Determine  Vs peak to peak,  Vo peak to peak, Vdc

Q: 8) The resusltant value of two currents that are out of phaso writh each other by 60 oloc đeg is 70…

A:

Q: Draw circuit of wilder current source.

A: The BJT are used as constant current source. The collector current of BJT is relatively independent…

Q: Q6. What is the purpose of harmonic standards? Provide a summary of comparison of IEEE and IEC…

A:

Q: The CMRR is the ratio of:

A: Operational amplifier- An integrated circuit which amplifies weak electric signals into a strong…

Q: Which of the following statement is true? a. Angle between load voltage and load current in a pure…

A: Solution:- Let's consider a capacitor C connected to load with capacitance C.C is connected as load.…

Q: For the self - bias Conf. of tigure bellow D sketch the trans for curve for the device ) from the…

A: To plot various points in transfer curve of above plot. Use Shockley equation  IDS=IDSS1-VGSVP2…

Q: For the given figure, find the branch current i1, i2, i3, i4, i5 and i6 by any method of analysi

A: The above circuit can be solved using either of the circuit theory rules mentioned below:…

Q: 25. The bridge reckfien (one-half, Same, kwico) othat of the PIV rating of each di'ode. in a is equi…

A: as per our guidelines when student posts multiple subpart questions we have to answer first three .…

Q: DETERMINE ETH,RTH,IB,IC,IE,VB,VC,VE ,VCE

A: In this question,  We need to determine the Thevenin voltage Eth  , Rth ,  collector current,…

Q: 1. Using loop analysis/node determine the values of the five resis tor voltages. R8 10k R7 R3 10k…

A:

Q: Tring to solve this MOSFET question but not sure how. Need to find the missing components value.…

A:

Q: What is the example of cable use with RJ-11 connector

A: What is the example of cable use with RJ-11 connector?

Q: Draw the circuit diagram

A: Introduction of chopper- Choppers are used for conversion of fixed DC voltage to variable DC…

Q: For given circuit below Adjuts the VGG voltage to have following Vas values and calculate the…

A: Given circuit is shown below. Given data is VDD=12V, RD=1kΩ, RG=560kΩ. For MOSFET input current is…

Q: An ideal voltage source has İdeat bir gesilim kaynağı Select one: O a. None O b. very high internal…

A: Here is the answer

Q: Ig= UA mA Rg= kQ Rc= RE= VB= V VCE= V V VBc= V *PAY ATTENTION TO THE SPECIFIED UNITS This circuit…

A:

Q: Find the Vpeak of the Vout Value of the circuit below during the positive half cycle. V2 Silicon ()…

A: In the question,  What is value of Vout during the positive half Cycle.?

Q: etermine the voltages Vc and i, for the ncircuit below. 3kn

A:

Q: For network of the figure,Find A. Vcc В. ІВ С. IC D. IE E. VC F. VCE Given that VRC(V)=14.5 and ß=…

A:

Q: nodal analysis. Determine the absorbed power by the resis

A:

Q: What is the frequency and what is the period, write the formula

A: Frequency is nothing but repetition of signal per second

Q: Find the Vpeak of the Vout Value of the circuit below during the negative half cycle. V2 Silicon 8…

A: In the question,  Find the value of the Vout of the circuit, during the negative half cycle?

Q: What is the net current

A:

Q: Solve for Total resistance of Rab

A: The total resistance can be determine as below:…

Q: schematic and the graph of Vin and Vout.

A: Please find your answer below in step 2

Q: 0.AAJT has cuscrent gain B=40 The load eitance Re l02, dcsupply voltage Vcc = 130V and input uoltage…

A: Operation of BJT in Saturation region- Step1. Assuming BJT in saturation region. Step2- VCE=VCE(sat)…

Q: what us the resistance of teb 240- resistors connected in series? in parallel?

A:

Q: VCE = 2.4 V, VCE, 10 V, and VCE= 20 V. %3D %3D

A: Given that  VCEmin=2.4VVCEQ=10VVCEmax=20V Formula for second harmonic distrotion is given by…

Q: 5. Via nodal analysis, obtain Vin the circuit below. Leave your answers in terms of the resistance…

A: In this question,  Find the voltage V using the nodal analysis.  Resistance R and Reactance X

Q: a) Using Nortel voltage rot the al, culculat V 多42

A: Please refer the attached images for the complete answer..

Q: VDD Vin Vout Suppose VDD = 1.2 V and VTHN= 0.4 V. Determine Vought in the Figure above for the…

A: The given NMOS- transistor is shown below, Where, VDD=1.2VVTH=0.4V

Q: A single-phas onas connected to 400/220 V,49.5HZ supply, has an efficiency of 98% at full load . If…

A:

Q: EE +10 V RE 470 N RB 10 ΚΩ Rc 330 N -10 V VcC

A:

Q: At the power-limit condition i.e. for maximum PR (a) leading VARS (Qp) goes to the load for any…

A: we need to explain power limit condition for maximum PR.

Q: Find the equiralont resistonce of dhia ctt r2k ere connected to an AMMA K. ANM-

A:

Q: what is value of current (I).

A: Given circuit is -

Q: terminal voltage and total current

A: Note- “Since you have posted a question with multiple sub-parts, we will solve first three subparts…

Q: NOTE: The units of the resistors are in ohms.  (ANS:  90.973 V)

A:

Q: Calculate the active power, reactive power, apparent power and power factor of the following…

A: In this question , series RLC circuit is given....We have to find out power factor , active power ,…

Q: Question : What is the Vpeak of Vout during 45ms. Question : What is the Vpeak of VS during 15ms.

A: A rectifier circuit is used to rectify the AC power generated by this source to the DC  power that…

Q: Calculate: a) VG b) IDQ and VGSQ c) VD and VS d) VDSQ

A:

Q: What is value of current (I).

A: Given circuit is -

Q: Question : What is the Vpeak of VN1 during 35ms. Question : What is the Vpeak of Vout during 45ms.

A: A rectifier circuit is used to rectify the AC power generated by this source to the DC  power that…

Q: Determine the value of W816. Please submit asap. I have to upload the solution at the earliest.

A: The twiddle factor is a very important parameter in digital signal processing. For N point discrete…

Q: 10k What are the component using in circuit? IDEAL

A:

Q: what is the current

A:

Q: for the voltage divider configuration determine:IBQ,ICQ,VCEQ,VB,VC,VBC using APPROXIMATE ANALYSIS

A:

Q: Q5(a) i) Explain the major difference between IT and TT earthing systems using sketches with labels.…

A: consider the given question;

Q: Find the .. Vs peak to peak , Vo peak to peak , Vdc

A: Half wave Rectifier circuit given.  Find the peak to peak voltage of primary and secondary of the…