Consider a silicon pn junction solar cell at 300 K with a reverse saturation current of 1x107 ampere. Calculate the open-circuit voltage of this solar cell when the photocurrent is 3.6 ampere. Lütfen birini seçin: O 0.35 volts O 0.5 volts 0.55 volts 0.45 volts O 0.15 volts

Q: In the reverse bias region, the saturation current of a silicon diode is about 0.1micro Amperes at…

A: The solution is given below

Q: In order to reduce the reverse recovery time of the diodes, __________ is carried out. a. adding an…

A: Correct Option : D).

Q: (i) For the silicon diode circuit of Figure Q1 (b(i)) Determine ID, Vp2 and Vo. + 字 Da Vo +12v DI…

A: The given circuit is

Q: 2. Design a power supply by specifying their rating to the nearest standard values. C3 220 VIEO H0…

A: Given, Erpeak=0.75V  Average Diode current rating= 1A,2A,3A,4A,5A  Peak diode current rating…

Q: Calculate the value of po. no and Na for GaAs sample at T= 350 K when =3p.- Assume Na =0. no

A: The conductivity of semiconductor is lies in between conductor and insulator. The conduction in…

Q: Problem 2 In a P-type semiconductor, the Fermi level is 0.3 eV above the valance band at a room…

A:

Q: For the circuit shown, the Zener diode (with a breakdown voltage of 10 V) is in which region of…

A:

Q: Exercise#5: Determine whether the ideal diode of Figure Q5 is conducting [3 V; =12V , V, =11v, R, =…

A: given circuit

Q: (b) Determine the peak voltage of the Vs.TM (a) Determine the average voltage of Vo. 5 URM supply…

A: In this question,   We need to determine the average output voltage of the full wave rectifier and…

Q: For a silicon diode, calculate the current at room temperature if the forward voltage VF = 0.3 V and…

A: In this question,  For a silicon diode, Calculate the current at room temperature if the forward…

Q: c) In a N-type semiconductor bar the fermi level is 0.4 eV below the conduction band at the…

A: Given, The Fermi level of an n-type semiconductor at temperature 298K is below the conduction band,…

Q: A silicon bar is doped with Np = 5x104 cm³ donor atoms and NA = 1017cm-3 acceptor atoms. Calculate…

A:

Q: The Fermi energy is 0.30 eV below the conduction band energy Ec at T = 400K. The value of Nc for…

A: We know, Nc=4.82×1015 mnm32  T32 /cm3Nc∝T32 Nc 300KNc 400K=30040032Nc 400K=4332 ×2.8×1019 cm-3Nc…

Q: The reverse current of diodes of silicon is equal to (30nA) at (25°C), if you know that the…

A: The leakage current is given by           IS2=IS1 2(T2-T1)/10           T1=25°C           T2=75°C…

Q: Assume Silicon Diode. Evaluate the forward resistance of a PN junction diode, when the forward…

A:

Q: From the given semiconductor diodes which will act as a source of microwave

A:

Q: Q2/Calculate the thermal equilibrium electron and hole concentration in silicon at T=300 K for the…

A: According to question: ∵Ec-Ef=0.22eV&Eg=Ec-Ev=1.12eV⇒Ec-Ev-Ec-Ef=1.12-0.22⇒Ef-Ev=0.9eV Therefore…

Q: 2. A silicon specimen is doped with 4.73 x1010/cm³ Antimony and 3.57x1010/cm³ Aluminum. a) Calculate…

A: We need to find out electron and hole concentration of given semiconductor .

Q: how much is the nominal current with which a LED diode with semiconductor material (wavelength) LED…

A: (LED)light emitting diode is an electric component which emits light if the electric current flows…

Q: ii. Acceptor type impurities will be added to this doped semiconductor material. For the following…

A: σo=nqMn+pqMpGiven,Mn=Mpni=n=1012atmos/cm3ND=p=1013×5atmos/cm3…

Q: The voltage drop across a forward biased Germanium PN junction diode is 0.7 volts. Select one: O…

A: Dear student as per guideline we are allowed to solve only one question at a time so I'm solving…

Q: 4 "A diode of 600V voltage rating" means А. The peak reverse voltage is 600V. The maximum average…

A: 4)  Voltage rating of diode is PIV ( peak inverse voltage ) across diode . It is a maximum reverse…

Q: Figure shows the parabolic E versus k relationship in the conduction band for an electron in two…

A:

Q: An AC voltage peak value of 20 Volts is connected in series with a silicon diode and load resistance…

A: here 20 v source is connected to positive terminal of the battery to make the diode to operate in…

Q: 2. A silicon diode has a saturation current of 5nA at 27'C. Estimate the Is at 100'C? ANS. 784.03 nA…

A:

Q: |Q2:- Determine the values of no and po for silicon at T = 400 K, if the Fermi energy is 0.22eV…

A:

Q: Draw the output waveform of the following Clipper’s circuits while the input is givenb below and…

A: The first circuit is  1. Negative shunt clipper with positive 5 V When the input voltage becomes…

Q: Problem 1. We have identical crystalline silicon solar cells available, with a short circuit…

A: Given data, Number of cell n = 54. Short circuit current Isc=4 A Open circuit voltage Voc=0.6 V

Q: o silicon diodes is 220 V rms, er circuit diagram when it is cor e average value of the voltage a

A: A center taped transformer is used in a full-wave rectifier circuit. It is very costly as compared…

Q: Question #3.2 Consider a compensated n-type silicon at 300K having a conductivityo=16 /NCm and…

A:

Q: Calculate the electron and hole concentration under steady-state illumination in an n-type silicon…

A:

Q: Estimate the ratio of the electron densities in the conduction bands of gallium arsenide (Eg 1.42…

A: The electron density in the conduction band is, ne=4.83×1021T32e-Eg3KT  (e/m3) The given data's are,…

Q: Which one of the following descriptions is true? Increasing the n-type dopant concentration will…

A: The objective is to determine the correct option.

Q: Consider a silicon pn junction solar cell at 300 K with a reverse saturation current of 1x10-7…

A: Solar cell convert light energy  in to electricity. Solar cell junction diode is  different from p-n…

Q: In a P-type semiconductor, the Fermi level is 0.3 ev above the valance band at a room temperature of…

A: Fermi level in P-Type semiconductor lies near to valence band. Fermi level EF in P-Type…

Q: Assume 0.6 V for all diodes if forward bais, reverse breakdown voltages are given, sketch IV curves…

A: Given,For all the diodes,If the diode is forward baised,The voltage is, V=0.6V

Q: Calculate the current flowing through the given circuit and the voltage value at the V0 ends.…

A: In this question , we will find current and output voltage in circuit..

Q: A practical silicon-based solar cell is constructed from a n+ p junction. a. Explain briefly the…

A: Here in this question they are interested in the calculation of PN junction solar cell.   Here the…

Q: For the circuit shown in the Figure, consider silicon diodes with forward drop voltage of 0.7 V. If…

A: Given :    The given transformer is of centre tapped transformer hence we have to take the secondary…

Q: At 300K, fermi level is found to be 0.2eV below the edge of conduction band for an n-type silicon…

A: First we will find out electron concentration in both cases then we will find out type and…

Q: Cite the difference(s) between a Zener diode and a Silicon diode.  Can a Zener diode replace a…

A: The Construction of zener diode and a silicon diode, both uses the silicon substrate. The Zener…

Q: 2- A silicon pn junction at T=300k is reverse-biased at Vr= 8 volt. The doping concentration are…

A: The data are given as T=300K,VR=8V,NA=5×1016cm-3ND=5×1015cm-3Ni=1.5×1010cm-3εsi=11.9 Now the…

Q: For the circuit shown, the Zener diode (with a breakdown voltage of vz : 10 V) is in which region of…

A: Find the region of zener diode for the given circuit ?

Q: 4 "A diode of 600V voltage rating" means А. The peak reverse voltage is 600V. В. The maximum average…

A: 4) correct option  is peak inverse voltage 600V. Usually the forward voltage drop across the diode…

Q: Calculate the efficiency of a silicon-based solar cell having short circuit current density of Jsc =…

A: Given data, Short circuit current density Jsc=42.2 mA/cm2 Open circuit voltage Voc=706 mV Fill…

Q: 1. Calculate position of Fermi level in n-type silicon with donor concentration of 3x1017 cm-³ at a…

A: Brief description : Generally semiconductors are divided as two types  1.Intrinsic semiconductors…

Q: SAS 3, ACTI VITY 3: ad For the Zener diode network shown in deter mine VL, UR, Iz, and Pz. VR | 1…

A: Note : Input voltage is not i am considering input voltage as 16 V and solving the question. -

Q: The applied electric field in p-type silicon is E=10V/cm. The semiconductor conductivity is…

A: given E= 10V/cm conductivity o= 1.5 ohm cm-1 area= 10-5 cm2 we have to find drift current

Types of Charge Carriers

A carrier is a type of object which carries a particular thing from one point to another point. For instance, people use different vehicles from one place to another, and the vehicle carries those people and acts as a carrier.