A:…

Q: A 230 V, 50 Hz fluorescent lamp unit takes a current of 0.6 A at a PF of 0.45 lagging. Calculate the…

Q: ) Consider the following circuit. Wha VDD +12 V RD 3.3 kQ 0.1 µF Rg RG 1.0 MQ 6800

Q: Discussion : Using complex algebra, find the voltage V for the circuit in Fig. below. Sketch the…

A: Given circuit,

Q: Using diagrams, explain the correctness of the relation ICEO = (β + 1)ICBO.

Q: Question 7.31 For the network of Fig. 7.105, determine: a. IDQ and VGSQ. b.VDS. c. VD.

Q: Referring to this figure, calculate Av if yos= 20 µS. Vp in the figure is Vgs(off)

A: The required parameters can be calculated by using the DC analysis and AC analysis of FET amplifier.

Q: A coil of wire having a value of (5 + j8) ohms is connected in series with a capaci- tive reactance…

Q: Rd Re 3 0 Ra Vc 30 Vdc Rc Rb 60 40 Itotal

Q: For a system if the value of damping o increases, then the rise time is increased. Select one: O…

A: In the control system If the damping ratio increase then rise time?

Q: 3. Let Is= 50A, nd V, 20 40 50

A: When total current is known and there is a combination of parallel paths, the current through any…

Q: 29. A telephone circuit has a capacitance of 6 microfarads. What current flows through it when 15 V…

Q: QUESTION 7 Given the following delta-connected resistances: Rab = 5 Q, Rpc = 5 Q, and Rca = 3 Q,…

Q: 13 For the circuit shown, the voltage source is 100<0 Vrms and k = 0.5. With w = 1000 rad/s, the…

Q: In a power supply using 7812 IC, the electronic device that changes AC to its DC equivalent is…

A: 7805

Q: 1. My family have (buy) some land in southern France recently. They (build) a summer house there at…

A: We are authorized to answer three subparts at a since you have not mentioned which part you are…

Q: For a system if the value of damping o increases, then the peak time is increased. Select one: O…

A: In control systems, we have Wd = Wn x squareroot(1- delta2 )-------(1) Where delta is damping.

Q: Find current i in the circuit shown below when us(t) = 50 cos 200t V. 10 Ω www 14 5 mF 20 mH

A: Given, vst=50cos200t V

Q: 3. Fined RT for the circuit shown below 101 31 201 VT 10 V

Q: impedance coil is connected in series with a fixed resistor, and a 120-V, 50-cycle source is then…

Q: For the circuit shown below, find ) The total capacitance of the circuit ii) The total charged…

A: The series and parallel connection of capacitors is used to calculate the total capacitance and then…

Q: Q2: For the circuit shown below, assuming Vin(t) = 0.5 sin(1000nt): 1. What is the function of the…

Concept explainers

Current Division Method

The generalized current divider formula is given by the following relation below,

Question

4. Find the total equivalent Resistance (Rab).
612
22
30
952
52

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step by step

Solved in 4 steps with 4 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

For residential water heaters, the Consumer Product Safety Commission suggests a maximum temperature setting of ___________ F (_____________ C). Some states have laws stating a maximum temperature setting of ____________ F (________________ C).
The temperature dependence of resistance is also quantified by the relation R2=R1[ 1+(T2T1) ] where R1 and R2 are the resistances at temperatures T1 and T2, respectively, and is known as the temperature coefficient of resistance. If a copper wire has a resistance of 55 at 20C, find the maximum permissible operating temperature of the wire if its resistance is to increase by at most 20. Take the temperature coefficient at 20C to be =0.00382.
What is CEMF?
My circuit is a Wall-Wall rectifier circuit. The transformer is taking in 120Vac from the wall and stepping it down to 22Vac. A set of 4 diodew and a capacitor then supply 22 VDC with a ripple voltage of 50mV and a ripple frequency of 120Hz. Which diode should be purchased and why?
A PMMC instrument has internal resistance of 0.77 ko and gives full scale deflection for 35 mA. The required resistance value of multiplier resistors for employing the meter as a multi range voltmeter for voltage range 79 V will be ohms. 102562.40 O 224.94 1487.14 O -326.96
I need some help with this problem. I need to create a power supply from 110v 60hz to regulated an output between 6 and 9 v. the image is the desire circuit to acomplish the possible solution. The resistor after the bridge rectifier will work as a surge protector or current limiter for the zener diode. the other is the Load resistor. I need some sort of calculations to prove the specific values for the components to operate according to the specs that I already explain. I know the capacitor will smooth the ripple voltage etc... but I need some guidance to get actual values
A half-wave rectifier is needed to supply 15-V dc to a load that draws an average current of 250 mA. The peak-to-peak ripple is required to be 0.2 V or less. What is the minimum value allowed for the smoothing capacitance?
A PMMC instrument has internal resistance of 0.51 kN and gives full scale deflection for 41 mA. The required resistance value of multiplier resistors for employing the meter as a multi range voltmeter for voltage range 56 V will be, ohms. O a. 222.14 O b. 136.08 O c. 109762.92 O d. 855.85
Simple circuits techniques
Power supply circuit is delivering 0.5 A and an average voltage 20 V to the load as shown in the circuit below. The ripple voltage of the half wave rectifier is 0.5 V and the diode is represented using constant voltage model. The smoothing capacitor value is equal to 220V rmsh soHz} VL-DC =20V 0.01 F 0.02 F 0.0167 F None of the above
Calculate the equivalent resistances Rin of the following circuits. (The resistance value of the diodes in the conduction will be 0, the resistance value of the diodes in the insulation will be taken as infinity. R1=10ohm
The resistance increases as temperature rises usually due to increased thermal lattice agitations is a. RTD b. PTC c. NTC d. EMF