An electronic device is cooled by passing water at 333 K through small tubular passages with 2.54 x10 m - The flow velocity is 0.2 m/s. Heat is generated in the device, resulting in approximately constant surface temperature to the water in the cooling passage. The water -outlet temperature is measured and found to be 345 K. If Re = 1058 Find Nusselt number Select one: a. 4.36 b. 4.66 c. 5.66 d. 3.66

An electronic device is cooled by passing water at 333 K through small tubular passages with 2.54 x10 m - The flow velocity is 0.2 m/s. Heat is generated in the device, resulting in approximately constant surface temperature to the water in the cooling passage. The water -outlet temperature is measured and found to be 345 K. If Re = 1058 Find Nusselt number Select one: a. 4.36 b. 4.66 c. 5.66 d. 3.66

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter21: Resistive-capacitive Series Circuits

Section: Chapter Questions

Problem 6RQ: A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating...

See similar textbooks

Similar questions

A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
An ac resistance is higher than a dc resistance. True False
QUESTION 5 A 20 ohms resistor is connected in series with a capacitor of 0.01 farad and an emf in volts given by 40e-3¹ +20e-6. Assuming that the charge and current on the capacitor are zero at t=0, determine the charge and current at any time.
We want to investigate how the field strength will be with air as dielectric and with steatite. A plate capacitor is placed in a 24 kV network between phase and ground. The relative permittivity of air is &=1 and for steatite &-6. The plate capacitor has area = 1m². The distance between the electrodes is 2 mm. Ep = 8.854-10-12 F/m A=1m² d=2mm a) Calculate the maximum field strength in the plate capacitor. (Answer: 9.8kV/mm) b) What is the capacitance of the capacitor if we use steatite? (Answer: C = 26.6nF)
A five-Ohm resistor is in series with a 0.001-Henry inductor and is supplied from a 10-V DC source. Solve for the current 2 milliseconds after the switch was turned on. a. 2.0000 Amperes b.1.9999 Amperes c.1.0001 Amperes d. 2.0001 Amperes
An inductor is constructed by winding a coil of 100 turns around a magnetic core. The core is a cylinder with radius 0.5 cm and the core material has relative permeability of 1000. The coil covers a length of 10 cm. Determine the resulting inductance. Enter your answer in mH rounded to two decimal places.
How temperature effect conductivity? Explain with the help of following equation. m e'n7'
Problem 1301 A-capacitor whose plates is 20 cm x 3.0 cm and is separated by a 1.0-mm air gap is connected across a 12-V battery. Determine the charge accumulated on each plate after a long time. A. 5.3 x 10-12 c B. 7.2 x 10-C C. 8.1x 10-11 c D. 6.4 x 10-10 C
ciocle with 24mA OF Current Flowing through has a vortage chop of 0.75V. Determine the reverse Saturation Current Is In A. Assume M = 1. Present Using ^ Cxy to answer in scientific notation your For the exponent. A H
8. Liquids with solid impurities a) Have higher dielectrie strength b) Of large size have higher dielectric strength c) Have lower dielectric strength as compared to pure liquids d) None of the above 9. Peak to peak ripple is defined as a) the difference between average de voltage and peak value b) the difference between maximum and minimum de voltage c) the difference between maximum ac and average dc voltages d) the difference between ac (rms) and average de voltages 10. In a Cockroft-Walton circuit, input voltage 100 kV load current 25 mA, supply frequency 100 Hz, each capacitor 10 nF. The optimum no. of stages for maximum output voltage is a) 1 b) 2 c) 10 d) 35
0.4 cm outer radius, R and 0.2 cm inner radius, r. ...
2.)What is the difference between Ampere's law and Biot-Savart's law?