Answered: Describe the components of a filter…

Describe the components of a filter fluorometer and a spectrofluorometer. Why are fluorometers often more useful than spectrofluorometers for quantitative analysis?

Fundamentals Of Analytical Chemistry

9th Edition

ISBN:9781285640686

Author:Skoog

Publisher:Skoog

Chapter4: Calculations Used In Analytical Chemistry

Section: Chapter Questions

Problem 4.2QAP

See similar textbooks

Related questions

Q: Account for the versatility of thin-layer liquid chromatography.

A: Answer - Thin layer liquid chromatography - Thin-layer liqid chromatography is a chromatography…

Q: The partition coefficient(k)of a substance between petroleum ether and water is 6. A substance of…

Q: The following calibration data were obtained by an atomic absorption spectrophotometric (AAS) method…

A: Calculation for the above questions given below.

Q: What are the common components of the buffers used in hydrophobic column chromatography? Explain the…

Q: 1. Discuss briefly the specifications and test parameters for system suitability for HPLC analysis.

A: Important Parameters used in HPLC analysis are as follows: 1). Retention time (tR): It is the time…

Q: Spectrophotometer device must contain the photocell. 2- The main differences in parts of colorimeter…

A: 1. A photocell is a device used to convert light energy into electrical energy.

Q: A 5.3 × 10-2 M solution is to be used to prepare a series of five 100 mL solutions of varying…

A: So basically, we are diluting the 5.3 X 10-2 M solution, every time taking 10 mL of it. As per the…

Q: Distinguish between voltammetry and amperometry

A: 1) Voltammetry is an analytical technique in which variable potential is applied to the working…

Q: Write three substances or species that can be determined using each of the following instrumental…

A: Introduction: A pH meter is a device used to measure the hydrogen ion activity in the solution. The…

Q: Consider a damping system consisting of 0.250 M HCN (Ka = 4.9 x 10-10) and 0.170 M KCN. What is the…

Q: What are the advantages of evaporative-light scattering detector when used with high-precision…

A: ELSDs are aerosol-based HPLC detectors which work by converting the eluents of target components…

Q: In reversed phase HPLC, how will the retention time of a component of a mixture vary with the…

A: Retention time is a measure of the time that is taken by a solute to pass through a column.In…

Q: A standard solution was prepared containing 10.0 ppm of an analyte and 15.0 ppm of an internal…

A: Given information: Concentration of analyte is represented as (CA)= 10 ppm Concentration of internal…

Q: Indicate which other analytical techniques TGA can be coupled with and what would be the advantages?

Q: A monoprotic acid (HA) with a Ka of 1.62 x 10-³ has a partition coefficient of 9.0 (favoring hexane)…

A: Given: Ka = 1.62 ×10-5 Partition coefficient, K = 9.0 At pH = 6.55 pH = -log[H+]…

Q: The following volumes of a solution containing 1.10 ppm Zn2+ were pipetted into separatory funnels…

Q: How do you find the Ksp and solubility limit for Sr(IO3)2 given [IO3]=0.00879366 & [Sr]=0.00439683?

A: The answer to the following question is-

Q: A) A cylinder has a mass of 300. g, and a density of 2.0 g/cm3. What is the radius of the…

A: Given Information: Calculations: The volume of the cylinder is calculated as shown below. Let the…

Q: What was the average delta t for part 1? From your observations about the experiment, which…

A: Exothermic reactions are those types of reactions in which energy is released in the form of heat…

Q: 1. at what wavelength was Pb determined? 2. What is the slope of the calibration curve? 3. What is…

A: 1. at what wavelength was Pb determined? 2. What is the slope of the calibration curve? 3. What is…

Q: What do you understand by Isocratic and Gradient elution?

A: Isocratic Elution : In the light of chromatography isocratic elution means that the composition of…

Q: size exclusion chromatography

A: The size exclusion chromatography can be used to determine the quaternary structure of the proteins…

Q: What are the benefits of Zeeman correction in electrothermal atomization (ETA)? a. Zeeman background…

A: The method used for the determination of the chromium present in the low traces and ultraraces…

Q: Give the rationale behind major steps in the analysis such as blending, filtration, heating of the…

A: Mixing of chemical substances is an interaction through which various chemicals are consolidated…

Q: Analytical Chemistry Describe the formation of plasma and its functions in ICP-MS technique

A: A plasma is essentially an ionised gas, consisting of positively-charged ions and free (unbound)…

Q: 7-2: Why do quantitative and qualitative analyses often require different monochromator slit widths?

A: 7-2 The monochromator is a wavelength selector that is used to select a particular wavelength from a…

Q: 1.A double beam UV-vis spectrophotometer accommodates the sample at the cell farther from the…

A: Hi, we are supposed to answer one question. To get the remaining questions solved please mention the…

Q: What are the disadvantages of uses the Thick Layer stationary phase in Thin Layer Chromatography…

A: What are the disadvantages of uses the Thick Layer stationary phase in Thin Layer Chromatography…

Q: ) -SH -OCH₂ -NO₂ silica column 20% CHCI₂ 6 Time (min) 8 -CIN 10 -OH -CO₂CH₂-COCH, CHO 12 -NH₂ 400…

A: Silica Column is eluted by 29% CHCl3. Now in the given graph elution time of different compounds are…

Q: The partition coefficient of ammonia between water and chloroform is wanted to be determined. The…

A: In this question determine concentration of ammonia in water and chloroform with the help of HCl and…

Q: A 36.0 mg sample of an organic compound (molar mass = 84.0 g/mol) is dissolved in 10.0 mL of water.…

A: Given:Mass = 36.0 mgmolar mass = 84.0 g/molVolume of water = 10 mLMass of Organic compound after…

Q: Explain the purpose of the collision cell in interface between inductively coupled plasma and mass…

A: ICP-MS (inductively coupled plasma-mass-spectrometry) is a technique to determine low-concentrations…

Q: Under what wavelength (in nm) should a spectrophotometer be set to be able to measure the optical…

A: 1. Answer - At 600 nm wavelength (in nm) should a spectrophotometer be set to be able to measure…

Q: What is the concentration meant by inner filter effects?

A: The concentration for inner filter effects .

Q: Let the retention factor of species A be 0.2 while the retention factor of species B be 0.4. If…

A: The factor reflecting the dissolving/soluble capacity of any pigment in known solvent is designated…

Q: Explain why TLC cannot be used for some volatile low molecular weight substances such as toluene.

A: Thin layer chromatography, a thin layer is pressed over the chromatographic plate. A drop or small…

Q: The student was supposed to measure the pH of a 0.1 M hydrochloric acid solution. For this purpose,…

A: Concentration of HCl = 0.1 M

Q: The particle size of the silica gel influences the quality of the separation in column…

A: The column chromatography involves the separation of a single compound from the mixture of fluid.…

Q: what is the purpose and what is it for Spectrophotometric of a Cobalt Chloride Solution Analysis?

Q: why is a red filter is needed when a Spectronic 20 is configured to make analyses out .into the near…

A: Spectronic 20 is a single beam spectrometer which operate in visible region of length 340-950nm and…

Q: In the context of chromatographic separation, discuss Eddy diffusion, longitudinal diffusion, and…

Q: Protein Concentration Standard Curve 0.7 y= 0.042x + 0.0378 R = 0.9867 0.6 0.5 0.4 0.3 0.2 0.1 10 12…

Q: The following data are for a series of extemal standards of Cd² buffered to a pH of 3.7. [Cď*], nM…

A: According to the given data, it can be observed that the intensity of the signal increase with the…

Q: Which of the following is TRUE regarding instrumental methods of analysis? A. these methods have…

Q: Estimate the concentration of nitrate in the aquarium water. Aquarium water was diluted from 1 mL to…

A: According to the mole concept, in terms of mass, the amount of substance in moles is equal to the…

Q: Indicate the order of elution of the following compounds from a normal-phase packed HPLC column a.…

A: Several compounds mixed in any particular solution mainly separated by utilizing the technique…

Q: I am not sure how to do number 10

A: Molarity of compound is the number of mole per unit volume in liter and it can be determined…

Concept explainers

Spectroanalytical Methods

Spectroanalytical methods measure the wavelength and intensity of radiations that are either emitted or absorbed by a molecular or atomic species. These methods are useful for evaluating the electronic or atomic arrangement of the molecules of a given analyte.

Question

Describe the components of a filter fluorometer and a spectrofluorometer. Why are fluorometers often more useful than spectrofluorometers for quantitative analysis?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

The researcher extracts a sample of well water and prepares it for TXRF analysis with a 10.00 mg/L V internal standard, like the calibration standards. The result produces SCa = 69297.81 and SV = 13481.2.Determine the concentration of Ca.
What is the actual or real-life application of precipitation gravimetric analysis? Include the specific methodology.
Discuss the advantages, disadvantages, and limitations of the technique of cyclic voltammetry in both qualitative and quantitative measurements.
What are the advantages and disadvantages of using external standards in instrumental analysis?
Distinguish between TSS and TDS to understand why one is a physical parameter and the other is a chemical parameter.
TLC was used to compare the solubility of two compounds A and B in a solvent system (acetic acid, methanol, H2O). The distances that solvent has moved in the silica gel TLC was 12 cm. and for the compounds were 2 and 8 cm respectively. (a) Calculate the Rf values and which compound is more soluble and which one is more polar. (b) What are the factors affecting the Rf value
Differentiate acidimetry from alkalimetry
A 36.0 mg sample of an organic compound (molar mass = 84.0 g/mol) is dissolved in 10.0 mL of water. This aqueous solution is extracted with 5.0 mL of hexane. Separation and analysis of the aqueous phase shows that it now contains 12.0 mg of the organic compound. Calculate the partition coefficient for the compound between hexane and water (Kphexane/water). Your answer should reflect the proper number of significant figures.
What is the correlation of the density of the saltwater mixture and the brightness of the bulb?
Discuss three practical applications of solvent extraction in analytical chemistry.
One method for quantitative determination of the concentration of constituents in a sample analyzed by gas chromatography is the area normalization method. In this method, complete elution of all of the sample constituents is necessary. The area of each peak is then measured and corrected for differences in detector response to the different eluates. This correction is accomplished by dividing the area by an empirically determined correction factor. The concentration of the analyte is found from the ratio of its corrected area to the total corrected area of all peaks. For a chromatogram containing three peaks, the relative areas were found to be 16.4, 45.2, and 30.2 in the order of increasing retention time. Calculate the percentage of each compound if the relative detector responses were 0.60, 0.78, and 0.88, respectively
A water sample was analyzed for Fe content using the iron-phenanthroline method. The following data were obtained from the analysis: Determine the value of the slope (m), y-intercept (b), and the coefficient of determination (r2)