EXAMPLE 30-7 LC circuit. A 1200-pF capacitor is fully charged by a 500-V dc power supply. It is disconnected from the power supply and is connected, at t = 0, to a 75-mH inductor. Determine: (a) the initial charge on the capacitor; (b) the maximum current; (c) the frequency f and period 7 of oscillation; and (d) the total energy oscillating in the system.

EXAMPLE 30-7 LC circuit. A 1200-pF capacitor is fully charged by a 500-V dc power supply. It is disconnected from the power supply and is connected, at t = 0, to a 75-mH inductor. Determine: (a) the initial charge on the capacitor; (b) the maximum current; (c) the frequency f and period 7 of oscillation; and (d) the total energy oscillating in the system.

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter33: Inductors And Ac Circuits

Section: Chapter Questions

Problem 31PQ

See similar textbooks

Similar questions

An LC circuit consists of a 3.00 mH inductor and a 5.00 (F capacitor. (a) Find its impedance at 60.00 Hz and 10.0 kHz. (b) Compare these values of Z with those found in Example 23.12 in which there was also a resistor.
An RL circuit consists of a 40.0 (resistor and a 3.00 mH inductor. (a) Find its impedance Z at l60.0 Hz and 10.0 kHz. (b) Compare these values of Z with mouse found in Example 23.12 in which there was also a capacitor.
In an RLC series circuit, can the voltage measured across the capacitor be greater than the voltage of the source? Answer the same question for the voltage across the inductor.
When the current through a large inductor is interrupted with a switch, an are appears across the open terminals of the switch. Explain.
For an LC circuit, show that the total energy stored in the electric and magnetic fields is a constant given by Equation 33.28, Etot=Qmax2/2C=12LImax2.
To receive AM radio, you want an RLC circuit that can be made to resonate at any frequency between 500 and 1650 kHz. This is accomplished with a fixed 1.00 (H inductor connected to a variable capacitor. What range of capacitance is needed?
A series RLC circuit consists of an 8.00- resistor, 5.00-F capacitor, and a 50.0-mH inductor. A variable frequency source applies an emf of 400 V (rms) across the combination. Assuming the frequency is equal to one-half the resonance frequency, determine the power delivered to the circuit.
In an LC circuit, what determines the frequency and the amplitude of the energy oscillations in either the inductor or capacitor?
In Figure 14.12, =12V , L = 20 mH, and R=5.0. Determine (a) the time constant of the circuit, (b) the initial current through the resistor, (C) the final current through the resistor, (d) the current through the resistor when t=2L , and (e) the voltages across the inductor and the resistor when t=2L .
EXAMPLE 30-8 Damped oscillations. At t = 0, a 40-mH inductor is placed in series with a resistance R = 3.00 Ω and a charged capacitor C = 4.8 μF. What value of R will make the circuit nonoscillating?
EXAMPLE 30-8 Damped oscillations. At t = 0, a 40-mH inductor is placed in series with a resistance R = 3.00 Ω and a charged capacitor C = 4.8 μF. (a) Show that this circuit will oscillate. (b) Determine the frequency. (c) What is the time required for the charge amplitude to drop to half its starting value? (d) What value of R will make the circuit nonoscillating?
EXAMPLE 30-7. LC circuit. A 1200-pF capacitor is fully charged by a 500-V dc power supply. It is disconnected from the power supply and is connected, at t = 0, to a 75-mH inductor. Determine: (a) the initial charge on the capacitor; (b) the maximum current; (c) the frequency f and period T of oscillation; and (d) the total energy oscillating in the system.