Consider a Pumped storage micro-hydel plant is to be built as a Peak load-plant on above mentioned Nathiya-Galli Water Fall with available head of 39 m and average discharge of 5640 m³/hour from the upper pound. The hydraulic efficiency and electrical efficiency of the plant to be 0.86 & 0.92 respectively. Analyze the following output from the above Pumped Storage Plant: a. Hydro-Power and Annual Hydro-energy available b. Electrical Power and annual electrical energy units that can be generated from the plant.

Consider a Pumped storage micro-hydel plant is to be built as a Peak load-plant on above mentioned Nathiya-Galli Water Fall with available head of 39 m and average discharge of 5640 m³/hour from the upper pound. The hydraulic efficiency and electrical efficiency of the plant to be 0.86 & 0.92 respectively. Analyze the following output from the above Pumped Storage Plant: a. Hydro-Power and Annual Hydro-energy available b. Electrical Power and annual electrical energy units that can be generated from the plant.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter12: Power System Controls

Section: Chapter Questions

Problem 12.18P

See similar textbooks

Similar questions

Consider two interconnected voltage sources connected by a line of impedance Z=jX, as shown in Figure 2.27. (a) Obtain expressions for P12 and Q12. (b) Determine the maximum power transfer and the condition for it to
In a power system, what are the key considerations for optimizing the economic dispatch of power generation units? Discuss the mathematical models involved.
Suppose a power system consists of two isolated regions: a western region and an eastern region. Five units have been committed to supply 3090 MW as shown below. The two systems are separated by a transmission line that can handle a maximum transfer of 550 MW in either direction. If losses are ignored, calculate the spinning reserve for the overall system and for each region. Comment on the adequacy of the spinning reserve of the overall system, and for each region. (consider the effect on the power supply in each of the regions if the various generators fail). Repeat the above calculations and analysis if an average of 8% of the output of the generators is lost in the transmission and distribution system before reaching the load.
Discuss the challenges and solutions related to power system stability and control, especially in the presence of renewable energy sources.
Discuss / Explain the operational process and show flow diagram including major equipment of a solar power plant, wind power plant, hydroelectric power plant, and biogas power plant..
A hydro-electric station has to operate with a mean head of 250 m and is supplied from a reservoir lake which drains a catchment area of 120 km2. the available rain off is 50% with annul rainfall of 100 cm .if plant capacity factor for the station is 80%. Find the average power produced and capacity of power station should be designed. assume the efficiency of plant .7 0%
Suppose a power system consists of two isolated regions: a western region and an eastern region. Five units have been committed to supply 3090 MW as shown below. The two systems are separated by a transmission line that can handle a maximum transfer of 550 MW in either direction. Calculate the spinning reserve for the overall system and for eachregion.
Discuss the future trends and technologies in power systems, such as microgrids and energy storage systems.
Discuss the challenges and solutions related to integrating renewable energy sources, like wind and solar, into existing power systems.
Explain the concept of distributed energy resources (DERs) and their impact on the modern power grid.
-) The active and reactive power drawn by the mixer fed from a 230 Vrms, 50 Hz single phase AC network was measured as 600 W and 100 VAR, respectively. According to this information: a) Calculate the apparent power drawn from the network? b) Calculate the current drawn from the network? c) Calculate the cos(a).
(a) Give the condition for the loss of load in a power generation system in terms of outages in generation units (b) Give the assumption taken for the calculation of LOLP? [Write relevant Answers in 1 or 2 sentences in each part)