Analyze which of the following is true about a default VLAN. Ports in default VLAN can be reassigned to other VLANs. To protect a network from unauthorized traffic, a default VLAN should be changed to an unused VLAN. A default VLAN can be used to carry user-generated traffic, such as email, web browsing, or database updates. A default VLAN supports VoIP traffic, which requires high bandwidths, priority over other traffic, flexible routing, and minimized latency.

Analyze which of the following is true about a default VLAN. Ports in default VLAN can be reassigned to other VLANs. To protect a network from unauthorized traffic, a default VLAN should be changed to an unused VLAN. A default VLAN can be used to carry user-generated traffic, such as email, web browsing, or database updates. A default VLAN supports VoIP traffic, which requires high bandwidths, priority over other traffic, flexible routing, and minimized latency.

Systems Architecture

7th Edition

ISBN:9781305080195

Author:Stephen D. Burd

Publisher:Stephen D. Burd

Chapter14: System Administration

Section: Chapter Questions

Problem 5VE

See similar textbooks

Similar questions

6- Divide the following networks into multiple area and assign a type for each router (IR, BR, ABR, ASBR, etc.) Wondershare EdrawMax Trial Version R3OSPF RLOSPF R2OSPF OSPE R4OSPF R6 OSPE OSPE RORIP RB BGP
Block Address: 192.168.16.0/24 Port to Point Link WANI Usable Hof Hosts: 2 Users LAN: Usable #of Hosts: 25 Network Address: LANI Usable #of Hosts: 100 Users Network Address: 7 Point to Point Link WAN2 Usable 4of Hosts: 2 Users LAN2: Usable #of Hosts: 50 Network Address: The network given in the above figure consists of three local area networks and two wide area networks are connected with two serial links. With an ID range 192.168.15.0/24, design an IP plan for this network. Find the network address and broadcast address, and subnet mask for each network.
Sliding Window Algorithms This question considers a sliding window implementation across a full-duplex point-to-point link. The link has a bandwidth of 327 kbps in each direction and a one-way propagation delay of 100 milliseconds. All packets sent across the link are 1,024 bytes long, including all headers and trailers. What send window size (SWS) is necessary to fully utilize the network?
) For the Internerwork shown in Figure Q4 below, Show the base configuration (do not include IP Routing) of RouterA assuming it is a DCE device connected to an El camer Take the IP addresses of the senal interfaces for RoutetA and RouterB to be 192.168.10 21/30 and 192 168.10.22/30 respectively. RouterA RouterB EO 192.168.10.65/26 EO 192.168.10 33/28
Two hundred workstations and four servers are linked through a single LAN connection and are all connected to one another via a network of switches. You seem to be getting an excessive number of broadcast packets across your LAN, and you would want to lessen the load that this kind of traffic places on your network. How can you be sure that the path you're on will lead you to success?
sWin an international IT solutions company, is launching 11 new branches in a new country where they currently have no existing branches. The sWin CIO has asked that each subnet should host at least 2000 devices. sWin has obtained a network address of 10.11.0.0/17.This address needs to be subnetted further and the CIO has decided that the internal subnet mask will be /21 The company’s subnet plan allows for: Router Pool: 2 router interfaces for each subnet – the last 2 IP addresses from each subnet. Managed Network Device Pool: The first 64 IP addresses are reserved for switches and other network devices Server Pool: The first 64 IP addresses following the Managed Network Device Pool are reserved for servers. Workstation Static Pool: The first 16 IP addresses following the Server Pool are reserved for Workstations that require static IP addresses. Workstation DHCP Pool: The remaining IP addresses are reserved for automatic IP configuration. You have been asked to use subnet 10 for…
Configuring Inter-VLAN Routing. Legacy inter-VLAN routing (or per-interface inter- VLAN routing) requires multiple physical interfaces between the router and the switch. The switch interfaces are set to access mode and assigned one VLAN. The router needs nothing special to route the VLAN traffic other than addressing for the VLAN's subnet. Because this is legacy inter-VLAN routing, we will not review it any further. You just need to be aware of what it is and how it is configured. An alternative in larger networks is to use VLAN trunking and subinterfaces. VLAN trunking allows a single physical router interface to route traffic for multiple VLANS. This technique is termed router on a stick and uses virtual subinterfaces on the router to overcome the hardware limitations based on physical router interfaces. a. List the commands including command syntax and prompt to configure a router for router-on-a-stick inter-VLAN routing. b. List the commands including syntax and prompt to configure…
CSMA/CA(carrier sense multiple access/collision avoidance) is the mechanism for random access control for wireless LAN (IEE 802.11) instead of CSMA/CD(carrier sense multiple access/collision detect) , give 3 reasons why CSMA/CD is not used by IEE 802.11
An application message is segmented into 10 packets, each of which is 1500-byte in size. Caculate the end- to end delay for the message when the bit rate for any node is 1.5 Mbps, the optical path total distance is 200-km, and the queuing and processing delays are 2-ms and 1-ms, respectively. There are 3 intermediate routers in the path, each of which uses the store-and-forward approach.
Q3: A 100 Mbps link between video server and a client is established. If receiving video frames of size 13.5 Megabyte has a latency of 1.1 seconds. Find the following: (assume that the speed of light is 2.8*10³ and no queuing delay) a) The distance between the client and server b) The latency of delivering the video frames if the connection is upgraded to 1Gbps link
Refer to the network figure above, showing two Ethernet Subnets connected through an IP Router, answer the following question 1-5. The devices in each subnet are connected locally to each other through layer two intermediate devices such as Ethernet switch and ethernet hub. For each device in the subnets, both its Internet Protocol (IP )address and its MAC address (also called the Physical address or the Ethernet address are shown. The subnet mask used by all devices is 255.255.255.240 (which is the same as the prefix length “/28”). 1. If Client #1 wants to send a broadcast packet to all the devices on the left subnet (containing client #1, client #2, client #3) what destination IP address should be used? (Mention in both binary and decimal format.) 2. What is the first and last assignable IP address for the left subnet above (containing client #1 and #3)? (Mention in both binary and decimal format.)
Find correct answers referes to data and networking communication: 1. In ethernet frame, sending adapter encapsulates IP datagram (or other network layer protocol packet) and it uses preamble whick consists of :a. 4 bytes with pattern 10101010 followed by one byte with pattern 10101011.b. 7 bytes with pattern 1010111 followed by one byte with pattern 10101011.c. 2 bytes with pattern 10101010 followed by one byte with pattern 10101011.d. 7 bytes with pattern 10101011 followed by one byte wit pattern 10101010.e. 6 bytes with pattern 10101010 followed by one byte with pattern 10101011.f. 7 bytes with pattern 10101011 followed one byte with pattern 10101010.g. 7 bytes with pattern 10101010 followed by one byte with pattern 10101011. 2. The method of communication in which transaction takes place in both directions but only in one direction at a time is called?a. three answers are correctb. two answers are correctc. Multi-duplexd. Full-duplexe. four wire circuitf. simplexg. half-duplexh.…

SEE MORE QUESTIONS

Recommended textbooks for you

Systems Architecture

Computer Science

ISBN:

9781305080195

Author:

Stephen D. Burd

Publisher:

Cengage Learning

Systems Architecture

Computer Science

ISBN:

9781305080195

Author:

Stephen D. Burd

Publisher:

Cengage Learning

SEE MORE TEXTBOOKS

GET THE APP

About FAQ Academic Integrity Sitemap Document Sitemap

Contact Bartleby Contact Research (Essays)High School Textbooks Literature Guides Concept Explainers by Subject Essay Help Mobile App

GET THE APP

Privacy

Your CA Privacy Rights

Your NV Privacy Rights

About Ads

Manage My Data

bartleby, a Learneo, Inc. business

	Ports in default VLAN can be reassigned to other VLANs.
	To protect a network from unauthorized traffic, a default VLAN should be changed to an unused VLAN.
	A default VLAN can be used to carry user-generated traffic, such as email, web browsing, or database updates.
	A default VLAN supports VoIP traffic, which requires high bandwidths, priority over other traffic, flexible routing, and minimized latency.