Answered: Detetrmine the formula mass, in amu, of…

Detetrmine the formula mass, in amu, of diesel, C12H23. а. 147.31 с. 167.31 b. 157.31 d. Answer is not among the choices

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: Consider water that is at 7MPa pressure and has an enthalpy of h-3261.7 (kJ/kg). What is entropy per…

A: Given:Pressure of water, P=7 MPaEnthalpy of water, h=3261.7 kJ/kg

Q: 11.-What is the work of the isobaric process (from point C to point D)?

Q: 6.21. The owner of the dump in Problem 6.20 suggests things would be much better if a 20-m stack…

A: Given DataFrom above question we had getemission without stack=284μg/m3QNOx=3g/sH=20m

Q: In an internal combustion engine, an air/fuel mixture at atmospheric pressure and 24 °C is…

Q: Identify if the property of the following steam: Temp Specific Enthalpy Quality C kJ/kg 287 2661 ?

Q: why Mement of interia is it should be always in the direction of the motion of the car or what ( Or…

A: Solution: The correct answer with necessary explanation is given below:

Q: 6. Four pounds of air gain 0.491 Btu/°R of entropy during a nonflow isothermal process. If p, 120…

Q: Using Marshall method to design an asphalt mix, the data in the Table below were obtained. The bulk…

Q: Estimate the pressure kPa(a) in the tank and density (kg/m3 ) of the gas mixture in the tank where…

Q: 2019 \ 2020 static pressure in the air stream is 50kpa, static temperature is 298K. Calculate Answer…

A: Mach no is a property of the fluid that represents the ratio of flow velocity across a boundary to…

Q: How many crankshafts does a V- -4 * ?type engine (e.g. V8, V12) have (A) 1 O (B) 2 (C) 3 (D) 4 A car…

A: Question (4): In all V-type engines, such as V8, V12 etc. , there will be two cylinder banks, each…

Q: A continuous flow calorimeter was used to obtain the calorific value of a sample of fuel and the…

A: The calorific value of fuel is amount of heat generated by a fuel due to its complete combustion of…

Q: Determine the ini tial Mach number, exit pressure ,exit temperature and stagnation pressure loss if…

Q: Air enters diesel engine at 1 bar and 20 C, then compressed to 35 bar before fuel injection,…

A: The given values are - P1 = 1bar ,T1 =20°C, P2 = 35bar The compression in the diesel cycle is…

Q: Identify if the property of the following steam

A: Given data:

Q: * Properties of Saturated H₂O мра Vf 1 1.1 1.2 0.001127 (2) 0.001139 Va 0.1944 (?) 0.1633

Q: +stroke, 8-cylinder, petrol engine, has the following parameters at sea %3D sumption = 0.75 ltr/min,…

A: Vf=volume flow rate of fuleVf=0.65let/min =0.65×10-360m3/secmf=mass flow rate of fuel=density of…

Q: Air (assuming constant specific heats of Cp 1.008 J/kgk. Cy= 721 J/kgK. k = 1.4) is compressed…

A: To find The temperature of compressed air T2 Given The initial pressure P1 is 150 kPa. The initial…

Q: Q7. The mass of air needed for complete combustion of 1 kg of propane (C3H8 ) is:- *

A: Write the atomic weight of the molecules and elements.

Q: lagrange interpolation is to be used to represent the enthalpy of saturated air as a function of the…

Q: (a) Prove that the identity ( əv. O, +P ne, T and T T Cy V ƏT, T

A: Prove: ∂S∂TV=CVT From the property relation of the first law of thermodynamics,…

Q: (Use Mollier Chart, note: tolerance of temperature & enthalpy is ∓1,pressure is ∓0.1, entropy is…

Q: 1000 kg car requires eight seconds to change its speed from 0 km/h to 140 km/h. What is the powered…

A: Given: m= 1000 Kg u= 0 km/h =0 m/s v= 140 km/h = 38.89 m/s

Q: tranport amalo gous only di) The unieonponend paefficient is diluted. when the Flow is…

A: One of the fundamental pillars in the field of Transport Phenomena is mass transfer, which…

Q: Find the stoichiometric A/F ratio for the combustion of ethyl m (C4H9OH) in a petrol engine.…

A: To find the stoichiometric air-to-fuel AF ratio for the combustion of ethyl m (C4H9OH), we need to…

Q: Find the stoichiometric A/F ratio for the combustion of ethyl (C3H7OH) in a petrol engine. Calculate…

A: To find the stoichiometric air-to-fuel AF ratio for the combustion of ethyl C3H7OH we need to…

Q: 3) A large tonk initially contains 200 gallons of brine in ur/e 15 lbs. 0f salt is dissolved.…

Q: 22-24. The large and small pistons in a hydraulic lift have an area of 360 cm² and 45 cm²,…

Q: A compressor is compressing 10 m/min of free air to 10 bar gauge. What is the power requirement…

A: given:velocity of free air=10m/minpressure p2=10 bar gaugepolytropic index n=1.3initial pressure…

Q: The current emissions standards for new railway Diesel locomotives limit CO emissions to 1.5…

A: Given: Co emission standard for new railway diesel locomotives=1.5 g/bhp-hr bhp of…

Q: 120 mm and stroke 180 mm under test, is supplied petrol of composition C= 82%, H, = 18% by mass. The…

Q: A fuel oil C12H26 is used in an internal combustion engine and the Orsat analysis are as follows:…

Q: 70. A supersonic airplane flies at two altitudes find the temperature of air at second level, (v2…

A: Now according to given data we haveMa=VCV=Velocity of planeC=Velocity of sound in air at particular…

Q: 10. An ideal monatomic gas goes through the following cycle. It starts at a point a…

Q: Derive Hae mean effective pressure of Dresel Cyole Fngine In terms of P., e ,k, ve ,rp and rie * P.…

A: Thermodynamic cycle of diesel cycle process 1-2: isentropic compression process 2-3: constant…

Q: From the experiments performed on the pump (pump A) in a laboratory, the following values at the…

A: It is the most common parameter , to compare a prototype and model It is defined as the speed at…

Q: Q.1 A 4-stroke, 4-cylinder diesel engine operating with bio-diesel fuel with an equivalent molecular…

A: THE SOOT AND CO EMISSIONS :Non-Dispersive Infra-Red (NDIR) technique: • This is the business…

Q: 3- Is a diesel oil of a high aniline point desirable as automotive fuel? Why?

A: A diesel engine works on an auto cycle. Heat is added at constant pressure. Following are some…

Question

100%

Detetrmine the formula mass, in amu, of diesel, C12H23.
а.
147.31
с.
167.31
b.
157.31
d.
Answer is not among the choices

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

There are 5kg/s of CO2 (R=188.96kJ/kg-K, k=1.288) gas compressed polytropically with n=1.2 from 103kPa, 60C to 1200kPa. What is the change in Enthalpy? (kJ/s)
If we have 5 kilograms of air how much ethanol do we need In an ideal air-fuel ratio in terms of weight? a. All are correct b. 555.56 g c. None of the choices d. 5/9 kg Show solution. Please answer honestly and do not just guess. Thank you :)
i need subpart 4 to the last number to be solved
Synthetic Natural Gas (SNG from a US based plant) has the molar composition: 96.59% CH4, 1.29% H2, 0.22% CO and 1.9% CO2. Calculate the GCV and NCV in:a) MJ/kgmol (Ans. 864.88; 779.24)b) kcal/gmol (Ans. 206.56; 186.11)c) kcal/kg (Ans. 12612.19 ; 11363.55)d) kcal/SCM (Ans. 8593.04; 7742.12)
Steam power plant - please answer accurately - thank you
Choose the correct answer
NFPA means - a. O a. National Fluid Power Association b. National Fluid Power Activation OC. Net Fluid Pressure С. Activity d. Net Fluid Power Association
Anideal gas with a mass of 2 kg reversibly and polytropically expands up to 3 times its initial volume in a piston-cylinder assem bly. The temperature of the ideal gas drops from 300° Cto 60° C. (a) If the heat energy inputis 20 kJand the boundary work output is 100 kJ, the specificheats of the gas cv [kJ/ kgK] and find the cp [kJ/ kgK] values. (b) If the heat energy output is 20 kJand the boundary work output is 100 kJ, the specificheats of the gas cv [kJ/ kgK] (c) Find the value k, which is the ratio of specificheats. (d) If the heat energy input is 20 kJ, the boundary work output is 100 kJ and the entropy generation is 0.36 kJ/K, then the thermal energy Calculate the source tem perature as [° C].
Write the general energy balance for any combustion process. Is my answer correct?
y Formül; Tmaks TL -;(1 – 0,630b/a) M,(lzy.z– ly.y) + M,(1..2 – Izy.y) 4.ly – Izy² Oz + Oy, tan20, - J,- dy czab³G' 5>5 için q = 10 cm It 2tA Og+ dy Ox- By cos20 + Tysin20 , Jort 2 2 600 N `x ty =- sin20 + Tyycos20 , Omaks.min 14 cm B Tmaks + rảy Vertical load is applied to point B of a 10 mm radius cylindrical bar as shown in the figure. Calculate the normal stress at point D. 76,39 MPa O MPa 48,86 MPa O 33,37 MPa O 94,75 MPa
A wind turbine gives the following data: Blade length= 57.5 m. Wind speed = 13 m/s Air density = 1.225 Kg/m3 Power coefficient = 0.45 Assuming equal efficiencies for gearbox and generator, If the Power output from wind turbine, P is 1.9 MW, then find
he performance of the engine depends on inter-relationship between power developed, speed and the specific fuel consumption at each operating condition within the useful range of speed and load. Explain the inter-relationships of the given parameters.