Design the given amplifier circuit according to followings specifications; Zi=97.97 K, Av-207.85 VA1-20 V, VA2-19.8 V, VCEI-10 V, B-99. V1 is the de voltage and Vi is sinusoidal input voltage. Vi 2K V1 1/99mA Τ1 R1 T2 12 2mA ww R2 Vo =C3

Q: R₁ www www R₂ www Rc- Answer: RE +Vcc In the figure presented Vcc = 14 V, R₁ = 589 k2, R₂ = 499 kn,…

A:

Q: 4. Given Vin (t) 5 cos 5x10 3 t + 1000m 0.1 h 865 Ω

A:

Q: 7. 2/0° A -j2 n j40 12/0° V 202² + Va Solve problem using loop analysis.

A: For this given circuit we need to find output voltage by using loop analysis method. Figure:-

Q: In the following diagram, what does the symbol in (a) represent? a. N-channel enhancement-MOSFET O…

A: a)N-channel enhancement MOSFET   The N-channel enhancement MOSFET is designed with a lightly doped…

Q: 1. Assume a parallel resonant circuit is constructed from a 200 µH inductor with 9.502 of resistance…

A: We need to find out resonance frequency and quality factor and bandwidth for given parallel RLC…

Q: 0.2 A three-phase 800kVA, 11kV (line to line), the star-connected synchronous generator has R=1.5 22…

A: In this question we need to find the following when a load of  600 KW , 0.8 pf leading applied to…

Q: The common-drain stage in the following figure has the following component parameters: RG = 900 KS,…

A: The above problem involves the analysis of a common drain (CD) MOSFET amplifier.

Q: Using Fig. P12.40, at what frequency does the quadratic pole break (the 3dB frequency of the…

A: Let ω1=t1 rad/sec=0 rad/sω2=15 rad/sω3=44 rad/sω4=561 rad/s

Q: 8. A closed-loop system is shown in Figure Q8 below. Gain, K, is positive. (i) (ii) Figure Q8 (a) Is…

A:

Q: Q2: For the amplifier in Figure 2, determine the following: (a) Ack(ND) (b) Vout (c) Vf Vin 10 mVrms…

A:

Q: Problem 5 R₁ 0,5 Ω ww R₂ 0,5 Ω ww R3 = 0,25 Ω Vs 3 V R4 0,33 Ω Following the algorithm of the…

A:

Q: QUESTION 2 The switch shown in the circuit of Figure 2 has been in position a for a long time. At…

A: We need to determine the current i(t) for  t≥0.

Q: For the circuit in the below figure, C = 33 uF, L = 150 mH, R1 = 560 Ohm, R2 = 360 Ohm, |vs| = 120 V…

A:

Q: For the network in the figure: a. Determine re. b. Find Av = Vo / Vi. C. Calculate Zi. and  Zo.

A:

Q: (i) (ii) (iii) :4Ω Solve the circuit using mesh or super mesh analysis. Find the voltage across 802…

A:

Q: a) Find the node voltages U1, 02, and v3 in the cir- cuit in Fig. P4.21. b) Find the total power…

A: It is given that: We need to determine a) The node voltages V1,V2 and V3. b) The total power…

Q: At terminals a-b, find Thevenin and Norton equivalent circuits for the network depicted in the…

A:

Q: I purchased an electric heater that draws 5 from a 34 outlet. Determine the power consumed by the…

A: This question is based on power rating of an electrical appliance.

Q: +1+ 30 VDC O 3.43 V O 1.43 V O2.43 V O 0.43 V O 4.43 V R2 1k ohms R1 120 ohms R3 2.4k ohms What…

A:

Q: Prob 4.3 A point Q is located at (a, 0, 0), while another charge -Q is at (-a, 0, 0). Find E at: (a)…

A: Point charge Q at (a, 0, 0) And point charge -Q at (-a, 0, 0)

Q: A 40 MVA, 11 KV, 3-phase, 50 Hz, 4-pole turbo alternator has an inertia constant of 15 sec. An input…

A: VA rating, S = 40 MVA, Voltage V = 11 kV Number of poles P = 4 Frequency, f = 50 Hz, Inertia…

Q: Vs (+1) R1 www + R2 Vout R3

A: We need to find out the output voltage for given circuit.

Q: SERIES AND PARALLEL AC CIRCUIT DETERMINE THE TOTAL IMPEDANCE, TOTAL CURRENT, AND POWER FACTOR OF THE…

A:

Q: How to create a procedure to solve any DC circuit with any number of resistors?

A: Let R1  R2 and R3 connected in seriesReq=R1+R2+R3Let R1  R2 and R3 connected in…

Q: Derive the Fourier coefficients for the periodic voltage shown in Figure 3 below, if Vm is 100…

A: Given: A periodic signal voltage wave form,  with, Vm=100π, To find: Fourier series coefficients.

Q: Find ic(t) and i(t) in the network given: i() D() = 120 cos (5000) V + 6002 16 mH 2.5 μF

A: The given circuit diagram is, To find the value of iCt and it in the network.

Q: The two figure panels show two ways to connect a real (non-ideal) voltmeter and a real ammeter in a…

A:

Q: Two BJT transistors Q1 and Q2 are identical. MOSFET parameters are: V₁-1V, K-3 25mA/V², λ=1/100…

A:

Q: Refer to Conceptual Example 11 as an aid in solving this problem. An intergalactic cruiser has two…

A: It is the fundamental particle of light. It has both characteristics of light and wave. It can be…

Q: A resistor with 870.0 2 is connected to the plates of a charged capacitor with capacitance 4.66 μF.…

A:

Q: Part (a): The magnetic flux linkage in a single turn of the inductor can be calculated as, p = [B·ds…

A: Inductance of inductor depends on Type of material used Number of turns Cross sectional area Length…

Q: 3. Find the reactive power delivered by the current source, and the power factor of the circuit if…

A:

Q: 4. Write a complete set of equations describing the circuit in s-domain replacing the sinusoidal…

A: In this question we need to write the given circuit in s domain

Q: Solve for Vo Using Norton's theorem. Please Do not use any other methods to solve. Vs = 12∠0° V and…

A:

Q: 3. Convert the circuit (ladder diagram) to a Boolean expression. L₁ Figure 1 L₁ Figure 2 A B A B A A…

A: it is asked to convert given ladder diagram to boolean expression

Q: For baseband signaling with a bit interval To, consider a pulse shape: P₁(t) = A 27₁ (a) Sketch the…

A:

Q: 1. Find the equivalent inductance. Leq RIBUTE 20mH 60mH 10 MH tribution to je @mapua.edu somH APÚA…

A:

Q: Find VGS, ID, and VDS- 10V VIN k₁ = 100µA/V² n 20k = -3V = λ=0

A:

Q: The relationship between the input x[n] and output y[n] of a causal digital filter is given as…

A: As per the guidelines of Bartleby we suppose to answer first three subpart only for solution of…

Q: 1. 8.1.1 Given i(t) = 5 cos(400t - 120°) A, determine the period of the current and the frequency in…

A: The given problem is from basic of sinusoidal.  The formula and concept are given in the next steps.…

Q: the table is wrong

A: Need to analyse the stability of the given system by using the routh Hurwitz criteria.

Q: *43. The Y-Y system of Fig. 22.48 has a balanced load and a line impedance Zine=42+j 2002. If the…

A:

Q: Determine the output sequence of the system with impulse response 1 h(n) = (-)"u(n) when the input…

A:

Q: Earth to a distant planet is 9 x 10^10 m. A 64 Mbps point-to-point link using a stop-and-wait…

A: In computer networks, the utilization of a communication channel is an important factor in…

Q: 3) Use the loop current method to determine the power dissipated in the 2 ohm resistor in the…

A: Given: A network,  To find: Power dissipated in 2Ω resistor using loop current method.

Q: Q1.4 Determine Vo Q1.5 Determine io. t = 0 1.25 Η + +)2A Σ10Ω 310 H v 24 t = 0 YYL 36H 7.5 ΚΩ

A: Circuit

Q: Find the steady-state torque–speed relation for a compound-wound motor. The following parameters are…

A:

Q: An electromagnetic wave in far field (plane wave) meets an aluminum device box that has no holes.…

A:

Q: Q2 (iii) In the space provided below, sketch the locus of the closed-loop poles of a standard…

A: The root locus for the given system needs to be drawn and the value of k and its respective location…

Q: Explain this diagram

A: The given diagram is shown below. We need to explain the diagram. Here the axis-z is the axis of…

Operational Amplifier

An operational amplifier also called op amp is an integrated circuit or analog circuit that takes input as a differential voltage and produces output as a single-ended voltage. It is an IC that can amplify weak electric signals.An op amp has one output pin and two input pins. The basic role of an opamp is to amplify the voltage difference between the two input voltages. It is also used in filtering or to perform mathematical operations or in signal conditioning.