An equipment has a per unit impedance of 0.8 on a base of 50 MVA, 66KV. The actual value of impedance will be O 49.49 Q O 59.59 Q O 69.69 Q O 79.79 O

Q: Q6. Determine whether the following Boolean equation is true or false. x'y' + x'z + x'z' = x'z' + y'...

A: In this answer we will verify whether the given Boolean equation is TRUE / FALSE as explained below ...

Q: 2. a. Write the equivalent ASCII code of the following characters (include the space): @2 5Ba#/?8 7 ...

A:

Q: Be a filter with transfer function: H(@) = ja)² + 5jw +6 Find the unit step response

A: Given: Transfer function, Hω=1jω2+5jω+6 Input is unit step.  

Q: the voltage Vth between a and b is: * 200 300 100 a* R2 100 V2 -20V

A: In this question,  Find the voltage Vth i.e voltage across a and b.  We are solving this question us...

Q: I kS2 1 ΚΩ 2 kΩ + 10 μ' 2 ΚΩ 1kΩ

A:

Q: 2.) Answer the following with "TRUE" or "FALSE" then explain why.  ___________a.) In a zener diode,...

A: Diode: This is a semiconductor device that is on in the forward biased condition. Generally, silicon...

Q: 4. When a plane wave of monochromatic visible light falls normally on a plate with a circular hole (...

A:

Q: 1. Determine whether each silicon diode below figures is forward-biased or reverse- biased. 2. Deter...

A: Brief description : Diode is a unidirectional device which will allow current to pass only in one di...

Q: Given the potential V = 10 sin 0 cos o, Calculate the work done in moving a 10-µC charge from point ...

A:

Q: BJT AC ANALYSIS   A.SOLVE FOR IB,IE,ETH B.SOLVE FOR re AND Bre C.SOLVE FOR zi and zo D.SOLVE FO...

A: The required parameters of the CE amplifier can be obtained by using the DC analysis and AC analysis...

Q: If you plot V/i characteristic of a resistor, which parameter of this characteristic gives value of ...

A: Answer -

Q: The output of this circuit is always taken parallel to the load resistor.   a. Parallel clipper   b...

A: Positive clipper clips in the positive half of the cycle where as negative clipper clips in the nega...

Q: Q/Rth between a and b is: * 200 300 10Ω R2 V2 20V 100 b O 13.727 O 12.727 O 11.727

A: In this question,  Choose the correct options Find the Thevenin equivalent resistance?  We know if t...

Q: Q/ the voltage of node 3 is: * R1 R3 R6 V3 180 200 150 R8 140 R7 R5 R4 V1 =25V 130 O 0.523 O 0.544 O...

A:

Q: 6 A lamp filament is to have its resistance measured by the voltmeter/ammeter method. The test volta...

A: The test voltage V=120 vVoltmeter resistance Rv=1500 ΩAmmeter resistance RI=0.08 ΩIn long-shunt amme...

Q: 4=0.5 A Problem 12.20

A: Given network:

Q: 37. Determine the equivalent impedance of the following, assuming an operating frequency of 20 rad/s...

A: (37) The operating frequency is ω=20 rad/s. The impedance is calculated as: (a) 1kΩ is in series wit...

Q: Problem 3: A rod AB with length L = 0.115 m is lying on a rectangular conducting loop of A zero resi...

A: We are authorized to answer three subparts at a time since you have not mentioned which part you are...

Q: Q/the voltage Vth between a and b is: * 200 300 100 R2 100 V2 20V O 16.364 O 14.364 12.364

A:

Q: Find the value of Rf that will produce the closed loop gain of -244 R Ri VinoW 10 kN oVout

A: This question belongs to analog electronics . It is based on the concept of closed loop gain for a i...

Q: 6 A lamp filament is to have its resistance measured by the voltmeter/ammeter method. The test volta...

A: In this question,  Determine the percentage error?  If circuit is connected long shunt and short shu...

Q: Write a paragraph to introduce yourself and what are your favorite hobbies using the simple present ...

A:

Q: QUESTION 25 Find the value of Rf that will produce the closed loop gain of-236 R R VinoW o Vout 10 k

A:

Q: A four-pole DC generator has an armature winding containing a total of 648 conductors connected in t...

A: This question belongs to electrical machine . It is based on the concept of induced voltage in dc ge...

Q: 1.13 A load torque of (6000 Nm) is supplied by motor through gears of ratios (1:2:4:8:16). The speed...

A:        

Q: Given the potential V = 10 sin 0 cos o, Calculate the work done in moving a 10-uC charge from point ...

A:

Q: R2 Q1 R3 VCC R1

A: We need to find base resistance of given circuit

Q: current through the 15 kQ resistor,

A:

Q: Hiw:-Write the nodal equalionns X find the Voltage across the 28 resistor for net. shown? 3 く7 240v ...

A: The solution is given below

Q: 50 Electrical Technology ww 2 V Is Vs 24 V + 4Ω Fig. 1.104 Fig. 1.100 5. The value of resistance R' ...

A: Since you have asked multiple questions , we will solve first question for you . If you want any spe...

Q: Calculate the value of RB in ohms. at VE=4V, RE=315 ohm, IB=13uA, RC=2139ohm and VCE=11V

A: In this question, We need to Calculate the value of RB in ohms.   If VE=4V, RE=315 ohm, IB=13uA, RC=...

Q: Q5. a. Extend the following expressions into a sum of products. F1= ABC + A’ + AB'C FA 'Β'C'+A'B'C+A...

A: The given Boolean expression can be reduced by using Boolean algebra rules and the same can be imple...

Q: Find the Thévenin equivalent circuit for the circuit shown in Figure. 3 Ω a 3Ω 3 A Ua 6 Ω 20 a

A:

Q: 21 Date.. .. *....... Q. Find the Fourier Series od (x) = x 2. 2.

A: Given,

Q: Obtain the z parameters for the network in figure.

A:

Q: 1) Step inout 2) Ramp input 3) Probloia input What is the value of the error at the steady state. R(...

A:

Q: Find the value of Rf that will produce the closed loop gain of -244 Ri Vin oW 10 kN oVout

A: Given circuit: Here, A=-244Ri=10 kΩ  

Q: Q: 1-Design Measurement System Signal Processing circuit, having an input signal e (t), output signa...

A: We need to design the circuit for given expression

Q: The signals below, CK and D are the clock and D inputs to two different components: a D latch and a ...

A: Timing diagram is drawn in step -3

Q: H(A,B,C,D) = Π(0,5,7,10,14,15) + Σd(4,8,11,13) Derive the minimal SOP form of H using a K-map ...

A: The solution is given below

Q: Draw to scale a vector diagram showing the following voltages : v1 = 100 sin 500 t; v2 = 200 sin (50...

A:

Q: Obtain the y parameters for the T network shown in Figure. 18 2 12 2 ww

A:

Q: Design equation F(A,B,C,D) =[(1,2,5,9,10,11,13,15) using a 8x1 Mux? and 4x1 Mux?

A:

Q: 2 mF 0.2 H rell Zin 1/3 U 1/8 C 10 mF www

A: The given figure is shown below:  

Q: Consider the function g(t). g(t) = = 20 cos(69Tt +=) 5 Find the fundamental period of g(t).

A: Given data, gt=20cos69πt+π5  

Q: Q4) Find the current i(t) for the series RC circuit if the applied voltage is E(t) = = 3e-t given th...

A: We need to find current through RC circuit   

Q: Measure Output peak value, is itequal to the input peak value? Explain why their peaks are not of th...

A: The given Circuit is called a half wave rectifier Circuit and it is used to convert AC TO DC. For ha...

Q: Simplify the following expression to sum of products F = (A, B, C, D) = n(1, 3, 6, 9, 11, 12, 14)

A:

Q: What is the current gain for a common-base configuration where IE = 4.2mA and IC = 4.0 ?mA c) 16.80 ...

A:

Q: 2. Can a diode with a PIV rating of 50 V be used in the circuit of Figure 77? 50 V R 100 N -50 V

A: To convert the AC into DC or Pulsating DC, Rectifiers are used . Rectifier can be controlled as well...