Determine the reactions at supports A and B. The beam segments AC and CB are connected to eac other with a "web only" splice (shear connection) at C. As such, the splice at C can be considered as a internal pin (hinge). The beam AC sits freely, i.e. unconnected, on a support at A. Therefore, A can b taken as a roller support. Beam CB is attached to a column at B with channels both at the web (shear and the flanges (flexural). Accordingly, the connection at B can be considered as a fixed support. 6 kN/m 16 kN

Determine the reactions at supports A and B. The beam segments AC and CB are connected to eac other with a "web only" splice (shear connection) at C. As such, the splice at C can be considered as a internal pin (hinge). The beam AC sits freely, i.e. unconnected, on a support at A. Therefore, A can b taken as a roller support. Beam CB is attached to a column at B with channels both at the web (shear and the flanges (flexural). Accordingly, the connection at B can be considered as a fixed support. 6 kN/m 16 kN

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

From the given indeterminate beam, the reaction at B and C are assumed to be the redundant and are both going upward. If downward displacement is assumed positive, which of the following is correct compatibility equation taken at point C? P₁ B Ac-By fBc-Cyfcc = 0 Ac+By fcB + Cyfcc = 0 Ac-By fcB-Cyfcc = 0 Ac-By fcs + Cyfcc = 0 P₁
describe the load acting on the beam determine the reactions RA and RB at the supports determine the maximum bending moment Mmax
the truss shown in the below figure is supported by a hinge at A and a link BC. Determine the components (magnitude and direction) of the reactions at A and B
The rigid truss supports the loads shown. (Assume that the +x-axis is to the right and the +y-axis is up along the page.) Find the reactions in kips the pin A and roller D exert on the truss. All concentrated loads act on the pins joining the truss members. Magnitude and Direction Magnitude in Kips Ax - ? Ay- ?
Determine the reactions at the supports and draw the bending moment diagram for the following structures. Verify the results the RISA-2D. (Ans : Ay=12.483kN, M₁--10.388kNm, By-22.885kN, Cy=12.632kN) 5kN/m 21 5m 20kN 2m 2m 3kN I 3m D
determine the magnitude of the pin reaction at a and c. neglect the weight of the members
Also determine the reactions at the pin support A2 Determine the reactions at the pin support A2 With units
Determine the reactions at the supports for the following structures by using the bending moments over support A and B as the redundant forces(unknown).Verify the results the RISA-2D.
Determine the Reactions at A and D, by following these steps: - Show the Unknown Reactions at the supports on the diagram - Cut a FBD through the hinge at C and determine the Reactions at D and the Internal Forces at C - From FBD ABC, determine the Reactions at A - Check answers by summing moments at C for the Total FBD
Determine the reactions at the supports of the truss structure. Observe that thesupport at A is a pin and the support at B is a roller
A plane truss is loaded as shown: It has a roller support at A and a pin support at B. Find the reaction at B
Solve for the support reactions and draw and label the SFD and BMD