An alternating voltage is given by: v=75 sin(200Trt-0.25) volts. Find the following: I. (a). The amplitude (b). The peak-to-peak value (c). The rms value (d). The periodic time (e). The frequency (f). The phase angle (in degrees and minutes) relative to 75 sin 200rt

An alternating voltage is given by: v=75 sin(200Trt-0.25) volts. Find the following: I. (a). The amplitude (b). The peak-to-peak value (c). The rms value (d). The periodic time (e). The frequency (f). The phase angle (in degrees and minutes) relative to 75 sin 200rt

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.1MCQ: The rms value of v(t)=Vmaxcos(t+) is given by a. Vmax b. Vmax/2 c. 2Vmax d. 2Vmax

See similar textbooks

Related questions

Q: derive the RMS formula for the following a.) b.)

A: The solution is given below

Q: 4. The waveform is shown in Figure below is a half-wave rectified sine wave. Find the rms value and…

Q: 6. A periodic voltage has the following voltages: 15 V at 0.02 sec, 9 V at another 0.05 sec and 0 V…

Q: 12. a Derive the equation for the RMS voltage in terms of peak voltage for a cosine wave. That is,…

Q: Upload answer sheets Find the following parameters of an ac voltage given by the equation…

A: Form Factor: It is the ratio of the RMS value to the average value. It is also known as root mean…

Q: An AC source operating at 60 Hz with a maximum voltage of 170 V is fed to a series combination of…

A: Find the value of capacitive reactance.

Q: Consider the sinusoidal voltage v(t) = 80 cos (1000mt - 30°) V. A. What is the maximum amplitude of…

A: Given data, Equation of voltage is given as, vt=80cos1000ωt-300

Q: A 29-Ω television and an 16-Ω amplifier are connected in series across a 158-V source of voltage…

A: Given: A 29 Ω television and a 16 Ω amplifier are connected in series across 158 V source and also…

Q: An engineer is required to analyse a sinusoidal waveform for the voltage and current using…

Q: Find the rms and average value of the wave form shown below. a. Vaverage b. Vrms

Q: b) A device with characteristics as shown is used to control an 110V AC supply. The load is…

A: The I-V characteristics of a device is given in the question. We need to identify the device. Also…

Q: A 10.8-2 resistor, a 11.8-uF capacitor, and a 16.4-mH inductor are connected in series with a 130-V…

A: current is maximum at resonant frequency. For series RLC resonant frequency=12πLC current at…

Q: Determine the following: (a) The components present in the circuit. (b) The rms value of the…

A: Note- Same frequency of voltage produces same frequency of current. Voltage leads current in…

Q: two devices are connected across a source where F= 60 Hz. If the 2 rms values of the voltage drops…

A: The solution is given below

Q: Derive the formula for the RMS value for the following

A: In this question, We need to derive the formula for the RMS value for the following.?

Q: 8. The power output, P, in Watts of an electric generator varies sinusoidally over the course of a…

A: We need to find out power expression and power graph .

Q: For the sinusoidal waveform shown in Figure, determine (a) Time period, (b) its frequency, (c) peak-…

Q: 2. For a sinusoidal voltage trace displayed by the CRO, the time/cm switch is on at 500µs/cm and…

A: Given Data: time/cm = 500 us/cm width of cycle = 4 cm peak to peak height = 5cm volt/cm = 5 V/cm

Q: Find the rms value of the full wave rectified sine wave in figure shown below. Calculate the average…

A: We need to find out RMS Value and power for given waveform .

Q: the RMS value of the current is? /2) the peak value of the voltage is?/3) the value of the reactive…

Q: The given data to be used for getting the RMS Values is 0, 5, 10, 30, 50, 70, 50, 30, 10, 5, 0, -5,…

A: In this answer we will find the RMS value using all the given values as explained below. The RMS…

Q: What is the rms value of the voltage V0 in the circuit given below

A: This network is combination of resistance, inductive and capacitive elements. Rms value of Vo.…

Q: Derive the formula for the RMS value for the following a)

A: RMS of AC is that value which when passes through a resistor of known value for a particular…

Q: Determine the rms value of the periodic waveform below. The y axis is expressed in Volts and x axis…

Q: (a) The peak amplitude. (b) The peak-to-peak value. (c) The average value. (d) The rms value. (e)…

A: as per question we need to answer a,b,c we need to find peak amplitude value, peak to peak value and…

Q: Find the RMS Voltage and Average Voltage based from the graph

A: It is given that:

Q: Find the rms value of the given waveform

A: Given waveform,

Q: Q.4. Find the rms value of lo and VAB =? in the circuit shown below.

Q: Derive the formula for the RMS value for the following

Q: 5. For the questions below, use the following AC circuit from EveryCircuit:| 4 V 2V OV -2 V 2 us -4…

A: In this question, We need to calculate the peak to peak voltage, Peak voltage rms voltage and time…

Q: Consider the sinusoidal voltage v(t)=100cos(1000nt-65°)V. A. What is the maximum amplitude…

Q: Find the average voltage value for the signal shown below for t=0 to10 (ms): V (V) 25

Q: Consider the sinusoidal voltage v(t) = 80 cos (1000nt -30°) V. A. What is the maximum amplitude of…

A: Given data, Voltage equation is given, vt=80cos1000πt-300 V Standard equation is given by,…

Q: Compile the correct results of the analyzer. i. The Amplitude value ii. The Frequency iii. The…

A: In the given question we need to compare with the standard alternating sine voltage waveform. From…

Q: Calculate the R value in ohms, since the 13kHz frequency sinusoidal sign is observed at the output…

A: C= 10nF Frequency, f= 13 kHz R=?

Q: Give the Formulas of Average Value and RMS Value of a waveform

A: There are some types of the waveform, Let the amplitude of each waveform be Vm.

Q: Find the RMS value of the voltage waveform. Find the average power if 8 N resisto connected across…

A: To solve above problem, one should know about different characteristics of waveform: Time Period:…

Q: Find the RMS value

A: The wave diagram shows the maximum value of the voltage as Vm.

Q: For the sinusoidal waveform in Fig. shown: (+).? + [vw] 20 10 15 30 7. SO 10 /20 40 [ms] -10 -20…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: Find the RMS value of a periodic voltage that has a value of 20 V for one half-period and -10 V for…

Q: The rms value of the voltage in a 60 cycle circuit is 115 volts. write the equation for the…

A: Given here the rms value of the voltage in a 60 cycle circuit is 115 volts. here 60 cycle circuit…

Q: A series of data is gathered discretely at equal intervals of time from an unknown voltage waveform…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: Derive the formula for the RMS value for the output waveform given below.

Q: b) Two circuits connected in series which voltage drop across at each circuit can be expressed in…

Q: The equation of alternating voltage is given by ν = 325.22 ???314?. Find (i) RMS value (ii)…

A: The solution is given below

Q: A complex voltage waveform which has an rms value of 240V contains 30% third harmonic and 10% fifth…

A: Given: Vrms=240V 3rd and 5th harmonic components are present in the voltage wave form. Frequency of…

Q: Find the rms value of the periodic waveform of the figure below over one full cycle. Av (V) 1 cycle…

A: Average Value of a signal: It's that steady state equivalent of a time varying signal which would…

Q: Determine the output wave-form for the network in the figure below then calculate the average and…

A: A diode is a nonlinear component. When the anode voltage is greater than the cathode voltage, then…

Concept explainers

Fourier Series

Most of the incidents studied in the field of Engineering and Science as a function of time. For example, current and voltage are in the alternating current circuit. These occasional activities can be analyzed in the activity components (fundamental frequency and harmonics) through a process called Fourier analysis.

Question

An alternating voltage is given by: v=75 sin(200TTt-0.25) volts. Find the following:
I.
(a).
The amplitude
(b).
The peak-to-peak value
(c).
The rms value
(d).
The periodic time
(e).
The frequency
(f).
The phase angle (in degrees and minutes) relative to 75 sin 200tt

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1 Introduction

VIEW

Step 2 Solution

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A certain waveform has a form factor of 2.3 and a peak factor of 3.5. If the maximum value is 100 find the rms value and average value...
In an experiment, the function generator is adjusted to generate a square voltage at a certain frequency. This voltage is displayed on an oscilloscope and the reading is 10 V peak-to-peak. The rms value of this voltage is .What will be the rms value of this voltage if the frequency is reduced to the half value? 3.536 Vrms . 3.536 Vrms O 5 Vrms . 1.7677 Vrms O 3.536 Vrms. 1.7677 Vrms O 5 Vrms . 5 Vrms ...... O 10 Vrms . 10 Vrms ......
Q2. For the Periodic Waveforms shown in the Figure, determine for each : Frequency, Average Value over half a cycle, RMS Value, Form Factor, and Peak Factor. 100 75 Voltage (V 50 25 20 40 Time (ms) 10 30 -100
A sinusoidal waveform is displayed on a C.R.O. screen, the time/cm switch is on 30 µs/cm and the volt/cm switch is on 20 V/cm. The width of one complete cycle is 3.8 cm and the peak to peak distance is 4.8 cm. Determine the following: The frequency is? The magnitude of the sine voltage is? The amplitude is? The R.M.S voltage is?
49. The sinusoidal waveform is the fundamental type of waveform used in AC and is commercially distributed. True False 51. Peak factor of a signal is the ratio of the peak or maximum value to the RMS (root-median-square) value. True False 52. Periodic signals are signals that recur at a irregular time interval True False
In an experiment, the function generator is adjusted to generate a square voltage at a certain frequency. This voltage is displayed on an oscilloscope and the reading is 16 V peak-to-peak. The rms value of this voltage is .What will be the rms value of this voltage if the frequency is doubled? Select one: O 16 Vrms 32 Vrms O 8 Vrms . 8 Vrms ..... O 5.657 Vrms 5.657 Vrms ....... O 8 Vrms . 16 Vrms O 16 Vrms 8 Vrms ......
Given the RMS value of the following voltage waveform is sqrt(8/3) , determine the maximum value, B, of the waveform.
A square wave having a postive maximum value of Em and a negative maximum -Em . Determine the Average Value , RMS Value , and Peak factor
How do I find the phase of this sinc function?
Given the figure below. Find: a. RMS value of the waveformb. Average value of the waveform
A voltage wave of 250 kHz has a Vmax-5 V and Vmin=-35 V. The duty cycle of this wave is 0.875. This voltage waveform has been applied across a 2.5 µH inductor for a very long time so that steady state has been achieved. Diagrams of the wave parameters and circuit are shown in this figure: L What is the average voltage of this wave? Average voltage = 35 V Voltage (arb, unit) 1.25 Minimum current: -3.5€ Amps 1 0.75 0.5 0.25 0 4.25 05 Have you integrated the wave over full cycle? 4.75 4 -1.25 Vmax 0.5 Vmin What is the average current flowing through the inductor? Average current = 3.56 A 15 Period/s On average, there is no power consumed by the inductor. Have you considered this? What are the maximum and minimum currents that flow through the inductor? Maximum current: 0.50 Amps D= 25 TH TH Have you used the relationship for current and voltage in an inductor? Have you considered the slope of the current wave?
Determine the rms value for each of the waveforms below.