Answered: An AC voltage an RMS value and average…

An AC voltage an RMS value and average value of 200 Volts and 150 Volts respectively. What is the form factor of AC Voltage? 1. 1.11 2. 0.75 3. 1.33 4. 1.414

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.1MCQ: The rms value of v(t)=Vmaxcos(t+) is given by a. Vmax b. Vmax/2 c. 2Vmax d. 2Vmax

See similar textbooks

Related questions

Q: If the surface-leakage current is 2 nA for a reverse voltage of 25 V, what is the surface leakage…

A: Given: Surface-leakage current, I=2 nA,Reverse voltage, V=25 V

Q: Explain with drawing Instruction set of PIC 16fxx Microcontroller List the Interrupt sources in…

A: We need to explain with the drawing instruction set of the PIC16fxx Microcontroller. We need to list…

Q: Find the transfer function (Vo/Vin) for the system shown in figure below. voo 2 H Vin Vo 10 Ω 5 F

Q: Solve the question in the simplest way Determine the y parameters for the two-port shown in Fig.…

A: We need to find out the Y parameters of given circuit

Q: Use rules of block diagram reduction to determine the closed loop transfer function:(see the…

A: By using Rule of block diagram reduction determine the closed loop transfer function: Options are:…

Q: Correct any five of the following sentences using suitable scientific phrases. 4. The total power…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: * The register is a type of combinational circuit O sequential circuit O latches O CPU O none of the…

Q: Q14/ 10 messages signals, each bandlimited to 5KHz are multiplexed using frequency division…

Q: Compared between three_ phase induction generator and synchronous them at impedance field and EMF…

Q: 1- Determine the values of x, and y (5x+j10)(2-jy) = 90-170 2- At steady state, what is the current…

Q: Find the rms value of the current waveform of Fig. 11.15. If the current flows through a 9-…

A: given here a waveform and asked to find the rms value and average power dissipated through the…

Q: In this parallel-plate capacitor, the distance d between the plates is 3cm, the radius of the plates…

A: Given, Distance between the plates, d=3 cm Radius of plates, r=2 cm Relative permittivity, εr=1…

Q: The progressive phase shift k=180, the direction of the main beam Bo for a uniform linear array with…

Q: Find the Thevenin equivalent circuit for the network below of variable resistance. Then find the…

Q: Construct 4-to-16 line decoder with 3-4-8 a line decoders with enable and external gates.

A: We need to design the 4 to 16 decoder by using of 2 to 4 decoders

Q: If the mid-band gain of an RC coupled amplifier is 150, the low-frequency voltage gain is 70 at an…

A: Given, Mid band gain of RC coupled amplifier, Av,M=150 Low frequency voltage gain Av,L=70 Input…

Q: 1-Efficiency 2- Ripple factor 3- PIV

A: The rectifier defined as the power electronic circuit which is used to convert ac power to dc power.…

Q: 7- Determine the power factor of 220V, 0.4A, 20W fluorescent lamp? and when it will be leading or…

Q: * If X= (1100101)excess-3 X=(65) decimal O X=(110000) gray O X=(101)octal

A: If X= (1100101)excess-3

Q: ind the inverse Z transform for the following by using Partial Fraction method: z (z² - z+2) H(z)…

Q: A GSM1800 cell tower antenna is transmitting 20W of power in the Frequency range of 1840 to 1845MHz.…

Q: eedback and control system How is the inverter type ACU open-loop systems calibrated identify the…

A: An open loop system is a type of control system in which the output of the system is determined by…

Q: Example: . Sketch the root locus for the following system G(s)H(s) = K (s+1) s(s+4) (s² +28+2)

Q: Show whether the process, xct) = A cosat + B sind t where A 4 B independent are norma ually…

Q: Q31 27, and draw the impedance diagram. I, VVV in the phaser domain, and draw the phaser diagram.…

A: Series combination of impedances: Z=Z1+Z2+Z3

Q: V₂ For the circuit shown calculate the power dissipated in 80-2 resistance Vs = 50 cos (lot +30) 101…

Q: For the network of Fig. 6.79, determine: (a) ID and VGS (b) VDs and Vs. 16 V 22K0 =fimA

Q: Which one of the following is the purpose ?of function in python

Q: i) Analyse and identify the types of the buses shown in the figure from the specification. 11/33 kV…

A: Given: Consider the following figure: To find: Analyze and identify the types of the buses shown in…

Q: BJT DC Biasing 1. Determine the range of possible values for V for the network using the 1MOhm…

A: We need to find out range of voltage for given circuit

Q: Define: 1)self-regulating 2)non-self-regulating

A: A self-regulating control is a system that compares a measured value of a process to a desired set…

Q: 4. For the circuit shown in the figure below find the following a. Write the name of the circuit....…

A: For the given circuit find the following parameters : Name of the circuit. Find the value of IB, IC…

Q: Exercise # 3 - MOSFET Bias The following circuit is used to bias an NMOS type MOSFET transistor. In…

A: For the above given MOSFET we need to calculate drain current, VGS and justification of the…

Q: olve the question in ne simplest way mine the y parameters for the two-port shown in Fig. 19.17.…

Q: Ex 1: a 50 Hz generator has e.m.f. to neutral 7.5 kV (r.m.s). the reactance of generator and the…

Q: Q6/ A. for the following network Find the voltages VI, V3, and Vab for the network of Fig (6) ? R₁…

Q: 15V $30 IA D + 552 1 Which of the following is the value of the power supplied by the voltage source…

A: Given, The circuit is,

Q: The AC system used instead of DC system power possible to: 1) Reduce the risk of electric shock. 2)…

A: The HVAC transmission is economical up to 400-500Km. If distance is more than that then HVDC is…

Q: FETs have similar properties to ___. a. Scotty diodes b. NPN transistors c. PNP transistors d.…

A: FET means Field Effect Transistor. A field-effect transistor (FET) is a type of transistor that uses…

Q: Input Terminal Input Terminal Output Terminal Output Terminal Output Terminal Output - Terminal…

Q: Q1: For the J-K flip-flop, determine the Q output for the inputs in figure below Assume that Q…

A: State table of JK flip flop J K Q 0 0 Q (Hold) 0 1 0 (reset) 1 0 1 (set) 1 1 ǭ (Toggle)

Q: The minimum number of flip- flops that can be used to construct a Mod-5 counter is

Q: Eş merkezli r1 ve r2 yarıçaplı iki iletken çember merkezleri orijin olacak şekilde…

A: We need to find out the value of charge for given electric field

Q: There are different states in a 4-bit Johnson counter 4 O 8 none of the mentioned O 1 O 3 O O O O

Q: Fig. 1 Fig. 2 2. An air cored coil of inductance L=3H is supplied by a DC voltage source, Fig.2, and…

A: Emf induced across the coil or inductor is E = L * dI/dt

Q: b) For the Circuit shown the switch has been in position for along time, at t-o the switch is moved…

A: This question belongs to circuit theory . It is based on the concept of transient and steady state…

Q: For an ordinary end fire uniform linear array, the progressive phase current K is 90 +/-Bd O 45 O…

A: The cut-off frequency for Transverse magnetic transmission mode and Transverse electric transmission…

Q: Q19/ Point charges of 4x10-5 C and 6 x10-6 Care located at points A(1,3,4) and B(4,0,4),…

Q: Using Thevenin's theorem, find vo in the circuit given in the figure.

A: The thevenin's equivalent circuit can be obtained by using nodal analysis of the given circuit.

Q: We need a three-stage space-division switch with N = 100. We use 10 crossbars at the first and…

Concept explainers

Digital Integrated Circuit Design

Digital IC design is a procedural interaction that involves converting determinations and highlights into computerized blocks, which are then further transformed into basic circuits. A significant number of the imperatives related with advanced IC plan come from the foundry cycle and innovative restrictions.

Question

An AC voltage an RMS value and average
value of 200 Volts and 150 Volts respectively.
What is the form factor of AC Voltage?
1. 1.11
2. 0.75
3. 1.33
4. 1.414

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

P-channel Metal-Oxide Semiconductor (PMOS), N-channel Metal-Oxide Semiconductor (NMOS), and Complementary Metal-Oxide Semiconductor (CMOS)

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Another name for the RMS value of current or voltage is ... O the effective value O the exact value O the true value O the reactance value
(a) What is the frequency in Hertz and rad/s of the voltage waveform shown on Figure Q1? (b) Calculate the average voltage and rms ac voltage of the waveform shown on Figure Q1. (c) Calculate the total rms voltage of the waveform shown on Figure Q1. (d) The voltage on Figure Q1 is connected across a 0.15 2 resistive load. Calculate the power dissipated in this resistor.
Draw the sinusoidal waveform of the AC voltage and current for the given loads below. Describe the characteristics of the waveform for each load. A. Pure resistor B. Pure inductor C. Pure capacitor
An ac voltage represents by a sinusoidal waveform as shown in Figure 6 below. a) Define: i. The period ii. The frequency b) Referring to Figure 6, given that the peak voltage Vp = 24 V. Determine: i. The period, T ii. The frequency, f. ii. The angular velocity, w. iv. The voltage, VRMS V. Write the mathematical expression for the sine wave in Figure 6 to represent the ac voltage.
(c)[ device needs to connect to a Diesel generator which generates sinusoidal AC power at 16.67 Hz. The amplitude or RMS value of the generator output voltage is adjustable. The area of cross-section of the core is 0.035 m². What constraints, if any, must be imposed on the The magnetic device of the figure is designed to operate with 240 V(rms) at 50HZ. For operation in a remote mining site, the use of this device, or the generator, if the device must be connected to the generator. You may assume that the peak B field in the core must be limited to 1.1 T to prevent magnetic saturation.
1-Choose the correct statement for pure resistor connected across single phase AC supply. a. Current and Voltage are in phase b. Current leads the supply voltage by 90° c. None of these d. Current lags the supply voltage by 90° 2-Identify the current through the inductor in a RL transient circuit connected across DC voltage, when the switch is kept open. a. 0 b. Infinity c. V/R d. 1
In U.S. residences, electrical power is generally utilized at a nominal voltage of 120 V rms. What problems would become pronounced if the power distribution system and household appliances had been designed for a lower voltage (say, 12 V rms)? For a higher voltage (say, 12 kV)?
State Ohm's Law and explainExplain the difference between AC and DC power. What is its significance.
Q2. For the circuit shown below, sketch the current waveforms iş and io and determine the Average and RMS for both currents. a = 50° TI 50 2 Vs = 300 sin 100zt ( cot T2 in cot
Find thr RMS value..
Solve for 20 V rms supply. Thank you.
Derive the formula for the RMS value for the following