Determine the Level of Service for the following details of a six-lane urban freeway (three lanes in each direction): Use fp = 1.0 a. Level terrain with 12 ft lanes b. Obstructions 4 ft from the right edge of the traveled pavement c. Nine ramps within 3 miles upstream and 3 miles downstream of the midpoint of the analysis portion d. Peak-hour volume of (1,704) vehicles e. 480 vehicles during congested 15-min period f. Number of lanes in each direction, N = 3

Determine the Level of Service for the following details of a six-lane urban freeway (three lanes in each direction): Use fp = 1.0 a. Level terrain with 12 ft lanes b. Obstructions 4 ft from the right edge of the traveled pavement c. Nine ramps within 3 miles upstream and 3 miles downstream of the midpoint of the analysis portion d. Peak-hour volume of (1,704) vehicles e. 480 vehicles during congested 15-min period f. Number of lanes in each direction, N = 3

Traffic and Highway Engineering

5th Edition

ISBN:9781305156241

Author:Garber, Nicholas J.

Publisher:Garber, Nicholas J.

Chapter9: Capacity And Level Of Service For Highway Segments

Section: Chapter Questions

Problem 4P

See similar textbooks

Similar questions

A six-lane freeway (three lanes in each direction in mountainous terrain has 10-ft lanes and obstructions 1ft from the right edge. There are five ramps within three miles upstream of the segment midpoint and four ramps within three miles downstream of the segment midpoint. The traffic stream consists of mostly commuter with a peak hour factor of 0.84, peak-hour volume of 2500 vehicles, and 4% recreational vehicles. What is the level of service?
A six-lane freeway (three lanes in each direction) in mountainous terrain has 10-ft lanes and obstructions 1 ft from the right edge. There are five ramps within three miles upstream of the segment midpoint and four ramps within three miles downstream of the segment midpoint. The traffic stream consists of mostly commuters with a peak hour factor of 0.84, peak-hour volume of 2500 vehicles, and 4% recreational vehicles. What is the level of service? (Write the letter only)
A basic segment of a rural freeway has the following characteristics: • Four-lanes (two lanes in each direction)%3B There is one ramp within 3 miles upstream, and 2 ramps within 3 miles downstream; 10-ft lanes; Right shoulder width of 4 ft; • Level terrain;. 10% trucks and 5% buses in the vehicle stream. Calculate the FFS at this freeway section and then determine the level of service (LOS) when the flow rate is 1740 pc/h/In. (Write the answer for the LOS in the box below).
A new section of Richmond Highway is being designed as a six-lane facility (three ineach direction) with a two-way left-turn lane. Determine the peak-hour LOS.Traffic data:• Directional design hourly volume = 3600 veh/h• PHF = 0.94• Assumed base free-flow speed = 55 mi/h (88 km/h)Geometric data:• Urban setting• Rolling terrain• Lane width = 11 ft (3.3 m)• Shoulder widths = 4 ft (1.2 m) (right side) and 1 ft (0.3 m) (left side)• Average access point spacing = 12 points per mile on each side
A new section of a freeway is to be designed with a free-flow-speed of 65 mph along of 0.75 mile on 5% upgrade. The expected traffic volume is 4200 v/hr. The traffic composition is 15% trucks, 5% recreational vehicles, and 10% buses. The peak hourly factor is 0.9, the unfamiliar driver factor is 0.95. If the design requirement is to target a level of service (B), how many lanes must be provided to satisfy the design requirement?
ramps within 3 miles upstream and downstream of the segment midpoint. It is on rolling terrain with 10% heavy vehicles and is operating at capacity with a peak-hour factor of 0.9. If the road is expanded to four 11-foot lanes with a 2-foot right shoulder, and traffic after the expansion is projected to increase by 10% with the same heavy vehicle percentage and peak-hour factor, what is the new LOS and estimated density? P-22 Chapter 6 Problems hour. What would be the LOS before and after the heavy vehicles are allowed on the upgrade (assuming 50% SUTs and 50% TTs.)? 6.21 A multilane highway has four lanes (two lanes in each direction) and a measured FFS of 55 mi/h. The directional peak-hour volume is 1900 vehicles (the peak-hour factor is 0.80). One upgrade is 5% and is 0.62 mi long. Currently, heavy vehicles are not permitted on the highway, but local authorities are considering allowing heavy vehicles on this upgrade. If this is done, they estimate that 150 heavy vehicles will use…
An existing urban freeway with 4 lanes in each direction has the following characteristics. Traffic data: Peak hour volume (in the peak direction): 7,110 veh/h Trucks: 10% of peak hour volume PHF = 0.93 Geometric data: Lane width: 11 ft Shoulder width: 6 ft Total ramp density: 1.8 ramps per mile Terrain: rolling Determine the LOS in the peak hour. (Assume commuter traffic and assume no RVs.) LOS A LOS B LOS C LOS D LOS E LOS F Show the demand flow rate (in pc/h/ln), mean speed (in mi/h), and density (in pc/mi/ln) for the given conditions. demand flow rate pc/h/lnmean speed mi/h density pc/mi/ln
QUESTION 1 A four-lane urban freeway segment has a peak demand volume of 3,500 vehicles per hour for the two eastbound lanes. The PHF is 0.95 and there are no trucks, buses or RVs because the freeway is classified as a parkway and such vehicles are prohibited. The segment has 12 ft lanes, no lateral obstructions, 3 ramps within the influence area, and meanders through some beautiful rolling terrain. Assuming the road will be used by commuters and those familiar with the road, what is the flow rate (pcphpl)? Provide your answer to the nearest integer.
An existing urban freeway with 4 lanes in each direction has the following characteristics. Traffic data: Peak hour volume (in the peak direction): Trucks: PHF = 0.93 Geometric data: LOS A OLOS B LOS C LOS D LOS E LOS F Lane width: Shoulder width: Total ramp density: Terrain: rolling 11 ft 6 ft 1.8 ramps per mile Determine the LOS in the peak hour. (Assume commuter traffic and assume no RVs.) 7,090 veh/h 10% of peak hour volume Show the demand flow rate (in pc/h/In), mean speed (in mi/h), and density (in pc/mi/In) for the given conditions. demand flow rate 2191 pc/h/In mean speed density 50 X mi/h 43.82 X pc/mi/In
A two-lane rural highway carries a peak hour volume of 465 (vph) and has the following characteristics: Roadway: 60mph design; 11 foot lanes, 2 foot shoulders; rolling terrain; 60% no-passing zones; length = 3 miles. Traffic: 70/30 directional split; 4% trucks; 2 percent recreational vehicles; 1 percent buses; PHF = 0.95 a) What Level of Service will the highway operate under during peak periods? b) What is the capacity of the highway? Explain why this is less than 2,800 (vph)?
(a) A six-lane freeway (three lanes in each direction) has regular weekday users and currently operates at maximum LOS C conditions. The lanes are 11 ft wide, the right-side shoulder is 4 ft wide, and there are two ramps within three miles upstream of the segment midpoint and one ramp within three miles downstream of the segment midpoint. The highway is on rollingterrain with 10% large trucks and buses (no recreational vehicles), and the peak-hour factor is 0.90. Determine the hourly volume for these conditions.
The details of a 12-hour volume study for a 4- leg road junction are tabulated below. The N-S major road has two through lanes on each approach while the E-W minor road has one through lane on each approach. Examine the fulfilment of traffic signal Warrants 1 (Condition B) using the MUTCD 2009 standards. Minor Rd. (Higher Major Rd. (Total of approaches) Hour Start approach) Hr 1 Hr 2 Hr 3 734 98 880 122 850 120 Hr 4 955 100 Hr 5 941 105 Hr 6 915 95 Hr 7 1040 140 Hr 8 1010 150 Hr 9 790 156 а. W1B is not met b. W1B is met