An inductive load of 100 Ohm and 200mH connected in series to thyristor supplied by 200V dc source. The latching current of a thyristor is 45ma.and the duration of the firing pulse is 50us where the input supply voltage is 200V. Will the thyristor get fired?

Q: A 10 MVA three phase load is to be served by a three phase transformer at a line voltage of 13.8 kV.…

A: Transformer is the static device it is used to transfer the electrical power from one terminal to…

Q: 17. Find f(t) of the following F(s): = 25s² + 395s + 1494 s² + 15s + 54

A: given here F(s) and asked to find the inverse laplace transform of F(s).

Q: b) In the circuit shown, find the value of K and put dots on the coupling coil when the circuit at…

A: In this question,  We need to determine the value of coupling factor K and Put the DOT polarity on…

Q: Find v and ic for t> 0 if i (0) = 1A and v(0) = 8V. 4H 20 250 mF ic + > i 802

A:

Q: 2. Power calculation In the following circuit element, it is known that Vab-10V, lab=-5A. Does the…

A: Given:

Q: The reading of the following voltmeter is

A: Since internal resistance of the voltmeter is very high. So no current will flow in the given…

Q: In radiation triggering when the intensity of light Obecomes more than Obecomes less than Obecomes…

A: This question is based upon the triggering methodology of Thyristors , the are various methods to…

Q: 3. Draw the output voltage waveform for each circuit in Figure 2 and include the voltage values. +5…

A: given both figure sinosidal input with diode circuit its output wave form is given as

Q: 15. Which of the following is TRUE?  a.   A conductor has a large amount of energy gap between…

A: Given a. A conductor has a large amount of energy gap between conduction band and valance band  b.…

Q: I need the solution for Part B please. 1.07 KiloOhms is incorrect and 0 KiloOhms is also incorrect.

A: Given: Consider the circuit shown in the figure: A Q-point value for IC between a minimum of 4 mA…

Q: what is it means if the results of XRD for ZnO thin films, cannot detect the (002) plane?

A: The ZnO thin films, alike doped and undoped Cu, are poly crystalline with hexagonal wurtzite…

Q: 1. Find and sketch the Fourier series corresponding to the square wave in the Figure shown.…

A:

Q: Q1a) Application of nodal analysis - No simplification needed 21x 20M lo a) Write controlling…

A: Nodal Analysis The following steps are to be followed while solving any electrical circuit using…

Q: The open circuit characteristics of dc machines is the relation between. O Torque and speed at…

A: Given data, Asking Open circuit characteristics of dc machine.

Q: The circuit pometers Rand Lore 250.50 625.50 1250, 50000 4) 25.5000 e) 1000 50 ) 40.50000 g) 626,…

A: In parallel resonance circuit, the imaginary part of conductance becomes zero. The circuit draws the…

Q: 28. Find the magnitude of a curl of the vector at point (1,1, −0.2); F = 30 ax + 2xy ay + 5xz² a₂ a.…

A: 28.  Find the magnitude of curl of the vector at point (1,1,-0.2) ; F=30 ax+2xy ay+5xz2 az Options…

Q: Qy find the frequency thalasis for the Signal sown A 2

A:

Q: 43. Poisson's equation is equals to: a. V.VV = Pv b. V.VV=_Pv C. V.VV = 0 d. V.VV=- £ Pu 44. Which…

A: Q.43) ans:(b) Poisson's Equation  states that the Laplacian of the electric potential is equal to…

Q: Series motor can be used in cranes upward and downward motions. O True O False

A: In this question we will write about dc series motor...

Q: In the following True or False and Multiple Choice problems, circle the correct answer. 1. One of…

A: As per our guidelines we are supposed to be the first three questions only. Kindly repost the other…

Q: 10. Draw the phasor diagram  of the 2 succeeding currents if it is out of phase by 90o

A: In the above given question we need to draw the phasor diagram for the given current sources with…

Q: b) The magnitude plot of a transfer function G(s)=- shown in Figure Q4b. Determine K, a and b from…

A:

Q: A single phase 220/6 Volt, 50 Hz transformer has a rated primary current = 0.5 A. its maximum…

A: From the question, it is given that Voltage=220 VFrequency=50 HzIPrimary=0.5 AEfficiency…

Q: An inductive load of 100 Ohm and 200mH connected in series to thyristor supplied by 200V dc source.…

A: Given information is that an inductive load is connected in series to thyristor. The supply voltage…

Q: Q1d) Find , and 4, in the circuit given. Use KCL and ohms law only to solve 0.54 3A

A: Kirchhoff’s Current Law- KCL, states that “The algebraic sum of all currents entering and exiting a…

Q: Determine the transfer function Io(s)/IT(S)

A: Given: Required: Transfer function I0sITs

Q: 9. The generator power is always the maximum load power. c. equal b. less than d. greater than or…

A:

Q: Correct any five of the following sentences using suitable scientific phrases. 1. At star connection…

A:

Q: The amount of charge represented by four million protons

A: Given:Number of protons=4×106To find:The amount of charge represented by 4 million protons

Q: Q4) Answer question related to circuit giver Given vs(t) = 15 cos(100t) V a) Write vs(t) in phasor…

A: Three sub part of question 4 is solve as given below

Q: The sync be regula speed.

A:

Q: 17. According to the Len's Law, the direction of the magnetic field induced by a current always have…

A: Given that

Q: A series circuit consists of a 20-ohm resistance, a 150 mH inductance and an unknown capacitance.…

A: A series circuit consists of a 20-ohm resistance, a 150 mH inductance and an unknown capacitance.…

Q: What we covered in Chapter 10 are called bilateral z-transform X(z). There 00 is also a thing called…

A:

Q: 1) If the sum of the 2-bit "AB" numbers and the 2-bit "CD" numbers is not odd, the logic circuit…

A:

Q: * What is the frequency and energy for a visible light that has a .wavelength of 5 x10-7 m

A: In this question we will find frequency and energy with given wavelength .....

Q: Find lb in the circuit shown below if Vg = 25/15° V and la = 5/15⁰ A.

A: Given data, The value of the current Ia  is5∠15° A,

Q: (a). Determine V₁, IL, Iz and IR for the network given if R₂ = 1800. (b). Repeat part (a) if R₁ =…

A: In this question,  We need to determine the voltage across the load resistance RL  ,  current in the…

Q: A single phase 220/6 Volt, 50 Hz transformer has a rated primary current = 0.5 A. its maximum…

A: It is given that: V=220 Vf=50HzI=0.5Aηmax=94%cosϕmax=1cosϕ=0.65 lagging

Q: 04: For the admittance locus diagram shown beside: 1. Draw the electric circuit. 2. Find the value…

A:

Q: Figure 3 illustrates the schematic diagram of the driver circuit. Note the output voltage E(s) of…

A: We need to find out the transfer function

Q: What are the characteristics of an ideal operational amplifier?

A: In this case, the characteristics of an ideal operation amplifier needs to be discussed.

Q: Q4: Answer the following, choose A or B A. For the following circuit, Determine the value of the…

A:

Q: 47. Flux linkage is equal to:  a.   Product of number of turns and magnetic flux  b.   Number of…

A:

Q: a-) In the circuit below, the silicon diode needs 1mA as the lowest value of the current in order to…

A: For the above given series connection of voltage source , resistor and diode we need to calculate…

Q: 15. Which of the following is TRUE? a. A conductor has a large amount of energy gap between…

A:

Q: A single phase 220/6 Volt, 50 Hz transformer has a rated primary current = 0.5 A. its maximum…

A: In this question we need to find a efficiency of the given transformer

Q: 10. At star connection unbalanced load system the neutral current is. c. less than zero b. greater…

A: For a balanced load system, the neutral current is zero. As the load system is unbalanced, the…

Q: Q2: For the circuit shown in Figure beside, if i 5+20sin(1000t)-10cos(3000t) A.. Find the total…

A:

Q: 47. Flux linkage is equal to: a. Product of number of turns and magnetic flux b. Number of turns…

A: