Determine the volumes of 0.12 M CH3COOH and 0.15 M CH3COONa required to prepare 10 mL of the following pH buffers. (Note: the pKa of CH3COOH =4.7)   pH 3.8 pH 5.0

Q: Calculate the volume, in milliliters, of 0.170 M NAOH that must be added to 315 mL 0.0547 M…

A:

Q: ANSWER NUMBER FOUR ONLY A study of vaccines suggest that a higher pH, preferably near 7, is…

A: Given the total concentration of the buffer solution, C = 0.25 M   Volume of the buffer solution, V…

Q: Sulfate buffer? Your laboratory is out of materials to make phosphate buffer and you are…

A: A buffer solution is formed by the weak acid and its conjugate base or weak base and its conjugate…

Q: Write the reaction between formic acid (Appendix B) and KOH. What is the equivalence volume (Ve) in…

A: As there are many subparts of the question and any specific subpart is not mentioned here, so solve…

Q: What is the pH of a buffer that results when 5.46 mole of H3PO4 is mixed with 2.97 mole of NaOH and…

A: · Moles of H3PO4 = 5.46 mol· Moles NaOH = 2.97 mol· Volume of solution = 1.00 L· Ka1 = 7.5 × 10–3

Q: Effect of the ratio of the conjugate base to the weak acid. CASE 1. From the Henderson-Hasselbach…

A: H2PO4- + H2O ⇔ HPO4-2 + H3O+ pH = pKa + log [Conjugate Base][Acid] pH =…

Q: Calculate the volume, in milliliters, of 0.170 M NaOH that must be added to 319 mL 0.0439 M…

A: pH of the solution can be calculated using the following equation: pH = pKa + log ([salt]/[acid])

Q: 4) How many grams of potassium azide (KN3, MM = 81.118 g/mol) are present in 250.0 mL of a pH 4.20…

A: Buffer is a solution which has a specific pH and resist a change in its pH when any acid or a base…

Q: 4.If the hydroxide concentration of a HNO3/NO3- buffer system is 0.00000025 M, what is the nitrate…

A: Given:   The concentration of hydroxide is 0.00000025 M. The concentration of nitric acid is 0.84 M.…

Q: Acetic acid and its conjugate base acetate can form an acid-base buffer.  The pKa of acetic acid is…

A: Given: Concentration of HNO3 = 10.0 M Concentration of acetic acid = 0.0100 M Concentration of…

Q: Use the titration curve for the weak acid to calculate the pH of a 0.150 M solution of that weak…

A: The pKa of the acid will be equal to the pH at half equivalence point which can be determined by…

Q: The following is a recipe for 10X SDS PAGE running buffer. The amount of SDS required to prepare 250…

A:

Q: Which acid-conjugate base system should you use to prepare a buffer with a pH of 9.0?…

A: pH = 9.0  According to Henderson hasselbach equation pH of buffer solution can be calculated as- pH…

Q: Calculate the volume, in milliliters, of 0.170 M NaOH that must be added to 409 mL 0.0463 M…

A:

Q: A biochemist working with bacteria requires a culture buffered at a pH of 3.6. Which of the…

A: Given that:  pH = 3.6 Buffer solution is mixture of weak acid and its conjugate base . Buffer…

Q: 25.00 mL solution of 0.100 M lactic acid (HC3H5O3, pKa = 3.85) is titrated with 0.100 M LiOH.…

A: The question is based on the concept of titrations.   we are titrating  a weak lactic acid with a…

Q: What is the equivalence volume in the titration of 50.00 mL of 0.010 0 M NaOH with 0.100 M HCl?…

A: Step 1: The balanced reaction of HCl and NaOH is: Calculation of equilvalence volume of HCl: Thus…

Q: Given a theoretical acid, HA, with a pKa of 6.52. Calculate the pH of 30.0mL of 0.400M HA, when it…

A: The total number of HA acids in the solution is determined below. nHA=MHA×VHA=0.400 mol/L×30.0…

Q: Your goal is to make a buffer with a pH of 4.75 from acetic acid and sodium acetate. Assume the pka…

A: Given: pH = 4.95 ; pKa=4.74 find x=?

Q: Calculate the volume, in milliliters, of 0.170 M NaOH that must be added to 305 mL 0.0409 M…

A:

Q: What is the acid component and base component of the buffer solution? What are the moles of each…

A: Since you have asked a question with multiple subparts, we will answer only first 3 subparts for…

Q: The Ka of bromoacetic acid is 2.00 ×10–3.  What masses of bromoacetic acid (CH2BrCOOH) and sodium…

A:

Q: For bromocresol green indicator, the pka of the indicator is about 4.7.  Estimate the pH range over…

A: Indicators are used to indicate the nature of the solutions when they are added to it by changing…

Q: What volume of 0.100M acetic acid and 0.100M sodium acetate would be required to produce 1.00 L of…

A: The ratio of concentrations of sodium acetate to acetic acid is equal to the ratio of number of…

Q: A 250.0-mg sample of an organic monoprotic weak acid was dissolved in an appropriate solvent and…

A: When acid is neutralized by a base then equivalent of both acid and base will be equal. We should…

Q: Consider the list of acids and their pKa values attached What two compounds would be best to use in…

A: Buffers are effective when the pKa values are closest to pH.

Q: Write the values of Y and X. H2SO4 CH;CH=CH2 + H2O CH3CH-CH2 H HỌ 2-propanol an alcohol The pKa of a…

A: The acid dissociation constant Ka is the representation of acidic strength of a solution and pKa is…

Q: What volume of 0.12 M HCl must be added to 1.5 g glycine amide to make buffer at pH 8.5?

A: The question is based on the concept of buffer preparation. we have been given glycinamide solution.…

Q: Consider the list of acids and their pKa values attached What two compounds would be best to use in…

A: A buffer solution performs best when the concentration of acid/ base is equal to the concentration…

Q: A sodium hydrogen carbonate/sodium carbonate buffer system is to be prepared with a pH of 9.89.  The…

A: The question is based on the concept of buffer solution.   A buffer is a solution which resist any…

Q: OOOO A 100.0-mL aliquot of 0.100 M diprotic acid H2A (pK1 =4.00, pK2 = 8.00) was titrated with 1.00…

A: The given acid is diprotic acid but at the first equivalent point, an equal mole of the acid reacts…

Q: Describe the preparation of 2 L of 85 mM phosphate buffer, pH 6.5, using 120 mM  NaH2PO4·6H2O and…

A: Given: total volume of buffer solution = 2 L Concentration of buffer solution = 85 mM Concentration…

Q: 3. Prepare a 250-mL buffer with pH = 4.40 from solid reagents benzoic acid (C6H5COOH; M = 122.123 g…

A: Given: Volume of buffer= 250 mL pH = 4.40 pKa of benzoic acid = 4.202 Molar mass of benzoic acid =…

Q: A buffer solution contains 0.10M benzoic acid (C6H5COOH, Ka = 6.3 x 105) and 0.10M assium benzoate…

A:

Q: What is the pka of the weak acid that gives the following pH curve when titrated with NaOH? 14.00…

A: The value of pH for titration of weak acid with strong base is calculated by Henderson-Hasselbalch…

Q: What is the appropriate acid-base indicator for the titration of 50.00 mL of 0.100 N NaOH with…

A: NaOH is a strong base and HCl is a strong acid. The titration will involve a sudden change from…

Q: If the hydroxide concentration of a HNO3/NO3- buffer system is 0.00000025 M, what is the nitrate…

A:

Q: What mass of NH4Cl (Mw = 53.492 g mol-1) has to be dissolved in 750 mL of 0.25 M NH3 (pKa = 9.26) to…

A: 750 mL of 0.25 M NH3 pKa = 9.26 solution is mixed with a certain amount of NH4Cl to prepare a…

Q: What volume of 1.00 M NaC2H3O2 should be mixed with what volume of 1.00 M HC2H3O2 to prepare 1.00L…

A: A buffer is a solution that can accept protons (by conjugate base) and donate protons (by acid) at…

Q: A particular buffer has been made up at 25 °C to give a pH of 8.00 and is then warmed to 35 °C. The…

A: The expression of Henderson-Hasselbalch equation is shown below:

Q: A 50.0 mL of acidic solute (Ka = 2.6 x 10-2) is titrated with a 25.0 mL of 0.001 M NaOH solution.…

A: Since you have posted multiple questions, we are entitled to answer the first only.

Q: indicator is best suited for the analyte?

A: PH lies between the pKin-1<pH<pKin+1

Q: Malonic acid is a dicarboxylic acid with structure CH2(COOH)2 with Ka1 1.5 x 10-3 and Ka2 = 2.0 x…

A: Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for…

Q: Your goal is to make a buffer with a pH of 4.75 from acetic acid and sodium acetate.  Assume the pKa…

A: Buffers are solutions that resists the change in pH on addition of small amount of acid or base to…

Q: A chemist generates the titration curve shown by slowly 12 adding 1.0 M sodium hydroxide (NaOH) to…

A: Ka is the acid dissociation constant for weak acid like acetic acid. When Ka is taken -log value ,…

Q: Use the titration data below to answer the following questions regarding the titration of an unknown…

A: Volume of NaOH(mL) pH 0 1.7 4 2 7 2.8 8 5 9 7.2 12 7.9 17 8.31 22 8.9 24 9.8 25…

Q: A sodium hydrogen carbonate/sodium carbonate buffer system is to be prepared with a pH of 9.89.  The…

A: Answer is explained below.  The given information are as follows:

Q: A weak acid (HA) with a pKa of 4.0 has a distribution constant of 5.2 between an organic and aqueous…

A: The fraction of HA acid in the organic phase at pH 2 and 6 is calculated:

Q: Determine the volumes of 0.10 M CH3COOH and 0.10 M CH3COONa required to prepare 10 mL of the…

A: The Henderson-Hasselbalch equation is given by

Q: Dr. Stone and Princess Bubble gum wanted to run an experiment to determine at what volume they will…

A: Given: Titration of CF3COOH with a pKa of 0.52 with 0.1 M NaOH.

Acid Base Titration

An acid-base titration is the method of quantitative analysis for determining the concentration of an acid and base by exactly neutralizing it with a standard solution of base or acid having known concentration.