Compute for the surface tension of a force of 3.65 x 10⁷ dyne acting on 7 m². (all answers in MKS unit) What is the force exerted? What is the surface tension? What is the radius of capillary tube? What is the diameter of capillary tube?

Compute for the surface tension of a force of 3.65 x 10⁷ dyne acting on 7 m². (all answers in MKS unit) What is the force exerted? What is the surface tension? What is the radius of capillary tube? What is the diameter of capillary tube?

College Physics

1st Edition

ISBN:9781938168000

Author:Paul Peter Urone, Roger Hinrichs

Publisher:Paul Peter Urone, Roger Hinrichs

Chapter11: Fluid Statics

Section: Chapter Questions

Problem 63PE: Suppose water is raised by capillary action to a height of 5.00 cm in a glass tube. (a) To what...

See similar textbooks

Related questions

Q: What is Bernoulli's equation when there is no flow (V1 = v2 = 0)? %3D O AP=0 O AP=VP9AY O AP= pgAy O…

A: The speed of the flow at the inlet and outlet are given by v1=0v2=0

Q: Set up an integral for fluid force against the vertical plate submerged in a fluid with weight…

Q: What is the ratio of heights to which ethyl alcohol andwater are raised by capillary action in the…

A: The expression for the height to which the ethyl alcohol is raised in the capillary tube is given…

Q: How much water will flow in 30.0s per capillary tube 200mm long and 1.50mm internal diameter, if the…

A: Poiseulle derived a formula for the volume of liquid flow, V=πpr48ηl…

Q: Use dimension analysis to determine the drag force, F, on a sphere moving through a fluid, in terms…

Q: The diameters of the large and small cylinders of a hydraulic press are 2.4 cm and 48.0 cm,…

A: As per Pascal’s law, the pressure on both the cylinder of the hydraulic press is the same, thus,…

Q: Calculate the fluid force on one side of a semicircular plate of radius 10 ft that rests vertically…

Q: A cylindrical tank is half-full of gasoline having weight density of 42 Ibs/ft3. If the axis is…

Q: Explain why the fluid reaches equal levels on either side of a manometer if both sides are open to…

A: The expression for the pressure, The pressure is inversely proportional to the area.

Q: Whole blood has a surface tension of 0.058 N/m and a density of 1050 kg/m3. To what height can whole…

A: Surface tension is,

Q: Compute the fractional change in volume of a glass slab, when subjected to a hydraulic pressure of…

Q: Derive the continuity equation from first principles using an infini- tesimal control volume of…

Q: A hose of radius 5.83 mm, is being used to fill an aquarium. If the Reynolds number is measured to…

Q: if a tube of 0.56 mm radius is introduced in water and it rises 18.9 mm by the capillary tube,…

Q: The height h that a fluid will rise in a capillary tube decreases as the diameter Dof the tube…

A: The variable and its dimension are given below, h L D L w ML-2T-2 σ MLT-2

Q: One liter of water flow out of the faucet in 10 s. If the inner diameter of the faucet (mouth) is 13…

A: Given data: Volume of water is, V=1 L=10-3 m3. Time interval is, t=10 s. Inner diameter of faucet…

Q: By considering the convex meniscus of mercury of density, ( in a capillary glass tube of radius, r…

Q: In a laminar flow flowing through a pipe of radius R, The fraction of the total fluid flowing…

A: in laminar flow, fluid flows such that velocity of particle passing through a given point remains…

Q: In one of the main human arteries the maximum value of the Reynolds number is 6,7. The diameter of…

A: Given:- The maximum value of the Reynolds number is 6.7 The diameter of the vessel lumen is 8,1 mm…

Q: The height h that a fluid will rise in a capillary tube decreases as the diameter D of the tube…

A: Given, Specific weight= w Surface tension=σ

Q: Find the magnitude and line f action Of the forces exerted on the tank is filles half full with el…

Q: Thank you for your help and illustration Derive the formula, P = hpg , for variation of pressure…

A: Derive the formula, P = hpg , for variation of pressure with depth of a fluid

Q: "An example of Pascal's principle is the hydraulic lever, the input p and output Po forces could be…

Q: Why density of the fluid affect the capillary height?

A: Height of fluid level in the capillary is calculated by using the formula given below, h=2Tcosθrρg…

Q: All are apparatus used in the determination of surface tension of a liquid by the capillary rise…

A: beaker is not used to measure the surface tension

Q: Could capillary action be used to move fluids in a “weightless” environment, such as in an orbiting…

A: Given: Weightlessness

Q: Water is flowing in a pipe if varying cross-sectional area, and at all points the water completely…

Q: What would be the effect of an increase in the value of the inner radius of the capillary tube to…

A: We want to see the effect of an increase in the value of the inner radius of the capillary tube to…

Q: Derive a relation for the capillary rise of a liquid between two large parallel plates a distance t…

Q: What is the height difference reading on the U-Tube? * 1. Consider a low speed subronic wind tunnel…

Q: When a cube-shaped object with a mass of 235 kg is supported fully underwater by a lifting cable,…

Q: What is the physical significance of the Reynolds number? How is it defined for (a) flow in a…

A: Reynolds number is a number used under the context of fluid mechanics which describes the types of…

Q: When physicians diagnose arterial blockages, they quote the reduction in flow rate. If the flow rate…

A: Write the expression for the flow rate. Here, Δp is the pressure difference, r is the radius, and l…

Q: A capillary tube delivers water by viscous flow from a reservoir and is 0.50 mm in diameter. The…

A: We will use Poiseuille's equation to solve this problem, according to which V=π∆pr4t8ηl V is the…

Q: Calculate the surface tension of water at 77°F if 0 = 38°, the capillary radius is 100 um, and the…

Q: One liter of water flow out of the faucet in 10 s. If the inner diameter of the faucet (mouth) is 13…

A: Given data The volume of the water flow out of the faucet is Vw = 1 Lt = 10-3 m3 The duration of the…

Q: Compute for the surface tension of a force of 3.65 x 10⁷ dyne acting on 7 m². Determine all in the…

A: In this question we have to compute for the surface tension of a force of 3.65 x 10⁷ dyne acting on…

Q: The method of capillary rise is based on the height to which the liquid in the capillary will rise…

A: It is force due to gravity F= mg m = mass g = gravitational constant

Q: Blood pressure is normally measured on the upper arm at the same height as the heart. Due to therapy…

A: density of blood (d) = 1060 kgm3height (h) = 30 cm = 0.3 m

Q: Calculate the rise of water inside a clean glass capillary tube of radius 0.1 mm , when immersed in…

Q: The closed cylindrical tank is filled with milk, for which density = 1030 %3D kg/m3. If the inner…

A: density, d =1030 kg/m3 length, L = 5 m diameter, d = 1.5 m acceleration, a = 0.8 m/s2

Q: A schematic of a homemade hydraulic jack is shown in the figure below, with cylindrical tube ends of…

A: In this question we have to find the force exerted on the car and the distance d2. Please give…

Q: In the experiment on the determination of the surface tension of liquids using the capillary rise…

A: The error in rising the liquid in capillary tube arises if there is any water bubble present in…

Q: How will you explain surface tension and capillary to an unschooled person?

A: To explain: Surface tension and capillary action.

Q: "An example of Pascal's principle is the hydraulic lever, the input p; and output Po forces could be…

Q: What will happen to the calculated buoyant force if the object had internal cavities? What will…

A: In this question we have to answer What will happen to the calculated buoyant force if the object…

Question

Compute for the surface tension of a force of 3.65 x 10⁷ dyne acting on 7 m². (all answers in MKS unit)

What is the force exerted?

What is the surface tension?

What is the radius of capillary tube?

What is the diameter of capillary tube?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1 GIVEN

VIEW

Step 2 CALCULATIONS

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

(a) Convert normal blood pressure readings of 120 over 80 mm Hg to newtons per meter squared using be relationship for pressure due to the weight of a fluid (p=hg) rater a conversion factor. (b) Explain why be blood pressure of an infant would likely be smaller than that of an adult. Specifically, consider the smaller height to which blood mast be pumped.
What is density of a woman floats in fresh water with 4.00% of her volume above the surface? (This could be measured by placing her in a Wii marks on the side to measure how much water she displaces when floating and when held under water.) (b) What percent of her volume is above surface when she floats in seawater?
Is there a limit to the height to which an entrainment device can raise a fluid? Explain your answer.
Calculate the contact angle for olive oil if capillary action raises it to a height of 7.07 cm in a glass tube with a radius of 0.100 mm. Is this value consistent with that for most organic liquids?
The flow of blood through a 2.00106 m -radius capillary is 3.80109cm3/s . (a) What is the speed of be blood now? (b) Assuming all the blood in the body passes through capillaries, how many of them must there be to carry a total flow of 90.0 cm3/s?
What is the ratio of heights to which ethyl alcohol and water are raised by capillary action in the same glass tube?
Construct Your Own Problem Consider a coronary artery constricted by arteriosclerosis. Construct a problem in which you calculate the amount by which the diameter of the artery is decreased, based on an assessment of the decrease in flow rate.
Figure 11.35(a) shows the effect of tube radius on the height to which capillary action can raise a fluid. (a) Calculate the height h for water in a glass tube with a radius of 0.900 cm—a rather large tube like the one on the left. (b) What is the radius of the glass tube on the right if it raises water to 4.00 cm?
The human circulation system has approximately 1109 capillary vessels. Each vessel has a diameter of about 8 m. Assuming cardiac output is 5 L/min, determine the average velocity of blood flow through each capillary vessel.
What effect does capillary action have on the reading of a manometer with uniform diameter? Explain your answer.
Suppose water is raised by capillary action to a height of 5.00 cm in a glass tube. (a) To what height will it be raised in a paraffin tube of the same radius? (b) In a silver tube of the same radius?
(a) Verify that a 19.0% decrease in laminar flow through a tube is caused by a 5.00% decrease in radius, assuming that all other factors remain constant. (b) What increase in flow is obtained from a 5.00% increase in radius, again assuming all other factors remain constant?