Assume you are constructing a machine to automatically count copper pennies as they travel down a chute, and you are going to use an inductive proximity sensor has a specified range of 6 mm. In order to detect copper which has a derating factor of 0.3, what is its range of this sensor you would need for this job? (b) Let's say you found a senor in stock that has a sensing range of 15 mm. If you use this to sense the copper pennies, what is the distance that you would need to mount it near the chute so that the pennies will pass within that distance between the face of the sensor.

Assume you are constructing a machine to automatically count copper pennies as they travel down a chute, and you are going to use an inductive proximity sensor has a specified range of 6 mm. In order to detect copper which has a derating factor of 0.3, what is its range of this sensor you would need for this job? (b) Let's say you found a senor in stock that has a sensing range of 15 mm. If you use this to sense the copper pennies, what is the distance that you would need to mount it near the chute so that the pennies will pass within that distance between the face of the sensor.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Q2/A- what are the main cases of insulator failures? B-what are type testing of insulator?
1. How does speaker convert electrical energy to sound energy? 2. How does microphone convert electrical energy to sound energy? 3. How does antenna convert RF energy electrical energy? 4. How does thermistor vary the resistance with respect to temperature change?
Summarize on how testing is carried out on isolators and circuit breakers of high voltage system. High voltage engineering
alculate the maximum force that should be applied via a pulling eye to a 70 mm2, 3-core copper cable,lf this is a low voltage cable with a PVC sheath, what is the maximum length of PVC pipe it can be pulled through?
diodes are on or off? explain why?
What are the different types of IC voltage regulators? Explain each one work's.
A certain cooper wire has a resistance of 25 ohms at 10°C. Take the temperature coefficient at 10°C to be 0.00409/°C. What must be the maximum operating temperature of the wire if its resistance is to increase by most 30%? CS Scanned with CamScanner
19. Identify the response time of a meter. a. Time taken by output to reach final constant value from Zero value b. Time taken by output to reach 95% of value from 10% c. Time taken to settle inside 2% of the final value d. None of the options
Fill in the blanks: Given the model for position control system, find the value for K1 and K2 so that the peak time is equal to 0.5 s and the %OS is equal to 3%. K1= 93.2070 K2= 0.129 I 446 23
1/ Identify the signal processor from the below following. a. Strain Gauge b. Piezoelectric Accelerometer c. Thermistor d. Wheatstone Bridge
What are the components of ical Electro mechanical Energy meters? and what are their functions?
An AC ammeter is connected in series with the primary winding of T1. What is the expected current reading? An AC ammeter is connected in series with the secondary winding of T1. What is the expected current reading? An AC ammeter is connected in series with R1. What is the expected current reading? NOTE: Idc for HW rectifier = 0.318 * Ipeak = 0.45 * Irms Describe/Explain briefly the purpose/use of the array (series-parallel) connection of the rectifier diodes in the given circuit.