e = 0 Q1: What does happen if we change two currents? Q2: What does happen if we have a three-phase four poles machine? Q3: What does happen if we have a two-phase two poles machine? e = 0 Q4: What does happen if we apply a capacitance in phase b and then use same voltage for both phase. Dr. Ali Ka. ..pw --

e = 0 Q1: What does happen if we change two currents? Q2: What does happen if we have a three-phase four poles machine? Q3: What does happen if we have a two-phase two poles machine? e = 0 Q4: What does happen if we apply a capacitance in phase b and then use same voltage for both phase. Dr. Ali Ka. ..pw --

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.31P: Consider two interconnected voltage sources connected by a line of impedance Z=jX, as shown in...

See similar textbooks

Similar questions

What is the physical meaning of the reactive power and the power triangle? Explain howcan this triangle achieved?
vii. When two magnetic circuits are coupled..... the coupling coefficient is expressed by (a) K=M\ VL1 L2 viii. Impedance matching means (a) Transfer power to the load (c) Maximum power transfer to the load. (b) k= MIM2 (c) K= LIL2 (b) Minimum power transfer to the load
Q9. What is the basic principle that a cage winding can be represented by a three-phase winding? Give your explanation.
What is the main direct cause of reactive power in AC system?A. Resistance of transmission linesB. Inductance and capacitance in the loadsC. Ideal transformer connected in the systemD. Power produced by generator
What is practical application of PWM?
Q.4/ choose true or false: 1. The reluctance of any core is proportional directly with the length of it and inversely with both the permeability and the cross-section area of it. 2. The number of parallel paths in wave windings is equal to twice of the number of poles. 3. In dc machines with same values of Z, N, Ø, the emf for wave winding type is more than emf of lab winding type. 4. If we insert a current in such a conductor subjected to a constant magnetic field, a movement will achieved giving the principle of electric generator.
A 5-ohm resistor is connected in series with a 25 micro-farad capacitor. A source voltage of158 volts, 50 Hz supplies the combination. Determine the following:a. Circulating currentb. Voltage across the resistorc. Voltage across the capacitord. Real power supplied by the source
Construct the circuit in Figure 1 in the Circuit JS simulator. Note that the voltage source is given in RMS. Within Circuit JS while defining the max voltage of the voltage source include “rms” after the number to tell Circuit JS that this is a rms value. Also note that there are additional parameters when instantiating a transformer in Circuit JS. Leave these at the default values. Additionally, transformers may have problems simulating in Circuit JS. Answer the following: 1. From the simulation results, determine the power dissipated in R2 and compare to the expected value from the previous section.2. Change the transformer ratio (“Ratio” as a fraction when you “Edit…” the transformer component) to the value calculated in the previous section to provide maximum power transfer in R2. Note: In Circuit JS, Transformer Ratio = Primary/Secondary.3. Rerun the simulation, calculate the power dissipated in R2 and compare to the expected value from the previous section.4. Change the…
Referring to the figure below. assume a 6V battery having a negligible resistance. to be connected in series between the terminal of the dc generator having an internal resistance of 0.15 Ohm 10 charge two batteries A and B in parallel. If the internal resistances of batteries are 0.5 Ohm and 0.25 ohm respectively. determine the charging current through battery A using a.) Kirchhoff's Law. b.) Mesh Analysis, c.) Nodal Analysis, d.) Superposition Method, e.) Source Transformation Method f.) Thevinin's Theorem, g.) Norton's Theorem and h.)Millman's Theorem.
The primary of a certain transformer takes 1 A at a power factor of 0.4 when connected across a 230 V, 50 Hz supply and the secondary is on open circuit. The number of turns on the primary is twice that on the secondary. A load taking 50 A at a lagging power factor of 0.8 is now connected across the secondary. Sketch, and explain briefly, the phasor diagram for this condition, neglecting voltage drops in the transformer. What is now the value of the primary current?
7. A coil having a resistance of 20 ohms and an inductance of 0.75 henry is connected in series with a 30-ohm resistor and to a 120-volt d-c source. A switch across the series resistor is then closed, and the circuit is assumed to be in a steady-state condition. At the instant the switch is opened, what will be the rate of current change and the power delivered by the magnetic field.
2. The below figure shows the results of magnetic particles inspection experiment. What can you conclude from it? d) Discuss which hysteresis is better to be used with the AC generator in the airplane. e) In general, describe the structural, elasticity and electrical properties of copper and the PVC insulator (polymeric) with reference to their material properties. f) How metals and non-metals (ceramics and polymers) could be degraded?