Ammonia gas enters the reactor of a nitric acid plant mixed with 30% more dry air than is required for the complete conversion of the ammonia to nitric oxide and water vapor. If the gases enter the reactor at 75oC (167 oF), if conversion is 80%, if no side reaction occur, and if the reactor operates adiabatically, what is the temperature of the gases leaving the reactor? Assume ideal gases.

Q: Consider the data at the table below at 298K and 1atm. When 1 mole of propene was combusted, wherein…

A: Given data: Moles of propene = 1 mol Average bond enthalpy for various bonds are also given.

Q: 0.72 g of a fuel containing 80% carbon, when burnt in a bomb calorimeter, increased the temperature…

A:

Q: 3. The following reactions take place in a continuous reactor at steady state. C2H6C2H4 + H₂ C₂H6+…

A:

Q: Calculate the standard reaction entropy at 298K for the following balanced reaction equation: 2A + B…

A:

Q: A Super-heated Steam at 200°C and 2 atm with mass flow rate of 1000 kg/h is being cooled in a…

A: It is given that mass flow rate of superheated steam at 200oC and 2 atm pressure = 1000 Kg/h Also…

Q: One side of brick mentain at temperature of 40 degree Celsius other side of wall mentain at…

A: One side temperature of wall T1 = 40 oC Otherwise of wall temperature T2 = 60 Wall thickness x = 1 m…

Q: 2 containing 60% benzene and 40% toluene by mole is desired to be separated by flash distillation at…

A:

Q: Exercise 2N₂O5(soln) → 4NO₂(soln) + O₂(g) Time (s) 0 200 400 600 800 1000 1200 1400 1600 1800 2000…

A:

Q: 2. The higher heating value (HHV) of a fuel is its standard heat of combustion at 298.15 K (25°)…

A: a) The latent heat of condensation is the heat released when the water vapor condenses to liquid. In…

Q: A chemical engineering student was given an information that the vapor pressure of n-butane at…

A: Given data: Temperature = 170.33 0F Vapor pressure of n-butane = 3796.76 in H2O

Q: QUESTION 4 One mole of an ideal gas undergoes isothermal reversible compression to 20% of its…

A:

Q: The output response of a temp measuring system of Kiln in a cement plant is respresented by y ( t )…

A: Given information: Output response of a step input of magnitude 9 is y(t) =6-6e^-6t Find the…

Q: the gas phase reaction A+BC+D takes place in a batch reactot at 300C. The eq constant k at 300C is…

A: Write the reaction as follows: A + B→ C + D The equilibrium constant, K = 9.0 The initial moles of A…

Q: A tube 93 mm outer diameter is insulated with a layer of silica foam 38 mm thick of conductivity…

A:

Q: Answer the following questions upon providing a detailed explanation of your answer. Which is…

A:

Q: NO STIRRING STIRRING NO STIRRING STIRRING Time/s 0.0 60.0 120.0 180.0 240.0 300.0 240.0 300.0 120.0…

A: We plot the graph in excel ...   On y axis: Measured temperature using thermometer On x-axis:…

Q: 2. (30 points) An aqueous solution of Na2CO3 contains 12% carbonate and small amounts of soluble…

A:

Q: 3. A 6M sulfuric acid solution (H₂SO4 in water) is flowing into a tank at the rate of 100 L/min. The…

A: NOTE-“Since you have posted a question with multiple sub-parts, we will solve the first three…

Q: 4. A mass of 1.7 kg of saturated liquid water is completely vaporized at a constant pressure of…

A: Given mass of saturated liquid water = 1.7Kg The pressure of the system = 101.325kPa

Q: A chip that is of length L = 5.4 mm on a side and thickness t = 1.7 mm is encased in a ceramic…

A: A chip is exposed to the dielectric liquid and the temperature at the surface of the chip is cooled…

Q: It is proposed to pump 20,000 kg/h of toluene at 114°C and 1.1 atm abs pressure. From the reboiler…

A:

Q: The electrolytic manufacture of chlorine gas from a sodium chloride solution is carried out by the…

A: Given data: Volume of NaCl solution = 10 m3 Specific gravity of the solution = 1.07 % composition of…

Q: (b) decreases d) (a) decreases (b) increases 5. If 5.6 m³ of oil weighs 46800 N, its density in…

A: Given  Volume of oil = 5.6 m3 Weight of oil = 46800N

Q: With respect to Figure 1.1, consider the two parallel flat surfaces spaced 1 mm apart, with a…

A:

Q: Two large water tanks are connected by a 10-ft piece of 3-in pipe. The levels in the tanks are…

A: Given that tank specification 10 ft piece of 3 in pipe △P =30 lbfin2 d =3 in =0.0762 m

Q: 1000 k mol/h of fresh feed consisting of 2% propane and 98% propylene by volume is mixed with the…

A: Refer to the figure shown below based on the information given in the problem statement.

Q: 36. Four kilograms of steam in a piston/cylinder device at 400 kPa and 175°C undergoes a…

A:

Q: Typically, more frequent measurements are taken at the start of the pharmacokinetic process, where…

A:

Q: 3. Water is flowing at an average velocity of 7 ft/s in a 6-in pipe. What is the pressure drop per…

A:

Q: 4.36. A steady-flow water power plant has the following inlet and outlet conditions: Pressure, psig…

A: Given data for steady flow water plant are as follows:   Inlet Outlet Pressure, psig 0 0…

Q: Liquid mercury has a molar volume of 0.01465 dm3 mol-1 and solid mercury a molar volume of 0.01413…

A: Given data: Molar volume of liquid mercury = 0.01465 dm3/mol Molar volume of solids mercury =…

Q: Problem 1 An aqueous solution of methanol containing 20% by weight methanol is fed to a distillation…

A:

Q: polymetric ferric sulfate in the basin at the moment of overflow.

A:

Q: 1) Heat capacity of hydrogen is given in terms of polynomial functions of temperature: Cp…

A: Given heat capacity of hydrogen in terms of polynomial functions of temperature is…

Q: Consider a mixing tank with a volume of 750 L working at steady state. A Feed stream enters and…

A: given = Volume = 750 L concentration = 50 g/L amount of A in tank = (750 L)(50g/L) = 37500 g

Q: · Outlet Temperature and Effectiveness of an Exchanger. Hot oil at a flow rate of 3.00 kg/s (cp=…

A: Given that- Specific heat of hot oil, Cpoil=1.92 kJ/kg.K Mass flow rate of hot oil, moil=3.00 kg/s…

Q: Calculate the standard heat of the following methanol-synthesis reaction at 800°C: CO(g) + 2H₂(g) →…

A:

Q: a) Calculate the Reynolds Number A stream of milk entering at 293 K, with a density of 1035 kg/m³,…

A: Given, Density = 1035 kg/m3 Viscosity = 2.12 cp = 2.12×10^-3 Pa-s Speed = 0.185 m/s Radius = 0.03175…

Q: ank initially filled with fresh water has a mixture of salt and insoluble material at its bottom. If…

A:

Q: have an accumulation rate equal to zero. 10. Systems at 11. 12.25 ppmv of CO (g) at 25 °C and 1 atm…

A: (10) In general, the mass balance equation is written as- Accumulation= Input-Output +…

Q: Buckingham Pi. Experiments show that the coefficient of drag CD = F/(1/2 pAV^2) for smooth spheres…

A:

Q: thermometer having a time constant of 1 min is initially at 60 deg C. it is immersed in a bath…

A: Given  Time constant T = 1 min Initial temperature = 60 oC Bath temperature  = 100oC

Q: A continuous single-effect evaporator concentrates 9072 kg/h of a 1.0 wt% salt solution entering at…

A: Introduction:- The heat exchanger for boiling the solution and the specific features for separating…

Q: 1. Kittel, Ch4-2. Surface temperature of the Sun. The value of the total radiant energy flux density…

A: Given, Solar constant = 0.136 J/s.cm2 Distance of the earth from the sun = 1.5×10^13 cm Radius of…

Q: A gas mixture consisting of 80% ethane and 20% oxygen is burned in an engine with 200% excess air.…

A:

Q: 5-161 An ideal gas expands in an adiabatic turbine from 1200 K, 600 kPa to 700 K. Determine the…

A: Given  Cv = 0.83 KJ/kg R = 0.3 KJ/kg K CP  - Cv = R Cp = 1.13

Q: Example: The balloon that Charles used for his initial flight in 1783 was destroyed, but we can…

A: For the detailed solution, please see the attached files.

Q: Blue Water Gas is obtained by passing steam over red-hot carbon enriched coal (coke). The gas is…

A: Composition of blue water gas is given.

Q: 3. An evaporator is used to concentrate cane sugar solutions. A feed of 10000 kg/day of a solution…

A:

Q: 5.2. Hydrocarbon fuels can be produced from methanol by reactions such as the following, which…

A: we know that.... Components H°f(kJ/mol) CH3OH -238.42 kJ/mol C6H12 -123.4 kJ/mol H2O -285.8…