B A rectangular pontoon 10m long, 7m broad, and 2.5m deep weighs 686.7kN. It carries on its upper deck an empty boiler of 5m diameter weighting 588.6kN. The center of gravity of the boiler and the pontoon are at their respective center along a vertical line. Find the meta-center height. The weight density of seawater is 10.104kN/m³. Sea water 7m 5m 2.5 m-

B A rectangular pontoon 10m long, 7m broad, and 2.5m deep weighs 686.7kN. It carries on its upper deck an empty boiler of 5m diameter weighting 588.6kN. The center of gravity of the boiler and the pontoon are at their respective center along a vertical line. Find the meta-center height. The weight density of seawater is 10.104kN/m³. Sea water 7m 5m 2.5 m-

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

AcynuiICai laiik i lavilig a ulalTititi u1 ZII and height of 4m is open at one end and closed at the other end. It is placed below the water surface with its open end down. What is the value of h if the depth of water inside the tank is 1.8m? Assuming that atmospheric pressure is 101.5 kPa. 2.2 4m 1.8 2 m Do not write the unit. You will only input the numerical answer in the space provided. Unit of the Correct Answer: m Decimal Places required in the final answer: 3
Homework 14 |A cylindrical vessel closed at the top and bo om is 300mm inn diameter, 1m long and contains water up to a depth of 0.8m. The air above the water surface is at a pressure of 60 KPa. If the vessel is rotated at a speed of 250n rpm about its ver cal axis, nd the pressure head at the bo om of the vessel at the center point and at the edge.
& HYDRAULICS Total Hydrostatic Force on Surfaces Problem 3 - 104 Water in a tank is pressurized to 80 cmHg. Determine the total force per meter width on panel AB. Ans: 482 kN 2 m 80 cm Water 4m Hg 3 m Problem 3 - 105
Question A rectangular pontoon 10 m long, 8 m broad and 3 m deep weigh 980 kN . It carries, on its upper deck, a boiler 6 m in diameter weighing 588 kN. Longitudinal axis of the boiler is parallel to 10 m side. The centres of gravity of pontoon and boiler are at the centroid of respective figures and in the same vertical line. Find metacentric height. Take unit weight of water as 9.80 kN / m³ . Boiler 6 m Pantoon 3 m B 8m G₁ O Elevation
A closed cylindrical tank having a radius of 0.60m and a height of 4m is full of water under a pressure of 196.2 kPa. If the vessel is rotated at 200 rpm: (a) Compute the total pressure on the side wall and (b) compute the total pressure against the top. Imaginaryy=8.04 water surface Closed- h=2d 4m Pawh -1.2- -1.2- 2.
2] A pipe discharges 130 lps of water into a reservoir at a point 1.85 m belowthe water surface. At point A the diameter is 25.4 cm and the center of the pipe is 1.25m above the water surface. At the discharge end the pipe is 30.5 cm. If the head lossfrom A to the reservoir is 0.7 m, determine the pressure in A.
T1. Water is to be pumped from a reservoir at datum level 6.5m to a reservoir at datum level 24.8m at the rate of 55.6 l/s by a pump at datum level 9.2m. The suction pipe is 21m of 200mm diameter, and the delivery pipe is 186m of 100mm diameter, both with friction factor 0.015. What head must be generated by the pump. Answer 89.9m Delivery reservoir ha Z₂ hs Suction reservoir Datum Z₁ Pump
I- An open tank containi ng oil Cspar. = 0.80) is acceleratd verticaly at 8m/s". Determine the pressure 3m belar the surface if the notion is: a) upward with a positive acceleration. k) upward with negative acceleration. c) davnward with posi tive acceleration- di) dawnward with 'negative acceleration.
ADNAN MENDE AYDIN ADNAN MENDERES ÜNİVERSİTESİ UNIVERS TES IS3. ONLINE SINAV PORTALI 1. Obtain a pressure of 150 kN/m2 in terms of the height of a water column (hmwc), height of a and choose the true one below. densityw=1000 kg/m³ S.G.Hg= 13.6 S.G.oil= 81803030 O B) None of these answers O A) hmoc > hmwc > hmHgc 0.8 Kalan Süre 44:18 mercury column (hmHgc), height of an oil column (hmoc) O C) hmwc > hmoc > hmHgc 181800 8183303 O D) hmHgc > hmoc > hmwc. 181803030 1818034 O E) hmHgc > hmwc > hmoc 1803030 81803030 O Bu soruyu cevaplamadan geçmek için bu seçeneği işaretleyin 181803030 18180003 Sorunun Cevabı Kaydet ve Sonraki Soruya Geç 18 181803030 181503030 181803030 181803030 81803 18180303 18180030 181800030 81803030 18180303 181803030 18180 181803030 181800030 481803030 181803030 181803030 803030 18180s030 181803030 181803000 reos30 181803030 1818000 1803030 181803030 1818000 18 0 181800
4. Evaluate the pressure at the center of pipe A. Given: y of Liquid 1 = 12 kN/m y of Liquid 2 = 25 kN/m. hi = 60 cm h2 = 10 cm L = 60 cm а. -750 Рa c.-650 Pa b. -800 Pa d. -700 Pa Liquid 1 Liquid 2 h, h2
Both pistons are moving to the left, but A has a speed twice as great as that of piston B. Then the water level in the tanks is (a) rising (b) not moving up or down, or (c) falling?
The impeller of the centrifugal pump is 350 mm diameter, and the width of the blade passages at outlet is 18 mm. A pump, which runs at 16.6 rev/s, is mounted so that its centre is 2.4 m above the water level in the suction sump. It delivers water to a point 19 m above its centre; the friction loss in the suction pipe is 68 Q² meter and that in the delivery pipe is 650 Q² meter where Q in m3/s is the rate of flow. The blades themselves occupy 5% of the circumference and are backward facing at 35° to the tangent. At inlet, the flow is radial and the radial component of velocity remains unchanged through the impeller. Assuming that 50% of the velocity head of the water leaving the impeller is converted to pressure head in the volute, and that friction and shock losses in the pump, the velocity heads in the suction and delivery pipes are negligible, calculate the following: A) The flow rate, m3/s, of the pump. B) Manometric efficiency, in %, of the pump. 0.0284 55.2 0.0397 95.5 0.0778 66.2…