Decide on the required number of wind turbines needed. 2. In your own words, explain what the Betz limit for wind turbines means

Q: A: Set three of the most important electrical generation stations, and give at least one advantage…

A: 1.Thermal power generation. This is the most widely used power generation method  Adv: 1.bulk power…

Q: ock diagram of Arduino car Detector and explain operating

A: The Digital OUT of the first IR Sensor is connected to Pin 11 of Arduino and the Digital OUT of the…

Q: Set three of the most important electrical generation stations, and give at least one advantage and…

A: Nuclear power plant:   Nuclear power plant are the kinds of power plant that uses the nuclear…

Q: With neat sketch explain the types and operation of oil circuit breaker

A: Types of the circuit breaker, 1. Low oil circuit breaker 2. Bulk oil circuit breaker Plain break…

Q: Identify the minimum distance requirements between network cables and power sources and identify…

A: Cable is the medium in a network through which information moves from one network device to another.…

Q: What is the difference between MCB and ELCB? Give one example each for Radial and Ring Circuit?…

A: In this question we will write difference  about MCB and ELCB ...Also example of ring and radial…

Q: What is the meaning of the acronym, XLPE? A. EXTRA LOW POLYESTER EQUIPMENT B. CROSS-LINED POLYETHYL…

A: In this we will write about XLPE....

Q: A bolted line to line short circuit is used to determine the thermal withstand rating of the cables…

A: The power system has to transmit power from the generation side to the load side. For this purpose,…

Q: Choosethe correct answer 3)The prerequisite for the reduction of systematic errors is a complete…

A: The prerequisite for the reduction of systematic errors is a complete analysis of the measurement…

Q: Suppose that you have a task of measuring the lengths of a bridge and a rivet and come up with 9999…

A: Given  measured value=9999cm and 8cm for rivet=8cm True value of rivet=9cm

Q: homeowner wants to add 12 general-purpose receptacle outlets to the electrical drawings before the…

A: Please refer the attached images for the complete answer..

Q: Write short note on the below mentioned questions, Each question carries one mark. Students has to…

A: AS PER OUR GUIDELINES ONLY THREE QUESTIONS ARE ANSWERABLE   a) High Voltages are Preferred for…

Q: Part 2: Analysis and selection of the Wind Turbine. The team decides at install a 30 MW wind farm.…

A: Given Installed power P = 30 MW Wind speed = 6 m/s

Q: A-) Explain with the help of diagrams the structure and operation of Hybrid (Magic) Tee

A: A tee in microwave use to connect a section of waveguide in series or parallel to the main…

Q: List the main differences between probabilistic and deterministic methods for analyzing the…

A: Probabilistic approaches provide quantitative indicators that may be used to determine if the…

Q: b) According to your diagram, express the absolute method error in power measurement by defining the…

A: b)

Q: Part 2: Analysis and selection of the Wind Turbine. The team decides at install a 30 MW wind farm.…

A: 1: Analysis and selection of the Wind Turbine.The team decides to install a 30 MW wind farm. The…

Q: What is the mean of wiring

A: Wiring is the term used for the supply system design, connection, and protection schemes employed…

Q: Overcurrent devices do not have to be readily accessible if ____. Select one: A. LOCATED WITHIN A…

A: Overcurrent devices do not have to be readily accessible if LOCATED ADJACENT TO THE EQUIPMENT WHERE…

Q: How many numbers

A:

Q: Which of the following must be notified prior to equipment shutdown for repair? a. Director of…

A: In this question we will write Which must be notified prior to equipment shutdown for repair..

Q: 1. He doesn't need to ....... A lot of time (get, got, getting) 2. We are ....... A short story…

A: 1) The given sentence is in simple present tense. Therefore, He doesn't need to get A lot of time.…

Q: write paragraph about how to concat and installation circuit breaker with socket ,what is…

A:

Q: The graphical method used to analyze the stability of the power system is?

A: A technique known as the equivalent region rule can be utilized for a fast expectation of…

Q: Explain with a neat block diagram the measurement of displacement using RTD (measuring system).

A: Thermistor is a special type of Resistor whose resistance changes with the change in temperature.…

Q: In your own words and from your own understanding, avoid plagiarism or copying from the Course…

A: we need to explain the molded case circuit breaker

Q: recommended the testing of wiring installations for domestic load

A: A

Q: . The only exception to the need for all information technology equipment to be satisfactorily…

A: Equipment grounding is mainly done for user protection.it is a non-current carrying element. A. In…

Q: Draw the Direct Digital Control block diagram and show the Implementation of the Problem using a…

A: We have given the problem Draw the Direct Digital Control block diagram and show theImplementation…

Q: The thickness of the layer of Insulation of an Underground Cable depends upon the Voltage to be…

A: In a conductor, The voltage gradient is developed along the length of the conductor which decreases…

Q: (c) Draw a circuit diagram to represent a TN-C-S earthing system and briefly explain its advantages…

A: “Since you have asked multiple questions, we will solve the first question for you. If youwant any…

Q: Draw the circuit diagram of Two quadrant chopper which is having average load voltage might be…

A: to draw the circuit diagram of Two quadrant chopper which is having average load voltage might be…

Q: Lockout is required: During servicing and maintenance where unexpected ener- gization or start-up of…

A: Bartleby has policy to solve only first question and if it has subparts then solve only first 3…

Q: Question no 1: Discuss the basic requirement to consider while selecting a suitable location for…

A: To Discuss the basic requirement to consider while selecting a suitable location for placement of…

Q: An electrical transmission line cable is supported between towers 150m apart. If the cable weighs 30…

A:

Q: Explain in detaill the benefits of using robotic car for wildlife observation rather then camera…

A: The great advantage of camera traps is that they can record very accurate data without disturbing…

Q: A passenger arriving in a new town wishes to go from the station to a hotel located 10km away on a…

A: Given that  Distance from station to hotel is 10 km  Distance travelled is 23 km  Time taken to…

Q: 11. Which of the following is the drawback for cordless telephones? a) Security b) Wireless…

A: The correct option along with the explanation is provided in the following section.

Q: Explain what is Grid system

A: The Grid system is a network to deliver electricity from producer to consumer.

Q: Explain why the risk of electric shock is greater with a.c. portable appliances than with fixed…

A: Electricity hazard is the most dangerous one as it do not provide advance warning od danger. Dealing…

Q: find the following parameters for the arcust below

A:

Q: Function of electrical system in a vehicle.

A: Electrically operated equipment in a vehicle, automobile electrical systems get energy from the…

Q: C.Comments on this statement: "PMUs can be used as a protective relays”. D. What is the ZIB and it…

A: NOTE: Since we can solve only 3 parts, so solving 1st three parts. Sorry for the inconvenience…

Q: . What is called Power Transistor? Write the classifications.

A: The devices designed for smaller voltages and smaller current ratings, are the analog devices. The…

Q: How do you manufacture a special wireless device for security What materials will it be? Use as an…

A: Please find your answer below Consumer and commercial equipment differ in a number of ways;…

Q: A 4.5-kVA, 240 volt electric clothes dryer contributes _____ amperes to the neutral load , when…

A:

Q: 5. Labeling the pin numbers of 7432 IC

A: 7432 has 4 OR gates of 2 inputs in 1 package.

Q: Air Blast Circuit Breaker

A:

Q: A sound level meter is placed in front of a loudspeaker of a 60W audio system reads 70dB. All else…

A: Energy travels from one point to other in the form of vibrations. Sound wave is one such form of the…

Electrical Heating Unit

The conversion of electrical energy to heat energy is known as electric heating. The heating system that converts the electrical energy to heat energy for various application is called electrical heating unit. Electricity is employed as the firing mechanism in electric heating systems, which transforms electric current to heat. Electric heaters have heating elements in the form of electric resistors.